Shop Fox d4327/d4328 - Manual
Shop Fox d4327/d4328 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Introduction
Your new Model D4327/D4328 Quick Release Wood Vise
(
Figure 1
) is designed to fit on workbenches 2
1
⁄
4
" and
thicker, but can be adapted to workbenches down to 1
1
⁄
2
"
thick by using a shim. Holes are pre-drilled in the jaw
faces to attach aftermarket or shop-built wood clamping
vise jaw pads.
D4327 Specifications
• Jaw Width .................................................7"
• Mounting Height (Workbench Thickness) ..........2
1
⁄
4
"
• Maximum Jaw Opening ..................................8"
• Weight ................................................ 21 lbs.
D4328 Specifications
• Jaw Width .................................................9"
• Mounting Height (Workbench Thickness) ..........2
1
⁄
4
"
• Maximum Jaw Opening ................................ 10"
• Weight ................................................ 25 lbs.
Installation
1.
Have another person hold the vise up against the
workbench in the desired mounting location. If the
workbench has holes for bench dogs, make sure the
bench dog on the vise is aligned with those holes.
Note:
If the workbench is less than 2
1
⁄
4
" thick, use a
piece of scrap wood (
Figure 2
) between the vise and
workbench as a shim. Cut the shim to the necessary
thickness so the vise does not protrude above the
workbench after mounting.
2.
Pencil mark the workbench through the mounting
holes to establish locations to drill pilot holes.
3.
Use a
1
⁄
8
" drill bit to drill pilot holes approximately
1
1
⁄
2
" deep in the face of the workbench, where the
wood screws will be used (see
Figure 3
).
Model D4327/D4328
Quick Release Wood Vise
Instruction Sheet
Phone #: (360) 734-3482 • Online Tech Support: [email protected] • Web: www.shopfox.biz
Figure 3
. Mounting hole locations.
Mounting Holes
for Wood
Screws
Mounting
Holes for Lag
Screws
Vise
Workbench
Shim
Figure 2
. Shim placed between workbench
and vise for workbenches under 2
1
⁄
4
".
Figure 1.
Quick release wood vise.
COPYRIGHT © MARCH, 2012 BY WOODSTOCK INTERNATIONAL, INC.
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE OR FORM WITHOUT
THE WRITTEN APPROVAL OF WOODSTOCK INTERNATIONAL, INC.
Printed in China
#14922ST
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
