SoleusAir Industrial Utility Heater HI1-50-03- Manuals

Page 4 - chemical storage areas.; SAFETY INFORMATION

1. Use Copper wire only rated at least 60°C (140°F) 2. For supply connections use No.10 AWG or larger wires suitable for at least 60°C (140°F) 3. Heater air flow must be directed parallel to, or away from, adjacent walls. 4. Observe wall, floor, and ceiling clearance requirements on DIAGRAM 1 on Pag...

Page 5 - SPECIFICATIONS

SPECIFICATIONS Voltage Rating / Amps 208V-240 V / 21 Amps / Single Phase Power Consumption 5000 Watts Unit Size 15.7 inches. (W) x 11.29 inches. (D) x 14.37 inches. (H) Unit Weight 27.00 lbs. Air Flow 270 CFM Heating BTU’s 17,100 BTU 5

Page 6 - HEATER LOCATION AND INSTALLATION; FRONT VIEW; DIAGRAM 1

HEATER LOCATION AND INSTALLATION Install the heater out of traffic areas maintaining the required clearances below. The direction of air flow shold not be restricted by anything and the air flow should not blow directly at exposed walls. When more than one heater is used in an area, the heaters shou...

Page 7 - MOUNTING THE BRACKET; wrench and slipping the handle off over the screw heads.; NOTE; : If you want the heater to swivel side to side,; HANGING THE HEATER; Lift the heater up and into the mounting bracket.; SINGLE –SCREW MOUNTING

LOCATION AND INSTALLATION (CONT.) MOUNTING THE BRACKET 1. Locate a stud in the ceiling joist. 2. Remove the mounting bracket from the heating unit be loosening the bracket screws with a wrench and slipping the handle off over the screw heads. 3. Place a washer on the screws before inserting through ...

Page 8 - Turn off the power at the main service; Turn on the power at the main service.

LOCATION AND INSTALLATION (CONT.) CONNECTING THE POWER (HARDWIRING) 1. Turn off the power at the main service 2. Remove the screw from the back of the unit to connect the power to the heater. 3. Attach the cable connectors to the unit and slide the 10 gauge wire through the cable connector. NOTE : F...

Page 10 - OPERATION; as needed to adjust the direction of the air flow.; : To tilt the heater it must be mounted in bottom keyhole slots of; : The louvers are designed so they cannot be

OPERATION NOTE : The first time you operate this heater, it may emit a slight odor and some smoke. This is due to the residual cleaning agents used to clean the element during manufacturing. This is normal op-eration and will cease after the heater has been used for a few minutes. ADJUSTING THE AIR ...

Page 11 - MAINTENANCE; CLEANING THE FAN AND MOTOR

MAINTENANCE To prevent possible electric shock, disconnect the power to the heater at the main service box be-fore attempting inspect or clean the unit. Use care to prevent damage to the internal components of the heater when cleaning the heating element. Make sure all connections remain tight and a...

Page 12 - WARRANTY; THIS WARRANTY DOES NOT COVER:; Freight and Insurance cost for the warranty service.; For Technical Support or Warranty Service

WARRANTY One Year Limited Warranty Soleus International Inc. warrants the accompanying Soleus Air Heater to be free of defects in material and workman-ship for the applications specified in its operation instruction for a period of ONE (1) year from the date of original re-tail purchase in the Unite...

SoleusAir Industrial Utility Heater HI1-50-03- Manuals

Manuals:

User Manual SoleusAir Industrial Utility Heater HI1-50-03

Summary

SoleusAir Manuals