Sun Microsystems 150 - Manual
Sun Microsystems 150 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 3 – Contents
- Page 4 – Cleaning a CD or DVD
- Page 5 – Required Tools; Antistatic wrist strap
- Page 6 – Preparing to Replace Components; Powering Off the System
- Page 7 – Turn off the power to the monitor and any peripheral equipment.; Removing the System Cover; cover to the chassis (
- Page 8 – Attaching the Antistatic Wrist Strap; Attach the copper end of the wrist strap to the chassis (; Disconnect the AC power cord from the system.
- Page 9 – Removing a Primary Hard Drive; as described in “Preparing to Replace Components” on page 2.; Pull the hard drive tray ejection lever away from the chassis.; Move the cables out of the way.; Slide the hard drive tray out of the chassis.
- Page 10 – Lift the hard drive tray from the hard drive.
- Page 11 – Replacing a Primary Hard Drive; jumper is set to “CS,” “Enable Cable Select,” or “Cable Select.”; Note –
- Page 12 – Installing a Secondary Hard Drive; ). The secondary IDE cable assembly is used with the
- Page 13 – secondary; IDE cable connector is connected to riser board; and
- Page 14 – Connect the power cable to the secondary hard drive (; Connect the power cable to the primary hard drive.
- Page 15 – Remove the following from the back of the CD-ROM or DVD-ROM drive; CD-ROM or DVD-ROM drive IDE cable connector; ROM or DVD-ROM drive toward the chassis front and remove it.
- Page 16 – Before you replace the CD-ROM or DVD-ROM drive, verify that the; Power cable connector
- Page 17 – described in “Finishing Component Replacement” on page 13.; Finishing Component Replacement; Position the system cover onto the system chassis.; cover to the chassis.
- Page 18 – Powering On the System; The front panel power indicator LED is on.; The; Hard Drive Mirroring
- Page 19 – Required Software and Patches; Solstice; CD or DVD Handling and Use; Inserting a CD or DVD Into the Drive
- Page 20 – unlabeled; Handling and Storing CDs and DVDs
Sun Microsystems, Inc.
4150 Network Circle
Santa Clara, CA 95054 U.S.A.
650-960-1300
Send comments about this document to:
Sun Blade™ 150 CD-ROM,
DVD-ROM, and Hard Drive
Installation Guide
Part No. 816-5369-10
June 2002, Revision A
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
iii Contents Sun Blade 150 CD-ROM, DVD-ROM, and Hard Drive Installation 1 Required Tools 1 Preparing to Replace Components 2 Powering Off the System 2 Removing the System Cover 3 Attaching the Antistatic Wrist Strap 4 Removing a Primary Hard Drive 5 Replacing a Primary Hard Drive 7 Installing a Seco...
iv Sun Blade 150 CD-ROM, DVD-ROM, and Hard Drive Installation Guide • June 2002 Cleaning a CD or DVD 16 Handling and Storing CDs and DVDs 16
1 Sun Blade 150 CD-ROM,DVD-ROM, and Hard DriveInstallation This guide provides instructions for installing a CD-ROM, DVD-ROM, or hard drivein your Sun Blade 150™ system. Required Tools The following tools are required to service the Sun Blade 150 system: ■ No. 2 Phillips screwdriver (magnetized tip ...
