Subaru H7110LS200 - Manual
Subaru H7110LS200 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – B. Security Module Installation; Vehicle Preparation
- Page 3 – NOTE: While the HVAC unit is pulled foward,
- Page 4 – C. Starter Interrupt and Horn Relay Installation
- Page 5 – E. Prior to System Test; Mount the horn bracket by passing it behind the AT
- Page 6 – mode and has returned to normal operation.; NOTE: T h i s i s s h o c k s e n s o r w a rn i n g m o d e . Fo r l i g h t v i b r a t i o n s a n d / o r
- Page 7 – desired sensitivity has been reached.
- Page 8 – K. Finishing the Installation; Installation is now complete.
1
INSTALLATION
INSTRUCTIONS
SECURITY SYSTEM
UPGRADE
LEGACY
P/N: H7110LS200
Kit Contents:
1
Security Control Module w/Integral Bracket
1
Starter Interrupt/Horn Relays w/Integral Bracket
1
Horn w/Integral Bracket
1
Security Radio Mounting Bracket
2
Pan Head Screws (M5
×
8mm)
2
M6 Nuts
2
Window Decals
1
Installation Manual
Tools Required:
#1 Flat-tip Screwdriver
#2 Phillips Head Screwdriver
Electrical Tape
1/4” Drive Ratchet
10-inch 1/4” Drive Extension
10mm Socket
This device complies with FCC rules part 15. Operation is
subject to the following two conditions: (1) this device may
not cause harmful interference and (2) this device must
accept any interference that may cause undesired operation.
NOTE: T h i s s y s t e m re q u i re s p r i o r i n s t a l l a t i o n o f Ke y l e s s E n t r y
System. If installing both systems at the same time, install the
Keyless Entry System first.
00.08
UT28L-11
Printed in Japan
39412/SUBARU (P.01-09) 8/1/00 5:39 PM Page 1
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 Figure 1 Figure 2 Figure 3 A. Pre-Installation Notes B. Security Module Installation 1. Vehicle Preparation a. Lower the driver’s side window to avoid inadvertently locking the keys in the vehicle dur- ing installation. b. Disconnect negative battery terminal to prevent accidental shorting of any ...
3 Figure 4 Figure 5 Figure 6 4. Lift the center console cover by carefully pulling outward in areas indicated by arrows in Figure 4. 5. Remove the six screws indicated by the arrows in Figure 5. Do not disconnect any connectors. Pull theunit out just far enough to access the passenger sideof the uni...
4 C. Starter Interrupt and Horn Relay Installation 1. Remove the screw indicated by the arrow in Figure 1 and disengage the two plastic screws indicated byarrows in Figure 2, then remove the dash panel. 2. Locate the starter interrupt 6-pin (white housing) connector located to the left side of the s...
