Sony CDX-CA530X - Manual
Sony CDX-CA530X – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – SERVICE NOTES; NOTES ON LASER DIODE EMISSION CHECK; Never reuse a disconnected chip component.; CAUTION; TEST DISCS; These marks denote that a disc is not for audio use.
- Page 3 – TABLE OF CONTENTS; ELECTRICAL PARTS LIST; EXTENSION CABLE AND SERVICE POSITION
- Page 7 – SECTION 2; SET
- Page 13 – SECTION 3
- Page 17 – • Waveforms
- Page 18 – for printed wiring boards:
- Page 19 – • Semiconductor
- Page 20 – • Refer to page 17 for Waveforms.
- Page 21 – • Semiconductor Location
- Page 25 – -12. SCHEMATIC DIAGRAM — DISPLAY SECTION —
- Page 26 – • IC BLOCK DIAGRAMS
- Page 33 – DISPLAY
- Page 35 – MAIN
- Page 40 – REVISION HISTORY; Date
1
Model Name Using Similar Mechanism
CDX-L300/L460X
CD Drive Mechanism Type
MG-393XA-121//K
Optical Pick-up Name
KSS-720A
SERVICE MANUAL
US Model
Canadian Model
CDX-CA400
E Model
CDX-CA530X/CA580X
CDX-CA400/CA530X/CA580X
FM/AM COMPACT DISC PLAYER
AUDIO POWER SPECIFICATIONS (US Model)
POWER OUTPUT AND TOTAL HARMONIC DISTORTION
23 watts per channel minimum continuous average power into
4 ohms, 4 channels driven from 20 Hz to 20 kHz with no more
than 5% total harmonic distortion.
CD player section
Signal-to-noise ratio
90 dB
Frequency response
10 – 20,000 Hz
Wow and flutter
Below measurable limit
Tuner section
FM
Tuning range
87.5 – 107.9 MHz
Antenna terminal
External antenna connector
Intermediate frequency 10.7 MHz
Usable sensitivity
11 dBf
Selectivity
75 dB at 400 kHz
Signal-to-noise ratio
65 dB (stereo),
68 dB (mono)
Harmonic distortion at 1 kHz
0.7% (stereo),
0.5% (mono)
Separation
33 dB at 1 kHz
Frequency response
30 – 15,000 Hz
AM
Tuning range
530 – 1,710 kHz
Antenna terminal
External antenna connector
Intermediate frequency 10.7 MHz/450 kHz
Sensitivity
30 µV
Power amplifier section
Outputs
Speaker outputs
(sure seal connectors)
Speaker impedance
4 – 8 ohms
Maximum power output 50 W
×
4 (at 4 ohms)
SPECIFICATIONS
General
Outputs
Audio outputs
Power antenna relay control lead
Power amplifier control lead
Tone controls
Bass ±10 dB at 20 Hz (CDX-CA400)
Bass ±9 dB at 100 Hz (CDX-CA530X/CA580X)
Treble ±10 dB at 20 kHz (CDX-CA400)
Treble ±9 dB at 10 kHz (CDX-CA530X/CA580X)
Power requirements
12 V DC car battery
(negative ground)
Dimensions
Approx. 178
×
50
×
177 mm
(7
1/8
×
2
×
7 in.) (w/h/d)
Mounting dimensions
Approx. 182
×
53
×
161 mm
(7
1/4
×
2
1/8
×
6
3/8
in.) (w/h/d)
Mass
Approx. 1.2 kg
(2 lb. 10 oz.)
Supplied accessories
Parts for installation and connections (1 set)
Front panel case (1)
Card remote commander
RM-X115 (CA400/CA580X)
Note
This unit cannot be connected to a digital preamplifier or an equalizer.
Design and specifications are subject to change without
notice.
Photo: CDX-CA400
• The tuner and CD sections have no adjustments.
Sony Corporation
e Vehicle Company
Published by Sony Engineering Corporation
9-873-433-01
2001L0400-1
© 2001. 12
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 CDX-CA400/CA530X/CA580X optical pick-up block semi-fixed resistor SERVICE NOTES NOTES ON HANDLING THE OPTICAL PICK-UP BLOCKOR BASE UNIT The laser diode in the optical pick-up block may suffer electrostaticbreakdown because of the potential difference generated by thecharged electrostatic load, etc...
3 TABLE OF CONTENTS 1. GENERAL Location of controls (CDX-CA400) ........................................ 4Location of controls (CDX-CA530X/CA580X) ..................... 4Connections (CDX-CA400) .................................................... 5Connections (CDX-CA530X/CA580X) .......................
7 CDX-CA400/CA530X/CA580X claws 4 claws 5 panel (1) assy, sub 3 claw 1 PTT 2.6x6 2 PTT 2.6x6 SECTION 2 DISASSEMBLY Note : This set can be disassemble according to the following sequence. Note : Follow the disassembly procedure in the numerical order given. 2-1. PANEL (1) ASSY, SUB 2-1. PANEL (1) ASS...
