Shure LX88-II - Manual - manualsarea.com

Page 2 - TABLE OF CONTENTS; II

TABLE OF CONTENTS ENGLISHSYSTEM CONTENTS 1 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . LX88- II RECEIVER FEATURES & CONTROLS 2 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . LX2 HANDHELD MICROPHONE-TRANSMITTER FEATURES ...

Page 3 - SYSTEM CONTENTS; System Combinations

CONGRATULATIONS! The LX88- II Wireless System is the finest in its class. This system will give you excellent performance for years to come. SYSTEM CONTENTS The LX88- II Wireless System contains the following components: • One LX88- II dual channel wireless receiver • Two transmitters available in o...

Page 4 - FIGURE 1; FRONT; Front; Volume Controllers. Controls the audio output level.; Back; –inch phone jack for each channel.; when the mixer or amplifier has only one audio input.; LX2 MICROPHONE–TRANSMITTER FEATURES & CONTROLS; FIGURE 2; from being picked up by the receiver; Battery Cover. Access to the battery and the audio gain control.

LX88- II Receiver Features & Controls (Figure 1) LX88- II DUAL CHANNEL RECEIVER FEATURES & CONTROLS FIGURE 1 FRONT BACK 2 5 7 6 9 8 3 4 1 2 3 4 1 7 6 Front 1. Power Indicators. 2. RF Signal Indicators. Yellow indicates when RF (radio frequency) signals are re-ceived from the transmitter. 3. ...

Page 5 - LX1 BODY-PACK TRANSMITTER FEATURES & CONTROLS; FIGURE 3; INSTALLING RUBBER FEET; FIGURE 4; table, with the feet working as anchors to prevent slipping.; FIGURE 5; INSTALLING RECEIVER IN A RACK; FIGURE 6

LX1 Body-Pack Transmitter Features & Controls (Figure 3) Á ÁÁÁÁ ÁÁÁÁ ÁÁÁÁ ÁÁÁÁ ÁÁÁÁ ÁÁÁÁ ÁÁÁÁ Á ÁÁÁ ÁÁÁ ÁÁÁ ÁÁÁ ÁÁÁ ÁÁÁ ÁÁÁ ÁÁÁ ÁÁÁ ÁÁÁ ÁÁÁ ÁÁÁ ÁÁÁ ÁÁÁ ÁÁÁ ÁÁÁ ÁÁÁ ÁÁÁ ÁÁÁ ÁÁÁ ÁÁÁÁ ÁÁÁÁ ÁÁÁÁ ÁÁÁÁ Á Á Á Á Á Á Á Á Á Á ÁÁÁ ÁÁÁ ÁÁÁ Á ÁÁÁ ÁÁÁ ÁÁÁ ÁÁÁ ÁÁÁÁ ÁÁÁÁ ÁÁÁÁ Á Á Á ÁÁÁ ÁÁÁ ÁÁÁ ÁÁÁ ÁÁÁ Á Á ÁÁÁÁ ...

Page 6 - INSTALLING THE HOLE PLUGS; FIGURE 7; CONNECTING THE POWER SUPPLY; Plug the ac adapter into an appropriate power outlet.; CONNECTING THE ANTENNAS; INSTALLING THE ANTENNAS; FIGURE 8; CONNECTING THE RECEIVER; CONNECTING SEPARATE CHANNELS; FIGURE 9; CONNECTING MIXED CHANNELS

4. If the antennas are to be remote mounted, insert the supplied plastic plugs into the holes on the front of the brackets (Figure 7). INSTALLING THE HOLE PLUGS FIGURE 7 Á ÁÁÁ ÁÁÁ ÁÁÁÁ ÁÁÁÁ ÁÁ ÁÁ ÁÁÁÁ ÁÁÁÁ NOTE: If you install the receiver in a rack mount, we recommend you frontmount or remote mount...

Page 7 - LX2 HAND-HELD MICROPHONE TRANSMITTER SETUP; part of the transmitter and unscrew the battery cover.; LX2 MICROPHONE-TRANSMITTER BATTERY INSTALLATION; Installing the Anti–Roll Device; ANTI-ROLL DEVICE INSTALLATION; Operating the LX2 Hand-Held Microphone Transmitters (Figure 13); Press the POWER switch on the LX88-; LX2 HAND–HELD MICROPHONE SYSTEM OPERATION; TRANSMITTERS

LX2 HAND-HELD MICROPHONE TRANSMITTER SETUP Battery Installation (Figure 11) 1. With the transmitter PWR ON/OFF switch in the OFF position, hold the upper part of the transmitter and unscrew the battery cover. ÁÁ Á Á Á Á ÁÁ Á Á ÁÁ Á LX2 MICROPHONE-TRANSMITTER BATTERY INSTALLATION FIGURE 11 Á Á Á Á Á ...

Page 8 - LX1 BODY-PACK TRANSMITTER CABLE CONNECTION

BODY-PACK TRANSMITTER SETUPLX1 Body-Pack Transmitter Battery Installation (Figure 14) Á Á Á Á Á Á Á Á Á Á Á Á Á Á Á Á Á Á Á Á ÁÁÁ ÁÁÁ -+ Á Á Á FIGURE 14 LX1 BODY–PACK TRANSMITTER BATTERY INSTALLATION Á Á Á Á Á Á Á Á Á Á Á Á Á Á Á Á Á Á Á Á Á Á Á Á Á Á Á Á Á Á Á Á ÁÁÁ ÁÁÁ Á Á Á Á Á Á Á Á Á Á Á Á Á Á ...

Page 9 - CHECKING THE TRANSMITTER BATTERY; Battery Life Indicators; Green; TRANSMITTER AUDIO GAIN ADJUSTMENT (FIGURE 17); TRANSMITTER AUDIO GAIN ADJUSTMENT

CHECKING THE TRANSMITTER BATTERY Battery Life Indicators Remaining Transmitter Operating Time* Green 6 to 20 hours Green and Amber 4 to 6 hours Amber 2 to 4 hours Red 1 hour or less * Estimated operating time assumes the use of a fresh 9 V alkaline battery (Duracell MN1604). NOTE: The above battery ...

Page 10 - Problem; SPECIFICATIONS

TIPS FOR GETTING THE BEST PERFORMANCE • Maintain a line-of-sight between the transmitter and receiver antennas. • Keep the receiver and antennas away from large metal objects. • Avoid placing the receiver near computers or other RF generating equipment. • Point the antennas straight up. • Avoid plac...

Page 11 - REPLACEMENT PARTS

FURNISHED ACCESSORIES Receiver Rack Mount Brackets 53A8425 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Hardware Kit 90TZ1371 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Swivel Adapter (hand-held only) WA370A . . . . . . . . . . . . . ...

Shure LX88-II - Manual

Table of Contents:

Summary

Other Shure Models