Snapper LT-200 Series - Manual

5 Safety Rules and Information CHILDREN Tragic accidents can occur if the operator is not alert to thepresence of children. Children are often attracted to theunit and the mowing activity. Never assume that childrenwill remain where you last saw them. 1. Keep children out of the mowing area and unde...

6 Safety Rules & Information SERVICE AND MAINTENANCE Safe Handling of Gasoline 1. Extinguish all cigarettes, cigars, pipes, and other sources of ignition. 2. Use only approved gasoline containers.3. Never remove the gas cap or add fuel with the engine running. Allow the engine to cool before ref...

7 Identification Numbers Tractor ID Tag Mower ID Tag When contacting your authorized dealer forreplacement parts, service, or information you MUSThave these numbers. Record your model name/number, manufacturer’sidentification numbers, and engine serial numbers in thespace provided for easy access. T...

8 Safety Decals Warning: Read Operator’sManual. Read and understand theOperator’s Manual before usingthis machine. Danger: Thrown Objects. This machine is capable of throwingobjects and debris. Keepbystanders away. Warning: Remove Key BeforeServicing. Remove the key and consulttechnical literature b...

9 CE Safety Icons Transmission Release Part No. 1730202 173xxxx Attachment LiftPart No. 1730264 Fuel LevelPart No. 1730172 1730172 1730264 Ignition SwitchPositionsPart No. 1722806 Decals Locations Pinch Point When installing or removing the mower deck, do not place hands between mower lift linkage a...

10 Features & Controls Throttle Control The throttle controls engine speed. Move the throttleforward to increase engine speed and back to decreaseengine speed. Always operate at FULL throttle. Choke Close the choke for cold starting. Open the choke oncethe engine starts. A warm engine may not re...

12 Features & Controls Figure 2. Engaging the Parking BrakeA. Ground Speed PedalsB. Brake PedalC. Parking Brake KnobD. Cruise Control KnobE. HourmeterF. 12V Power Adapter Parking Brake Function Applying the Parking Brake - See Figure 2. To lock the parking brake, release the ground speed pedals ...

13 Operating the Tractor General Operating Safety Be sure to read all information in the Safety andOperation sections before attempting to operate this unit.Become familiar with all of the controls and how to stopthe unit. Adding Fuel To add fuel: 1. Remove the fuel cap (A, Figure 3). 2. Fill the ta...

14 Operating the Tractor Stopping The Tractor & Engine 1. Return the ground speed control(s) to neutral. 2. Disengage the PTO and wait for all moving parts to stop. 3. Briggs & Stratton Models: Move the throttle control to SLOW position and turn the ignition key to OFF.Remove the key. Kohler...

15 Operating the Tractor Mower Deck Removal & Installation Removing the Mower Deck 1. Park tractor on a hard, level surface such as a concrete floor. Turn off PTO switch and engine,remove the key and apply parking brake. 2. Place wood blocks under the mower deck. Place the attachment lift in the...

16 Operating the Tractor Attaching a Trailer The maximum horizontal drawbar force allowed is 280Newton. The maximum vertical drawbar force is 160Newton. This equates to a 250 lbs (113 kg) trailer on a10 degree hill. Secure the trailer with an appropriatelysized clevis pin (A, Figure 8) and clip (B)....

17 Regular Maintenance MAINTENANCE SCHEDULE & PROCEDURES The following schedule should be followed for normal care of your tractor and mower. • = All Models * Refer to engine owner’s manual. Change original engine oil after initial break-in period. ** More often in hot (over 85° F: 30° C) weathe...

18 Regular Maintenance Battery Maintenance Cleaning the Battery and Cables Service Interval: Every 100 Hours 1. Disconnect the cables from the battery, negative cables first (A, Figure 10) then the cover & positivecables (B). 2. Loosen the wingnut & washer (D). 3. Pivot the hold-down rod (C)...

19 Regular Maintenance Hood Removal and Installation HOOD REMOVAL 1. Open the hood.2. Remove the socket and bulbs (A, Figure 12) by twisting the socket counterclockwise and pulling it outof the bezel (B). Repeat on other side. 3. Rock the hood back slightly and lift hood (B, Figure 13) off pivot pos...

