Shop Fox W1780 - Manual

Model W1780 1 1 ⁄ 4 " Brad Nailer -5- Compressed Air System Exceeding the maximum permissible operating pressure may damage the nailer and cause it to malfunction. To protect yourself from personal injury, DO NOT allow the air pressure to exceed the recommended pressure for this nailer! The Mode...

Model W1780 1 1 ⁄ 4 " Brad Nailer -6- SETUP Inventory This brad nailer has been carefully packaged for safe transportation. If you notice the machine has been damaged during shipping, please contact your authorized Shop Fox dealer immediately. Unpacking The following is a description of the main...

Model W1780 1 1 ⁄ 4 " Brad Nailer -7- A safety mechanism on the nose of the nailer protects against accidental firing. When the trigger is pressed, the nailer will not fire until the safety nose mechanism is depressed. Before you use your nailer for the first time, check the safety nose mechanis...

Model W1780 1 1 ⁄ 4 " Brad Nailer -8- OPERATIONS Loading When replacing nails in your Model W1780, follow these guidelines: Gauge: ........................................ 18Length: ............................... 3 ⁄ 8 "–1 1 ⁄ 4 " Capacity: ................................... 100 To loa...

Model W1780 1 1 ⁄ 4 " Brad Nailer -9- 5. Pull the trigger. — If the nail drove into the wood far enough, continue with your intended operations. — If the nail either went too far or not far enough, then go to the Adjusting Depth section on this page. 3. Depress the safety nose mechanism against ...

Model W1780 1 1 ⁄ 4 " Brad Nailer -10- A jammed nail must be cleared before using the nailer again. To clear a jammed nail from the dis-charge area, do these steps: 1. DISCONNECT NAILER FROM THE AIR SUPPLY! 2. Pull back and latch the magazine pusher. 3. Remove the nail stick from the magazine. 4...

Model W1780 1 1 ⁄ 4 " Brad Nailer -12- CLEANING & LUBRICATION Cleaning Use a good solvent to clean the nose assembly of the nailer. Always be sure that the nailer is dry before using it again. Do not allow dust, chips, sand, etc. into the air connectors or into the body of the nailer; this m...

Model W1780 1 1 ⁄ 4 " Brad Nailer -15- Troubleshooting Symptom Possible Cause Possible Solution Air leaking at trigger valve area. 1. O-rings in trigger valve housing are damaged. 1. O-rings must be replaced & operation of safety nose must be checked. Air leaking between housing and hose 1. ...

CUT ALONG DOTTED LINE Name ___________________________________________________________________________________Street __________________________________________________________________________________City _________________________ State ___________________________ Zip ________________________Phone # ...