Summit Appliance CRH2BT30230 - User Manual

6 • Do not cook on a broken or cracked cooktop. If the cooktop surface should break or crack, switch the appliance off immediately at the main power supply (wall switch) and contact a qualified technician. • Switch the cooktop off at the wall before cleaning or maintenance. • Failure to follow this ...

7 Cut Hazard • Take care: panel edges are sharp. • Failure to use caution could result in injury or cuts. • The razor-sharp blade of a cooktop scraper is exposed when the safety cover is retracted. Use with extreme care and always store safely and out of reach of children. • Failure to use caution c...

8 INSTALLATION INSTRUCTIONS The cooktop must be installed and connected in accordance with all local codes and regulations. After unpacking the appliance, ensure there is no visible damage. If it has been damaged during transit, DO NOT USE. Contact your appliance seller immediately. Cooktop Installa...

10 Make sure the electric cooktop is well ventilated and the air inlet and outlet are not blocked. Ensure the electric cooktop is in good work state. As shown below: Note: The safety distance between the hotplate and the cupboard above the hotplate should be at least 760mm (30”). A B C D E 760mm/ 30...

11 Foam Gasket 3. The gasket must be attached along the entire length of the glass edge and should not overlap at the corners. 4. When installing the gasket, make sure that the glass does not come into contact with any sharp objects. Before Installing the Fixing Brackets • The unit should be placed ...

12 Connecting the Cooktop to the Power Supply The power supply should be connected in compliance with National Electric Codes, as well as all state, municipal, and local codes. The supply must be from an individual grounded circuit that is protected by a circuit breaker. CAUTION: The appliance has a...

14 CERAMIC COOKTOP LAYOUT NOTE: Before your first use, remove any protective film that may still be on your cooktop. Model: CRH2BT30115 3 1. 1200W Cooking Zone 1 2. 1200W Cooking Zone 3. G lass p late 4. Control panel 2 4 Control Panel 1 2 3 4 5 6 7 1. Cooking Zone selection button 2. Stop & Go ...

21 INDUCTION COOKTOP LAYOUT Model: SINC2B230B/LNC2B230B 3 1 2 4 Control Panel 1. 2000W Boost 2600W Cooking Zone 2. 1500W Boost 2000W Cooking Zone 3. Glass plate 4. Control panel 1 2 3 4 5 6 7 1. Cooking Zone selection button 2. Stop & Go control button 3. Timer control button 4. Booster function...

30 OPERATING YOUR COOKTOP Choose the Right Cookware (Induction Models) • Only use cookware with a base suitable for induction cooking. Look for the induction symbol on the packaging or on the bottom of the pan. • You can check whether your cookware is suitable by carrying out a magnet test. Move a m...

32 Using the Touch Controls • The controls respond to touch, so you don’t need to apply any pressure. Use the ball of your finger, not its tip. • You will hear a beep each time a touch is registered. • Make sure the controls are always clean, dry, and that there is no object (e.g., a utensil or a cl...

33 NOTES: 1. When the cooktop is in Standby mode, and no button is pressed for one minute, the cooktop will beep once, then automatically turn off. 2. The default power level setting is level 5. 3. The heat setting indicator of the selected zone will flash when the level is being adjusted or set. 4....

34 NOTE: A hot surface indicator will glow when any radiant element is turned on and will remain on until the surface is cooled to a safe temperature to touch. To Turn off the Cooktop Be sure you turn the control knob to Off when you finish cooking. It will snap into the Off position. Using the Exte...

35 • Adjust the power of the dual zone by adjusting the control knob to anywhere between symbol and the midpoint of the dial. • To deactivate the dual zone, turn the control knob past the midpoint to the left, toward the symbol to either use the single cooking zone or turn the cooking zone off. Note...

36 2) Touch the Booster function control button , and the heating zone indicator will show “b” and flash for 5 seconds. The booster function is now active. Notes: 1. When using booster function, if the other cooking zone in vertical direction is also activated at a power level higher than 2, program...

37 To Unlock the Controls 1. Make sure the electric cooktop is turned on. 2. Touch and hold the Child Lock control button for 3 seconds, the buzzer beeps once and “ Lo ” disappears in the timer indicator. The Child Lock is now inactive. You can now start using your electric cooktop. Under the child ...

38 Timer control Minute display shows the number of minutes Using the Timer Note: Timer function is for touch/slider control models only. When the cooktop is turned on, you can use the timer in two different ways: • You can use it as a “minute minder” alert, which can be set for up to 99 minutes. In...

39 NOTE: By continuously touching the timer control button, the slider works in this sequence: “Single Digit-Tens Digit -Confirm Setting-Single Digit-…” When the minute minder is set, it will begin to count down immediately and show the remaining time in the display. The buzzer will beep for 30 seco...

40 NOTE: By continuous touch the timer control button, the slider works as follows: “Single Digit-Tens Digit -Confirm Setting-Single Digit-…” When the minute minder is set, it will begin to count down immediately and show the remaining time in the display. NOTES: • The red dot next to the power leve...

41 Auto Shutdown Another safety feature for touch/slider control cooktop is auto shutdown. This occurs whenever you forget to switch off a cooking zone. The default shutdown times as below table: Overheat Protection A temperature sensor inside the cooktop monitors its internal temperature. When an e...

42 Simmering • Simmering occurs below the boiling point, at around 85˚C (185˚F), when bubbles are rising occasionally to the surface of the cooking liquid. It is the key to delicious soups and tender stews because flavors develop without overcooking the food. You should also cook egg-based and flour...

43 Heat Settings The settings below are guidelines only. The exact setting will depend on factors including your cookware and the amount you are cooking. Experiment with the cooktop to find the settings that best suit you. Heat setting Suitability 1 - 2 • Delicate warming for small amounts of food •...

44 CLEANING AND MAINTENANCE CAUTION: Before any maintenance or cleaning work is carried out, DISCONNECT the appliance from ELECTRICITY supply and ensure the appliances is completely cool. Cleaning the Cooktop Surface • Clean spillages from the cooktop surface as soon as possible after use. Always en...

45 Notes: • When turning off the power supply of cooktop, there will be no ‘hot surface’ indication, but the cooking zone may still be hot! Take extreme care. • Heavy-duty scourers, some nylon scourers, and harsh/abrasive cleaning agents may scratch the glass. Always read the label to check if your ...

46 TROUBLESHOOTING If you encounter any issues with your cooktop, consult the table below for a quick resolution before contacting our service team: If you've checked the table above and find that you still need help with your cooktop, call our Customer Service facility at 800-932-4267. ISSUE: There...

47 WARNING: This product can expose you to chemicals including Nickel (Metallic) which is known to the State of California to cause cancer. For more information go to www.P65Warnings.ca.gov Note: Nickel is a component in all stainless steel and some other metallic compositions. LIMITED WARRANTY ONE ...