Page 6 - ii
L IMITED W ARRANTY ii WARRANTIES EXCLUSIVE: IF AN SMC PRODUCT DOES NOT OPERATE AS WARRANTED ABOVE, CUSTOMER’S SOLE REMEDY SHALL BE REPAIR OR REPLACEMENT OF THE PRODUCT IN QUESTION, AT SMC’S OPTION. THE FOREGOING WARRANTIES AND REMEDIES ARE EXCLUSIVE AND ARE IN LIEU OF ALL OTHER WARRANTIES OR CONDITI...
Page 7 - iii; OMPLIANCES; EC Conformance Declaration - Class A
C OMPLIANCES iii C OMPLIANCES FCC - Class A This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. Th...
Page 8 - iv; Industry Canada - Class A
C OMPLIANCES iv Industry Canada - Class A This digital apparatus does not exceed the Class A limits for radio noise emissions from digital apparatus as set out in the interference-causing equipment standard entitled “Digital Apparatus,” ICES-003 of the Department of Communications.Cet appareil numér...
Page 11 - vii
C OMPLIANCES vii • Vous devez raccorder ce groupe à une sortie mise à la terre (mise à la masse) afin de respecter les normes internationales de sécurité. • Le coupleur d’appareil (le connecteur du groupe et non pas la prise murale) doit respecter une configuration qui permet un branchement sur une ...
Page 12 - viii
C OMPLIANCES viii Bitte unbedingt vor dem Einbauen des RPU die folgenden Sicherheitsanweisungen durchlesen: WARNUNG: Die Installation und der Ausbau des Geräts darf nur durch Fachpersonal erfolgen. • Diese Anleitung ist fr die Benutzung durch Netzwerkadministratoren vorgesehen, die fr die Installati...
Page 13 - ix; Warnings and Cautionary Messages
C OMPLIANCES ix Warnings and Cautionary Messages Warnings (in German) Stromkabel . Dies muss von dem Land, in dem es benutzt wird geprüft werden: Schweiz Dieser Stromstecker muß die SEV/ASE 1011Bestimmungen ein-halten. Europe Das Netzkabel muß vom Typ HO3VVF3GO.75 (Mindestan-forderung) sein und die ...
Page 14 - Environmental Statement; End of Product Life Span; Purpose
C OMPLIANCES x Environmental Statement The manufacturer of this product endeavours to sustain an environmentally-friendly policy throughout the entire production process. This is achieved though the following means:• Adherence to national legislation and regulations on environmental production stand...
Page 15 - xi; Safety Compliance; Warning: Fiber Optic Port Safety
C OMPLIANCES xi Safety Compliance Warning: Fiber Optic Port Safety Avertissment: Ports pour fibres optiques - sécurité sur le plan optique Warnhinweis: Faseroptikanschlüsse - Optische Sicherheit When using a fiber optic port, never look at the transmit laser while it is powered on. Also, never look ...
Page 16 - xii
Page 17 - ABLE
vii T ABLE OF C ONTENTS Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Features and Benefits . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Front Panel RJ-45 Ports . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ....
Page 19 - NTRODUCTION; Features and Benefits
F EATURES AND B ENEFITS 1 I NTRODUCTION The EZ Switch™ 10/100/1000, SMCGS16 and SMCGS24, are high-performance Gigabit Ethernet switches designed for delivering Gigabit connectivity to the desktop. They provide 16/24 full-duplex 1000BASE-T ports that significantly improve network performance and boos...
Page 20 - Front Panel RJ-45 Ports
I NTRODUCTION 2 Front Panel RJ-45 Ports The EZ Switch 10/100/1000 features 16/24 1000BASE-T ports with RJ-45 connectors located on the front panel of the switch. Because all ports support automatic MDI/MDI-X operation, you can use straight-through cables for all network connections to PCs or servers...
Page 21 - Rear Panel
R EAR P ANEL 3 SMCGS16 SMCGS24 Rear Panel The AC power connector is located on the rear panel of the switch.
Page 22 - NSTALLING; Package Contents
I NSTALLING THE S WITCH 4 I NSTALLING THE S WITCH Before installing the switch, verify that you have all the items listed under “Package Contents.” Note that the switch can be installed on any suitably large flat surface or in a standard EIA 19-inch rack. Package Contents The EZ Switch 10/100/1000 i...
Page 23 - Instructions
I NSTRUCTIONS 5 • There should be adequate space (approximately two inches) on all sides for proper air flow. • Make sure twisted-pair cable is always routed away from power lines, fluorescent lighting fixtures and other sources of electrical interference such as radios, transmitters, etc. • Make su...
Page 24 - Cascading Switches and Other Network Devices:
I NSTALLING THE S WITCH 6 Note: If an attached device does not support auto-negotiation, the data rate will be sensed automatically and the communication mode will default to half duplex. 4. Cascading Switches and Other Network Devices: All the ports on the switch support automatic MDI/MDI-X configu...
Page 25 - PPLICATION
I NSTRUCTIONS 7 A PPLICATION E XAMPLE A typical application for the SMCGS16 is illustrated below. EZ Switch 10/100/1000 SMCGS16 Server SMC-EZ109DT Workstations L A N 1 PWR WLAN WAN 2 3 Link Activity Notebook Internet Notebook withSMC2835WWireless PC Card SMC2804WBR WirelessBroadband Router Workstati...
Page 26 - ROUBLESHOOTING; Diagnosing Switch Indicators; Probable Causes; Possible Solutions; Possible Solutions
T ROUBLESHOOTING 8 T ROUBLESHOOTING Diagnosing Switch Indicators 1. Symptom Power LED does not light after power on. Probable Causes • AC power cord may be defective. Possible Solutions • Check for loose connections.• Check the power outlet by using it for another device.• Replace the AC power cord....
Page 27 - ABLES; Cable Specifications
C ABLE S PECIFICATIONS 9 C ABLES Cable Specifications 10BASE-T/100BASE-TX Pin Assignments Caution: DO NOT plug a phone jack connector into any RJ-45 port. Use only twisted-pair cables with RJ-45 connectors that conform with FCC standards. Use unshielded twisted-pair (UTP) or shielded twisted-pair (S...
Page 29 - 000BASE-T Cable Requirements; Cable Testing for Existing Category 5 Cable
1000BASE-T C ABLE R EQUIREMENTS 11 1000BASE-T Cable Requirements All Category 5 UTP cables that are used for 100BASE-TX connections should also work for 1000BASE-T, providing that all four wire pairs are connected. However, it is recommended that for all critical connections, or any new cable instal...
Page 30 - RODUCT
P RODUCT S PECIFICATIONS 12 P RODUCT S PECIFICATIONS EZ Switch 10/100/1000 Standards Conformance IEEE 802.3-2002Ethernet, Fast Ethernet, Gigabit EthernetFull-duplex flow control Communication Rate 10, 100, and 1000 Mbps Communication Mode Full or half duplex at 10/100 MbpsFull duplex at 1000 Mbps Me...
Page 31 - EZ S
EZ S WITCH 10/100/1000 13 Weight SMCGS16: 2.0 kg (4.04 lbs)SMCGS24: 2.2 kg (4.85 lbs) MAC Address Table 8 K entries Memory Buffer SMCGS16: 272 Kbits on-chip frame bufferSMCGS24: 400 Kbits on-chip frame buffer Power Consumption SMCGS16: 15.8 WattsSMCGS24: 24.2 Watts Heat Dissipation 130 BTU/hr maximu...
