Sterling SCD 10 - Manual

10 CFM Compressed Air Dryer Chapter 1: Safety 6 of 30 1-2 General Safety Regulations Read and follow the instructions in this manual before installing, operating or maintaining any equipment. Additional copies are available from the manufacturer. Install, operate, and maintain this equipment accordi...

10 CFM Compressed Air Dryer Chapter 1: Safety 7 of 30 1-4 Warnings and Precautions Our equipment is designed to provide safe and reliable operation when installed and operated within design specifications, following national and local safety codes. To avoid possible personal injury or equipment dama...

10 CFM Compressed Air Dryer Chapter 2: Functional Description 8 of 30 Chapter 2: Functional Description 2-1 Models Covered in This Manual This manual provides instructions for installing and operating your 10 cfm compressed air dryer. 2-2 General Description Mini compressed air dryers are designed t...

10 CFM Compressed Air Dryer Chapter 2: Functional Description 9 of 30 2-5 Safety Features This section includes information on safety devices and procedures that are inherent to the 10 cfm compressed air dryer. This manual is not intended to supersede or alter safety standards established by the use...

10 CFM Compressed Air Dryer Chapter 2: Functional Description 10 of 30 2-7 Remote Membrane Dryer for Low-Dew point Operation (Optional) Membrane dryers take a small percentage of the dried gas and direct it back in a sweeping pattern through the module shell. This provides a driving force to remove ...

10 CFM Compressed Air Dryer Chapter 2: Functional Description 11 of 30 2-8 Microprocessor Controls The 10 cfm compressed air dryer uses a microprocessor-based PID temperature controller for maintaining process air temperature. The controller is a modular, self-contained unit that you can remove from...

10 CFM Compressed Air Dryer Chapter 2: Functional Description 14 of 30 2-9 Restoring Factory Default Settings If the preset parameters on the controller have been tampered with and it no longer properly controls temperature and displays dew point, you can restore the controllers to the factory setup...

10 CFM Compressed Air Dryer Chapter 3: Installation 15 of 30 Chapter 3: Installation 3-1 Uncrating the Equipment The 10 cfm compressed air dryer has a handle at the top of the cabinet to use for lifting. For hopper-mount configurations, be sure to support the hopper when lifting and placing the drye...

10 CFM Compressed Air Dryer Chapter 3: Installation 17 of 30 3-4 Making Electrical Connections The serial tag lists voltage, phase, and amp draw information. Line voltage must be within plus or minus ten percent of the voltage listed on the serial tag, or damage may occur. Never supply any voltage o...

10 CFM Compressed Air Dryer Chapter 4: Operation 19 of 30 Chapter 4: Operation Before beginning dryer operation, make sure that there is a good compressed air connection and that the main power is securely plugged in. Check the process hose and hopper exhaust filter for tight connections. Check all ...

10 CFM Compressed Air Dryer Chapter 5: Maintenance 21 of 30 Chapter 5: Maintenance This dryer is designed to be virtually maintenance-free. This unit is factory-sealed. Any service required on this unit must be performed by factory personnel at the manufacturer’s facility. WARNING! The 10 cfm compre...

10 CFM Compressed Air Dryer Chapter 5: Maintenance 22 of 30 5-3 Replacing the Fuse Outside of the Cabinet Note: If the compressed air dryer does not start when the ON/OFF switch is in the “ON” position, check the main power supply to ensure that it is properly installed. If the main power supply is ...

10 CFM Compressed Air Dryer Chapter 6: Troubleshooting 23 of 30 Chapter 6: Troubleshooting The utmost in safety precautions should be observed at all times when working on or around the machine and the electrical components. All normal trouble-shooting must be accomplished with the unit turned off, ...

10 CFM Compressed Air Dryer Chapter 7: Appendix 25 of 30 Chapter 7: Appendix 7-1 Returned Material Policy Credit Returns Prior to the return of any material, authorization must be given by the manufacturer . A RMS number will be assigned for the equipment to be returned. Reason for requesting the re...

10 CFM Compressed Air Dryer Chapter 7: Appendix 26 of 30 7-2 Technical Assistance Parts Department Call toll-free 7am—5pm CST [800] 423-3183 or call [262] 641-8610; Fax [262] 641-8653 The ACS Customer Service Group will provide your company with genuine OEM quality parts manufactured to engineering ...

10 CFM Compressed Air Dryer Chapter 7: Appendix 27 of 30 7-3 Technical Specifications Average dew point: -10ºF (-23ºC) Average dew point with optional membrane dryer: -40ºF (-40ºC) Heating capabilities up to 400ºF Large particle compressed air filter Exhaust air cartridge filter 1/16 DIN PID tempera...

10 CFM Compressed Air Dryer Chapter 7: Appendix 30 of 30 7-4 Spare Parts List Parts not included in this list must be replaced by the factory. Part No. Quantity Description 35452 1 Filter Regulator 725.00002.00 1 Fuse (110 volt) 725.00001.00 1 Fuse 220/1/50 725.00001.00 2 Fuse 230/1/60 CT92241 1 Hop...