Snapper 421823BVE, 422023BVE Manual

Page 2 - IMPORTANT SAFETY INSTRUCTIONS; PROTECTION FOR CHILDREN

2 IMPORTANT SAFETY INSTRUCTIONS WARNING: This powerful cutting machine is capable of amputating hands and feet and can throw objects that can cause injury and damage! Failure to comply with the following SAFETY instructions could result in serious injury or death to the operator or other persons. Th...

Page 3 - PREPARATION

3 IMPORTANT SAFETY INSTRUCTIONS PREPARATION (Continued From Previous Page) 6. Check the area to be mowed and remove all objects such as toys, wire, rocks, limbs and other objects that could cause injury if thrown by blade or interfere with mowing. 7. Keep people and pets out of mowing area. Immediat...

Page 4 - TOWING

4 IMPORTANT SAFETY INSTRUCTIONS TOWING 1. Tow only with a machine that has a hitch designed for towing. DO NOT attach towed equipment except at the hitch point. 2. Follow the manufacturer’s recommendation for weight limits for towed equipment and towing on slopes. 3. DO NOT allow children or others ...

Page 5 - TABLE OF CONTENTS

5 TABLE OF CONTENTS IMPORTANT SAFETY INSTRUCTIONS ........................................................................ 2-4 TABLE OF CONTENTS ..................................................................................................... 5 SECTION 1 - FAMILIARIZATION ..........................

Page 6 - Section 1 - FAMILIARIZATION; Understand and Follow; the IMPORTANT SAFETY; All; SAFETY messages on the Rear Engine Rider and its

6 Section 1 - FAMILIARIZATION FIGURE 1.1 1.1 INTRODUCTION This manual has been prepared for the operator’s of the SNAPPER Rear Engine Rider. Its purpose, aside from recommending standard operating procedures and routine service requirements, is to promote SAFETY through the use of accepted operating...

Page 7 - Section 2 - OPERATING INSTRUCTIONS; OPERATOR’S SEAT ADJUSTMENT

7 Section 2 - OPERATING INSTRUCTIONS 2.1 PRE-START CHECK LIST Make the following checks and perform the service required before each start-up. 2.1.1. Check tires and add or release air as needed to bring pressure to 12 psi in front and 12 psi in rear tires. 2.1.2. Check guards, deflectors and covers...

Page 8 - WARNING

8 Section 2 - OPERATING INSTRUCTIONS 2.3 STARTING & OPERATION 2.3.1. ENGINE (ELECTRIC START) IMPORTANT: When the ignition key is turned to “START”, the engine will turn over, but will not start unless the Clutch/Brake pedal is pressed all the way down, the Blade Lever is in the “Off” position (S...

Page 10 - “FAST”

10 Section 2 - OPERATING INSTRUCTIONS WARNING Once blade is disengaged, it should come to a complete stop in 3 seconds or less. If the blade continues to rotate after 3 seconds, the blade brake must be adjusted. Refer to Section “BLADE BRAKE ADJUSTMENT” for adjustment procedures or return machine to...

Page 11 - Stop engine by turning key to the; Stop mower blade by releasing blade pedals or

11 Section 2 - OPERATING INSTRUCTIONS WARNING DO NOT leave machine with the engine running. Stop engine. Stop blade. Shift to neutral. Engage parking brake. Remove key. 2.4 STOPPING - ENGINE, WHEEL DRIVE, BLADE 2.4.1. ENGINE 1. Stop engine by turning key to the “OFF” position. See Figure 2.13. FIGUR...

Page 12 - Engage park brake by pushing clutch/brake pedal; DO NOT park the machine on slopes.

12 Section 2 - OPERATING INSTRUCTIONS 2.4 STOPPING - ENGINE, WHEEL DRIVE, BLADE 2.4.4. PARK BRAKE 1. Engage park brake by pushing clutch/brake pedal “DOWN” and moving the park brake latch over to the “ENGAGED” position. While holding the park brake latch “ENGAGED”, release clutch/brake pedal to set ...

Page 13 - DO NOT operate blades in; Depress and hold Override Lever.; DO NOT use the Reverse Lockout; DANGER; LOOK and SEE behind and down for children, pets

13 Section 2 - OPERATING INSTRUCTIONS 2.6 REVERSE LOCKOUT MECHANISM Data indicates that tragic back-over accidents occur each year. These accidents usually involve unsupervised children. Many times these children have been given rides on the machine and have been trained to view this potentially dan...

Page 14 - Section 3 - MAINTENANCE

14 Section 3 - MAINTENANCE WARNING DO NOT attempt any adjustments, maintenance, service or repairs with the engine running. STOP engine. STOP blade. Engage parking brake. Remove key. Remove spark plug wire from spark plug and secure away from plug. Engine and components are HOT. Avoid serious burns,...