20 Regular Maintenance Lubrication Service Interval: Every 25 Hours Lubricate the unit at the locations shown in Figures 14-16 as well as the lubrication points listed. Generally, allmoving metal parts should be oiled where contact ismade with other parts. Keep oil and grease off belts andpulleys. W...

21 Regular Maintenance Figure 17. Rear Axle HardwareA. KeyB. SpacerC. Wheel & HubD. Special WasherE. Small WasherF. E-ClipG. Axle CapH. Large Washer G B D A E F C Figure 15. Arbor Lubrication Points Figure 16. Lubricate Deck Linkage (38” shown) Lubricate Rear Axle Shafts Service Interval: Yearly...

22 Regular Maintenance WARNING For your personal safety, do not handle the sharpmower blades with bare hands. Careless orimproper handling of blades may result in seriousinjury. WARNING For your personal safety, blade mountingcapscrews must each be installed with two springwashers or a hex washer an...

23 Regular Maintenance Check & Fill Engine Oil Service Interval: Before each use, and every 8 hours. 1. Turn the engine off, and set the parking brake to PARK. 2. Clean the area around the dip stick (C, Figure 22 or 23). 3. Remove the dip stick (C) and clean it with a paper towel. 4. Insert the ...

24 Regular Maintenance Figure 24. Oil Drain ValveA. Engine Block / Valve BaseB. Oil Drain ValveC. CoverD. Nipple A A B B C C D Figure 25. Recommended Engine Oil - Briggs & Stratton Models Use oil classified API Service Class SF, SG, SH, SJ or better with SAE Viscosity: 100 80 60 40 20 32 0 -20 3...

25 Regular Maintenance Figure 26. Air Filter Assembly - Briggs & StrattonTwin Cylinder ModelsA. KnobsB. Air Filter CoverC. Air FilterD. Pre-Cleaner Air Filter & Pre-Cleaner Service BRIGGS & STRATTON TWO CYLINDER MODELS Service Interval: Pre-Cleaner: Every 25 hours or as required. Air Fil...

27 Regular Maintenance Figure 31. Spark Plug Gapping Replace Spark Plug Service Interval: Yearly Spark Plug Gap: .030” (.76mm) Replacement Spark Plug Resistor Spark Plug, Champion RC12YC 1. Stop the engine and allow it to cool. 2. See Figures 31or 32. Clean the area around the spark plug. 3. Remove ...

28 Troubleshooting,Adjustment, & Service Troubleshooting While normal care and regular maintenance will extendthe life of your equipment, prolonged or constant usemay eventually require that service be performed toallow it to continue operating properly. The troubleshooting guide below lists the...

29 Troubleshooting, Adjustment, & Service Tractor Troubleshooting Cont. Tractor drive belt slips. 1. Pulleys or belt greasy or oily. Clean as required. 2. Belt stretched or worn. See Dealer. 3. Idler pulley pivot bracket Remove idler pulley bracket, clean and lubricate. “frozen” in declutched po...

31 Troubleshooting, Adjustment, & Service PTO clutch adjustment Check the PTO clutch adjustment after every 250 hoursof operation. Also perform the following procedure if theclutch is slipping or will not engage, or if a new clutchhas been installed. 1. Remove key from ignition switch and discon...

33 Troubleshooting, Adjustment, & Service WARNING Before checking mower, shut off PTO andengine, remove the key, and allow all movingparts to stop. Leveling The Mower If the cut is uneven, the mower may need leveling.Unequal or improper tire pressure may also cause anuneven cut. Make sure tire p...

Figure 41. Typical Mower Belt Routing Two BladeDecksA. Idler Pulley ArmB. PTO Pulley (Engine)C. Mower UpstopD. Idler Pulley Belt Guide Left Side of Mower 34 Troubleshooting, Adjustment, & Service Mower Belt Replacement Note: It is not necessary to remove the mower to install anew belt. However, ...

35 Specifications ENGINE: 20 HP* Briggs & Stratton Make Briggs & Stratton Model Intek Horsepower 20 @ 3600 rpm Displacement 30.5 Cu. in (582cc) Electrical System 12 Volt, 9 amp. Alternator, Battery: 230 CCA Oil Capacity 64 Oz. (1.9 L) 18.5 HP* Briggs & Stratton Make Briggs & Stratton...