Subaru H7110FS300 - Manual
Subaru H7110FS300 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Vehicle Preparation; Remove one plastic screw and two metal screws indica-; NOTE: To detach the black housing, insert a slotted
- Page 3 – Figure 3; Install the keyless entry module to the location previ-; Figure 4
- Page 4 – D. Notes on System Operation
- Page 5 – E. Finish the Installation; Installation is now complete.
1
INSTALLATION
INSTRUCTIONS
REMOTE KEYLESS
ENTRY SYSTEM
FORESTER
P/N: H7110FS300
Kit Contents:
1
Keyless Entry Control Module w/Integral Bracket
2
Remote Control Transmitters
1
Installation Manual
Tools Required:
#1 Flat-tip Screwdriver
#2 Phillips Head Screwdriver (short)
1
/
4
” Drive Ratchet
4-inch
1
/
4
” Drive Extension
1
/
4
” Swivel
10 mm Socket
This device complies with FCC rules part 15. Operation is
subject to the following two conditions: (1) this device may
not cause harmful interference and (2) this device must
accept any interference that may cause undesired operation.
99.11
UT27T-11
Printed in Japan
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 Figure 1 Figure 2 A. Pre-Installation Notes B. Installation 1. Vehicle Preparation a. Lower the driver’s side window to avoid inadvertently locking the keys in the vehicle during installation. b. Note and record station presets on radio for step #2 in section E. Finish the Installation.c. Disconne...
3 Figure 3 4. Insert the 16-pin (white housing) connector into the key- less entry module. 5. Install the keyless entry module to the location previ- ously used by the door lock timer module and secure itin place with two M6 nuts removed in Step 3. Refer toFigure 4 which shows the installed keyless ...
4 C. System Test 1. Reconnect the negative battery terminal.2. Close all vehicle doors (with dome light switch set to “Doors”).3. Depress the LOCK/ARM button on the remote and the following should be observed: 3.1 All vehicle doors will lock 3.2 The vehicle courtesy (dome) light will turn off 3.3 Th...
