Shure BLX14/CVL - Manual - manualsarea.com

Page 3 - Caution; Consult your BLX Channel guide

For proper operation, set each transmitter to a different channel on the BLX88 receiver. Caution audio ready channel Diversity Antenna System PG4 audio ready group (A-Y) channel (0-9) BLX88 power audio ready group (A-Y) channel (0-9) Consult your BLX Channel guide to select compatible channel sets. ...

Page 7 - BLX; Features; Front Panel; power; English

1 BLX Features Front Panel ① audio LED Indicates strength of incoming audio signal: green for normal and red for overload. ② ready LED Green light indicates system is ready for use and receiving transmitter signal. ③ LED Display Displays group and channel setting. ④ group and channel Buttons Scan: P...

Page 8 - Back Panel; Button

2 BLX2 Back Panel ① DC Power Jack② Adapter Cord Tie-Off ③ XLR microphone output jack ( MIC out ) ④ 6.35 mm (1/4") instrument level output jack ( instrument out ) BLX1 ① LED Indicator Displays power and battery status (see Transmitter LED Indicators). ② power Switch Toggles power on or off. ③ 4-P...

Page 9 - Transmitter LED Indicators; Single System Set Up

3 Transmitter LED Indicators LED Indicator Status Green Ready Rapidly Flashing Red Controls locked Solid Red Battery power low (less than 1 hour remaining*) Flashing Red and shuts off Batteries dead (change batteries to power on transmitter) *For alkaline batteries only. For rechargeable batteries, ...

Page 10 - Multiple System Setup; Manually Setting Receiver Group and Channel

4 Multiple System Setup Up to 12 systems can operate simultaneously (band and RF environment dependent). Important: Set up each system one-at-a-time. Once a receiver and transmitter are tuned to the same group and channel, leave the transmitter powered on. Otherwise, scans from the other receivers w...

Page 11 - Correct Microphone Placement; Adjusting Gain; select

5 13 mm (.5 in.) Tips to Improve Wireless System Performance If you encounter interference or dropouts, try the following suggestions:• Choose a different receiver channel• Reposition the receiver so there is nothing obstructing a line of sight to the transmitter (including the audience)• Avoid plac...

Page 13 - Troubleshooting

7 Troubleshooting Issue Indicator Status Solution No sound or faint sound Receiver ready LED on • Verify all sound system connections or adjust gain as needed (see Adjusting Gain) • Verify that the receiver is connected to mixer/ amplifier Receiver ready LED off • Turn on transmitter • Make sure the...

Page 15 - Important Product Information; LICENSING INFORMATION; Certifications; Australia Warning for; Wireless

9 Important Product Information LICENSING INFORMATION Licensing: A ministerial license to operate this equipment may be required in certain areas. Consult your national authority for possible requirements. Changes or modifica- tions not expressly approved by Shure Incorporated could void your author...

Page 16 - RM N; RM N; PERU DECLARATION OF CONFORMITY

PERU DECLARATION OF CONFORMITY Shure Incorporated 5800 W. Touhy Avenue Niles, Illinois 60714-4608, U.S.A. (847) 600-2000 Shure Incorporated declares that the following product Model: BLX1-H8E (518 – 542 MHz) BLX1-K3E (606 – 630 MHz) Description: UHF FM Wireless Microphone Transmitter Has been tested...

Shure BLX14/CVL - Manual

Table of Contents:

Summary

Other Shure Models