Page 15 - BRAKE; TOP VIEW OF BELT ROUTING

15 Section 3 - MAINTENANCE WARNING DO NOT attempt any adjustments, maintenance, service or repairs with the engine running. STOP engine. STOP blade. Engage parking brake. Remove key. Remove spark plug wire from spark plug and secure away from plug. Engine and components are HOT. Avoid serious burns,...

Page 16 - Section 3 – MAINTENANCE; ENGINE MUST NOT START IF:

16 Section 3 – MAINTENANCE 3.2 SERVICE - AFTER FIRST 5 HOURS INTERLOCK SYSTEM SAFETY CHECKS (Cont.) ENGINE MUST NOT START IF: 1) Clutch/brake pedal is not fully depressed OR, 2) Blade Control is in the “ON” (blades engaged) position. ENGINE SHOULD START IF: 1) Blade Control is in the “OFF” (blades d...

Page 19 - EVERY TWO YEARS

19 Section 3 - MAINTENANCE WARNING DO NOT attempt any adjustments, maintenance, service or repairs with the engine running. STOP engine. STOP blade. Engage parking brake. Remove key. Remove spark plug wire from spark plug and secure away from plug. Engine and components are HOT. Avoid serious burns,...

Page 20 - REMOVING FUEL TANK

20 Section 3 - MAINTENANCE 3.6 STORAGE (OUT OF SEASON) If desired, the Rear Engine Rider can be stored on the rear bumper. Perform the following procedures to insure the Rear Engine Rider will operate properly when taken out of storage. 3.6.1. Thoroughly clean the Rear Engine Rider by removing all g...

Page 24 - REAR ENGINE RIDER DRIVE COMPONENTS

24 Section 4 - ADJUSTMENTS & REPAIR WARNING DO NOT attempt any adjustments, maintenance, service or repairs with the engine running. STOP engine. STOP blade. Engage parking brake. Remove key. Remove spark plug wire from spark plug and secure away from plug. Engine and components are HOT. Avoid s...

Page 25 - ADJUSTMENT; Blades are extremely sharp and can cause severe

25 Section 4 - ADJUSTMENTS & REPAIR WARNING DO NOT attempt any adjustments, maintenance, service or repairs with the engine running. STOP engine. STOP blade. Engage parking brake. Remove key. Remove spark plug wire from spark plug and secure away from plug. Engine and components are HOT. Avoid s...

Page 29 - TESTING

29 Section 4 - ADJUSTMENTS & REPAIR WARNING The electrolyte (acid) produces a highly explosive gas. Keep all sparks, flame and fire away from area when charging battery or when handling electrolyte or battery. Electrolyte (acid) is a highly corrosive liquid. Wear eye protection. Wash affected ar...

Page 30 - Battery Condition Chart; State of Charge; SNAPPER REAR ENGINE RIDER ACCESSORIES; DESCRIPTION OF KIT

30 Section 4 - ADJUSTMENTS & REPAIR 4.6.6. BATTERY TESTING Battery Condition Chart State of Charge Syringe Hydrometer Digital Voltmeter Five Ball Hydrometer 100% Charged w/ Sulfate Stop 1.280 12.80v Five Balls Floating 100% Charged 1.265 12.60v Four Balls Floating 75% Charged 1.210 12.40v Three ...

Page 31 - TROUBLESHOOTING; (Trouble Shooting Continued on Next Page)

31 TROUBLESHOOTING PROBLEM PROBABLE CAUSE CORRECTIVE ACTION Engine Will Not 1. Fuel tank empty. 1. Fill fuel tank with fresh fuel to proper level. Start Using 2. Engine needs choking. 2. Move choke control to “CHOKE” position. Recoil Starter 3. Spark plug wire disconnected. 3. Place spark plug wire ...

Page 34 - YEAR LIMITED WARRANTY; any authorized

34 2 YEAR LIMITED WARRANTY For two (2) years from purchase date for the original purchaser's residential, non-commercial use, SNAPPER , through any authorized SNAPPER dealer will replace, free of charge (except for taxes where applicable), any part or parts found upon examination by the factory at M...

Page 35 - PRIMARY MAINTENANCE

Page 39 - SNAPPER PRODUCT REGISTRATION FORM; IMPORTANT: KEEP THIS INFORMATION FOR YOUR PERSONAL RECORDS; (Complete the following information on your Snapper purchase)

39 SNAPPER PRODUCT REGISTRATION FORM IMPORTANT: KEEP THIS INFORMATION FOR YOUR PERSONAL RECORDS (Complete the following information on your Snapper purchase) Model Number _____________________________________________________________ Serial Number _____________________________________________________...