Page 4 - Copyright
Copyright Information furnished by SMC Networks, Inc. (SMC) is believed to be accurate and reliable. However, no responsibility is assumed by SMC for its use, nor for any infringements of patents or other rights of third parties which may result from its use. No license is granted by implication or ...
Page 5 - Limited Warranty
i Limited Warranty Limited Warranty Statement: SMC Networks, Inc. (“SMC”) warrants its products to be free from defects in workmanship and materials, under normal use and service, for the applicable warranty term. All SMC products carry a standard 90-day limited warranty from the date of purchase fr...
Page 6 - ii
L IMITED W ARRANTY ii WARRANTIES EXCLUSIVE: IF AN SMC PRODUCT DOES NOT OPERATE AS WARRANTED ABOVE, CUSTOMER’S SOLE REMEDY SHALL BE REPAIR OR REPLACEMENT OF THE PRODUCT IN QUESTION, AT SMC’S OPTION. THE FOREGOING WARRANTIES AND REMEDIES ARE EXCLUSIVE AND ARE IN LIEU OF ALL OTHER WARRANTIES OR CONDITI...
Page 7 - iii; OMPLIANCES; Industry Canada - Class A
iii C OMPLIANCES FCC - Class A This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause interference to radio communications. It has been tested and found to comply with the limits for a Class A computi...
Page 8 - iv; EC Conformance Declaration - Class A
C OMPLIANCES iv EC Conformance Declaration - Class A SMC contact for these products in Europe is: SMC Networks Europe,Edificio Conata II,Calle Fructuós Gelabert 6-8, 2 o , 4 a , 08970 - Sant Joan Despí,Barcelona, Spain. This information technology equipment complies with the requirements of the Coun...
Page 9 - Safety Compliance
C OMPLIANCES v Australia AS/NZS 3548 (1995) - Class A SMC contact for products in Australia is: SMC Communications Pty. Ltd.Suite 18, 12 Tryon Road, Lindfield NSW2070,Phone: 61-2-94160437Fax: 61-2-94160474 Safety Compliance Underwriters Laboratories Compliance Statement Important! Before making conn...
Page 11 - vii; ABLE
vii T ABLE OF C ONTENTS About the EZ Switch 10/100 . . . . . . . . . . . . . . . . . . 1 Features and Benefits . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1Front Panel LEDs . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ....
Page 12 - viii
Page 13 - EZ S; WITCH; Features and Benefits
1 A BOUT THE EZ S WITCH 10/100 The EZ Switch™ 10/100 SMC-EZ1024DT is a 24-port Fast Ethernet switch. The 10BASE-T/100BASE-TX ports deliver dedicated 10/100 Mbps links to each attached LAN segment – all with conventional cabling and adapters. Auto-negotiation is used to select the optimal communicati...
Page 14 - Front Panel LEDs
A BOUT THE EZ S WITCH 10/100 2 ◆ Plug-and-play ◆ “At-a-glance” LEDs for port and system status monitoring ◆ Desktop and rack mountable Front Panel LEDs The front panel of the switch provides a link status LED for each RJ-45 port. In addition, the front panel also contains status LEDs for “at-a-glanc...
Page 15 - Rear Panel
R EAR P ANEL 3 Rear Panel The AC power socket is located on the rear panel of the switch. FDX On The port is in full-duplex mode. Off The port is in half-duplex mode. Flashing Packet collision is occurring in half-duplex mode. Port and Switch Status LEDs LED Condition Status 100-240VAC 50-60Hz 1A 10...
Page 16 - Equipment Checklist
4 I NSTALLING THE S WITCH The EZ Switch 10/100 can be placed on a desktop or shelf, or installed in a standard 19-inch equipment rack. Equipment Checklist After unpacking the EZ Switch 10/100, check the contents of the box to be sure you have received the following components: • EZ Switch 10/100 SMC...
Page 17 - Selecting a Site
S ELECTING A S ITE 5 Selecting a Site Be sure to follow the site selection guidelines below when choosing a location: Select a suitable location for the switch:• It should be accessible for installing, cabling and maintaining the switch. • The temperature and humidity should be within the ranges l...
Page 18 - Instructions
I NSTALLING THE S WITCH 6 Make sure that a properly grounded power outlet is within 2.44 meters (8 feet) of the switch and is powered from an independent circuit breaker. As with any equipment, using a filter or surge suppressor is recommended. Instructions 1. Positioning the Switch: For desktop o...
Page 19 - Standalone LAN
7 S AMPLE A PPLICATIONS Some typical applications for the EZ Switch 10/100 are illustrated below: Standalone LAN In the figure below, the EZ Switch 10/100 is operating as a collapsed backbone for a small LAN. It is providing dedicated 10 Mbps full-duplex connections to workstations and 200 Mbps full...
Page 20 - High-Speed Switch Links
S AMPLE A PPLICATIONS 8 High-Speed Switch Links In this application a 200 Mbps full-duplex link is made to a second EZ 10/100 switch. 5 6 7 8 1 2 3 4 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 Link/Act Link/Act 10/100 10/100 9 10 11 12 20 21 22 23 24 5 6 7 8 1 2 3 4 9 10 11 12 13 14 15 16 17 18 ...
Page 21 - ROUBLESHOOTING
9 T ROUBLESHOOTING 1. Symptom Power LED does not light after power on. Probable Causes Power outlet or power cord may be defective. Possible Solutions • Check for loose connections. • Check the power outlet by using it for another device. • Replace the power cord. 2. Symptom Link LED does not light ...
Page 22 - ABLES; Cable Specifications
10 C ABLES Cable Specifications Twisted-Pair Cable and Pin Assignments Caution: DO NOT plug a phone jack connector into any RJ-45 port. Use only twisted-pair cables with RJ-45 connectors that conform with FCC standards. For 10BASE-T/100BASE-TX connections, a twisted-pair cable must have two pairs of...
Page 24 - Connectivity Guidelines
C ABLES 12 Connectivity Guidelines Note: Network diameter is defined as the wire distance between two end stations in the same collision domain. Maximum Fast Ethernet Network Diameter Repeater Type and Number Twisted Pair 100BASE-TX Twisted Pair/Fiber 100BASE-TX and FX 1 Class I 200 m (656 ft) 260.8...
Page 25 - PECIFICATIONS
13 S PECIFICATIONS EZ Switch 10/100 Model SMC-EZ1024DT Ports 24 RJ-45 ports Network Interface RJ-45: 100 ohm, UTP cable10BASE-T – EIA/TIA Categories 3, 4, or 5100BASE-TX – EIA/TIA Category 5 LEDs Power – oneLink/Act (Activity) – one per port 100M (10/100 Mbps) – one per port Switching Method Store-a...
