Sherwood RD-6108 - Manual
Sherwood RD-6108 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Introduction; Congratulations on Your Purchase!; CAUTION; Caution : Do not block ventilation openings or stack; ENGLISH; UNPACKING AND INSTALLATION
- Page 3 – READ THIS BEFORE OPERATING YOUR UNIT; AC VOLTAGE SELECTION; AC voltage selector switch; FOR YOUR SAFETY
- Page 4 – CONTENTS
- Page 5 – System Connections; CONNECTING ANTENNAS; CONNECTING AUDIO/VIDEO COMPONENTS; • The VIDEO 2 jacks may also be connected to an; B C; CONNECTING 6 CH DIRECT INPUTS; •Use these jacks to connect the corresponding analog; CH decoder; outdoor FM antenna may be used to further improve the reception.
- Page 6 – CONNECTING DIGITAL INPUTS; SUBWOOFER PRE OUT connection; AC INPUT CORD
- Page 7 – Front Panel Controls; • The VIDEO 3 jacks may be also connected to an
- Page 8 – Remote Controls
- Page 9 – LOADING BATTERIES; Use the remote control unit within a range of about
- Page 10 – LISTENING TO A PROGRAM SOURCE; Operations; Before operation; TAPE MONITOR function; or
- Page 11 – To listen with the headphones.
- Page 13 – SURROUND SOUND; • Dolby Pro Logic ll MOVIE; • The following modes apply conventional 2-channel; Surround modes
- Page 14 – Front speakers: Place each front speaker about 1m (40; Delay time
- Page 15 – ENJOYING SURROUND SOUND; Adjusting the Dolby Pro Logic II parameters
- Page 16 – Adjusting the speaker settings; If so, the filter set previously is automatically changed to OFF.; Checking the speaker setting
- Page 17 – Adjusting each channel level; Front Left
- Page 18 – NARROW: Relatively long distance from the; Rear delay time : 0 ms; Downmixing into 2 front channels; Adjust the delay time.
- Page 19 – LISTENING TO RADIO BROADCASTS; Presetting radio stations; ) button repeatedly until; Manual tuning; Select the tuning mode.
- Page 20 – Then “PRESET” lights up.; MEMORY BACKUP FUNCTION; Note : If the electricity fails or the AC input cord is; Scanning preset stations in sequence
- Page 21 – RECORDING; Recording with TAPE MONITOR; input can be heard but cannot be recorded.
- Page 22 – Compressing the dynamic range (Dolby Digital sources only); OTHER FUNCTIONS
- Page 23 – Troubleshooting Guide; PROBLEM
- Page 24 – Specifications
- Page 25 – A U D I O / V I D E O R E C E I V E R; O P E R A T I N G I N S T R U C T I O N S
REMOTE
SENSOR
MASTER VOLUME
TONE
DIRECT
ON/STANDBY
MAIN POWER
STANDBY
ON/
OFF
TUNING/PRESET
ADJUST
PHONES
CHANNEL
SELECTOR
VIDEO
L - AUDIO - R
VIDEO 3
BAND
FM MODE
T/P MODE
TONE MODE
SPEAKER
MODE
DYNAMIC
RANGE
MEMO/ENTER
CINEMA EQ
ON/OFF
SPEAKER
I N P U T S E L E C T O R
AUDIO
VIDEO
TAPE MON.
6CH DIRECT
DSP MODE
AUTO
STEREO
DIGITAL
INPUTS
TONE
DIRECT
S U R R O U N D M O D E
ST TUNED
TAPE M
PRESET
Pro Logic
DIGITAL
DTS
THEATER
HALL
SLEEP
dB
kHz
MHz
MEM
ms
A U D I O / V I D E O R E C E I V E R R D - 6 1 0 8
RD-6108
AUDIO/VIDEO RECEIVER
O P E R A T I N G I N S T R U C T I O N S
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 Introduction Congratulations on Your Purchase! Your new high fidelity receiver is designed to delivermaximum enjoyment and years of trouble free service.Please take a few moments to read this manualthoroughly. It will explain the features and operation ofyour unit and help ensure a trouble free in...
FOR U.S.A AND CANADA ..............................120 V Units shipped to the U.S.A and Canada are designedfor operation on 120 V AC only. Safety precaution with use of a polarized AC plug.However, some products may be supplied with anonpolarized plug. CAUTION : To prevent electric shock, match wide...
4 CONTENTS Introduction UNPACKING AND INSTALLATION ....................................................................................................... 2 READ THIS BEFORE OPERATING YOUR UNIT................................................................................... 3 System Connections .....
