Shop Fox W1777 - Manual

Model W1777 2 1 ⁄ 2 " 16 Gauge Finish Nailer -5- The Model W1777 is designed to be operated at 60-100 PSI using clean, dry, regulated, compressed air. Do not exceed the 120 PSI maximum operating pressure for your model. Before using your nailer, regulate the air pressure to find the optimum sett...

Model W1777 2 1 ⁄ 2 " 16 Gauge Finish Nailer -6- SETUP Inventory This finish nailer has been carefully packaged for safe transportation. If you notice the tool has been damaged during shipping, please contact your authorized Shop Fox dealer immediately. Unpacking The following is a description o...

Model W1777 2 1 ⁄ 2 " 16 Gauge Finish Nailer -7- A safety mechanism on the nose of the nailer protects against accidental firing. When the trigger is pressed, the nailer will not fire until the safety nose mechanism is depressed. Before you use your nailer for the first time, check the safety no...

Model W1777 2 1 ⁄ 2 " 16 Gauge Finish Nailer -8- OPERATIONS Loading When replacing nails in your Model W1777, follow these guidelines: Gauge: ........................................ 16Length: ..............................1 1 ⁄ 4 "–2 1 ⁄ 2 " Capacity: ......................................

Model W1777 2 1 ⁄ 2 " 16 Gauge Finish Nailer -9- 5. Pull the trigger. — If the nail drove into the wood far enough, continue with your intended operations. — If the nail either went too far or not far enough, then go to the Adjusting Depth subsection on this page. 3. Depress the safety nose mech...

Model W1777 2 1 ⁄ 2 " 16 Gauge Finish Nailer -10- A jammed nail must be cleared before using the nailer again. To clear a jammed nail from the dis-charge area, do these steps: 1. DISCONNECT NAILER FROM THE AIR SUPPLY! 2. Pull back and latch the magazine pusher. 3. Remove the nail stick from the ...

Model W1777 2 1 ⁄ 2 " 16 Gauge Finish Nailer -12- CLEANING & LUBRICATION Cleaning Use a good solvent to clean the nose assembly of the nailer. Always be sure that the nailer is dry before using it again. Do not allow dust, chips, sand, etc. into the air connectors or into the body of the nai...

Model W1777 2 1 ⁄ 2 " 16 Gauge Finish Nailer -15- Troubleshooting Symptom Possible Cause Possible Solution Air leaking at trigger valve area. 1. O-rings in trigger valve housing are damaged. 1. O-rings must be replaced & operation of safety nose must be checked. Air leaking between housing a...

CUT ALONG DOTTED LINE Name ___________________________________________________________________________________Street __________________________________________________________________________________City _________________________ State ___________________________ Zip ________________________Phone # ...