Sony Ericsson DSC-S600 - Manual
Sony Ericsson DSC-S600 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 3 – Remove the case
- Page 6 – Wiring your S40 camera to the PixController
- Page 7 – PixController Universal Camera Port Diagram
How to hardwire the Sony DSC-S600 Digital Camera
Copyright
, PixController
http://www.PixController.com
, all rights reserved.
This document covers in detail how to modify the Sony DSC-S600 digital camera for remote shutter control from the
PixController Universal or LE camera control board. Please see
http://www.pixcontroller.com
or email
for more information.
Please note that if you make this modification to your Sony camera that you will void your
camera’s warranty. This modification can also result in damage to your digital camera if
you do not follow the instructions properly.
Tools/Parts Needed
1. 2.4 mm #0 Philips Screwdriver & Small Flat Blade Screwdriver.
2. Fine tipped soldering iron with heat control.
3. 30 Gauge wire. Wire Wrap type wire can be purchased from your local Radio Shack store. Find one of the 3
part numbers: 278-501, 278-502, 278-503. They come in a spool of 50 feet of wire for $2.99
4. Small tweezers.
5. Flat blade screw driver or knife.
6.
PixController Universal board with Sony S40-U PIC chip, or LE board with LE II PIC chip
(Use the Sony DSC-
S40 mode for the DSC-S600 camera)
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Remove screw 4 from under the battery door. Remove the case Carefully remove the back of the camera case from the camera exposing the interior electronics. Next, remove the front of the camera case. This is a little harder to remove, but take your time and unsnap all of the hinges. The front of the ...
Route the wires Put the shutter board back into the plastic housing and screw the housing back to the camera. Twist the wires into a small cable and route the cable around the LCD display as shown in Figure 5. Secure the cable to the bottom with some tape. From here you can drill a hole in the botto...
2. Wiring your S40 camera to the PixController Universal board. Connect the following wires to your Universal board: Shutter – Shutter, J14-1, or Phone Cable Shutter Wire Ground – Ground, J14-7, or Phone Cable Ground Wire Power – Power, J14-3, or Phone Cable Power Wire PixController Universal Camera...
