SoleusAir Industrial Utility Heater HI1-50-03- User Manual
SoleusAir Industrial Utility Heater HI1-50-03– User Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 4 – chemical storage areas.; SAFETY INFORMATION
- Page 5 – SPECIFICATIONS
- Page 6 – HEATER LOCATION AND INSTALLATION; FRONT VIEW; DIAGRAM 1
- Page 7 – MOUNTING THE BRACKET; wrench and slipping the handle off over the screw heads.; NOTE; : If you want the heater to swivel side to side,; HANGING THE HEATER; Lift the heater up and into the mounting bracket.; SINGLE –SCREW MOUNTING
- Page 8 – Turn off the power at the main service; Turn on the power at the main service.
- Page 10 – OPERATION; as needed to adjust the direction of the air flow.; : To tilt the heater it must be mounted in bottom keyhole slots of; : The louvers are designed so they cannot be
- Page 11 – MAINTENANCE; CLEANING THE FAN AND MOTOR
- Page 12 – WARRANTY; THIS WARRANTY DOES NOT COVER:; Freight and Insurance cost for the warranty service.; For Technical Support or Warranty Service
HI1-50-03
© 2010 Soleus Air International
HI1-50-03
Industrial Utility Heater
3092402
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
1. Use Copper wire only rated at least 60°C (140°F) 2. For supply connections use No.10 AWG or larger wires suitable for at least 60°C (140°F) 3. Heater air flow must be directed parallel to, or away from, adjacent walls. 4. Observe wall, floor, and ceiling clearance requirements on DIAGRAM 1 on Pag...
SPECIFICATIONS Voltage Rating / Amps 208V-240 V / 21 Amps / Single Phase Power Consumption 5000 Watts Unit Size 15.7 inches. (W) x 11.29 inches. (D) x 14.37 inches. (H) Unit Weight 27.00 lbs. Air Flow 270 CFM Heating BTU’s 17,100 BTU 5
HEATER LOCATION AND INSTALLATION Install the heater out of traffic areas maintaining the required clearances below. The direction of air flow shold not be restricted by anything and the air flow should not blow directly at exposed walls. When more than one heater is used in an area, the heaters shou...
