Sterling 402028 - Manual
Sterling 402028 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – CAUTION: Risk of personal injury or product damage.; Sterling
- Page 3 – Remove the Existing Toilet; Turn off the water supply.; Closet Flange
- Page 6 – Adjustments; Adjust the water level in the tank to the marked waterline.; Ferrule; Supply Shut-Off Valve; Waterline; Adjusting the Water Level
- Page 7 – Install the Push Buttons; Carefully set the cover in position on the tank.
- Page 8 – Guide d’installation; Outils et matériels; Manipuler avec précaution. La; Clé à tuyau
- Page 9 – ATTENTION : Risque d’émanation de gaz nocifs.
- Page 10 – Installer la cuvette; IMPORTANT ! Risque de fuites extérieures.
- Page 12 – Installer le réservoir; ATTENTION : Risque d’endommagement du produit.; Le
- Page 13 – Connexions finales; Mettre soigneusement en place le couvercle du réservoir.; Réglages; Ajuster le niveau d’eau du réservoir au niveau de la ligne d’eau.; Collet; Connexion de robinet d'arrêt
- Page 15 – Guía de instalación; Herramientas y materiales; Maneje el producto con cuidado. La porcelana; Cortatubos
- Page 16 – Desmonte el inodoro existente; Cierre el suministro principal del agua.; PRECAUCIÓN: Riesgo de fuga de gases nocivos.; Si el inodoro; Pernos en T
- Page 20 – Conexiones finales; Conecte la llave de paso al vástago de suministro del inodoro.; Ajustes; Ajuste el nivel de agua en el tanque a la línea de agua marcada.; Casquillo; Conexión de la llave de paso del; Línea de agua; Ajuste del nivel de agua
- Page 21 – Instale los botones; Coloque la tapa con cuidado sobre el tanque.
Installation Guide
Dual-Flush
Close-Coupled Toilet
Français, page “Français-1”
Español, página “Español-1”
402024
402025
402027
402028
1035429-2-D
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Thank You For Choosing Sterling We appreciate your commitment to Sterling value. Please take a fewminutes to review this manual before you start installation. If youencounter any installation or performance problems, please don’thesitate to contact us. Our phone numbers are listed on the back cover....
1. Remove the Existing Toilet Turn off the water supply. Flush the toilet, then sponge out all remaining water from thetank. Disconnect the supply shut-off valve (if present), and remove theold tank and bowl. Remove the old wax seal from the floor with a putty knife. Replace the old T-bolts with the...
4. Final Connections Connect the supply shut-off valve to the toilet supply shank. Open the supply shut-off valve slowly to check for leaks. If theconnections have been properly assembled, a slight tightening ofthe nuts should stop leakage. Install the toilet seat according to the packed instruction...
