Page 3 - Contents
1 Contents Important safety instructions ............................................. 2 MX W1 digital wireless earphone system ......................... 4 Delivery includes .................................................................... 4 Product overview .........................................
Page 4 - Important safety instructions; Intended use of the devices
2 Important safety instructions The MX W1 has been manufactured according to the accepted rulesof safety and current technology. However, there is still a danger ofdamage to equipment if the following general safety instructionsare not complied with.• Please read these instructions for use carefully...
Page 5 - Safety instructions for Lithium-Ion rechargeable batteries
3 Safety instructions for Lithium-Ion rechargeable batteries If abused or misused, rechargeable batteries may leak. In extremecases, they may even present a Please understand that Sennheiser does not accept liability fordamage arising from abuse or misuse. • heat hazard • fire hazard • explosion haz...
Page 6 - MX W1 digital wireless earphone system; Enjoy your new MX W1!; Delivery includes
4 MX W1 digital wireless earphone system Thank you for purchasing MX W1 - Sennheiser's completelydigital wireless earphone system. We trust that you will enjoyusing it and that it will satisfy your expectations. The MX W1 is simple to operate. These instructions for use havebeen designed to help you...
Page 7 - Product overview; Earphones
5 Product overview Earphones Transmitter Twist-to-fit pad Speaker LED (orange/blue) Operation/pairing button of the earphone 2.5 mm charging jack Battery compartment Operation/pairing button of the transmitter Reset button LED (orange/blue) 2.5 mm charging jack Connecting cable with 3.5 mm stereo ja...
Page 8 - Docking station; LED indications of the devices; Putting the MX W1 into operation; Charging the MX W1; or
6 Docking station LED indications of the devices Putting the MX W1 into operation Charging the MX W1 Charge the rechargeable batteries of all MX W1 devices for3 hours before first use.When the battery is almost flat, the LED , or flashes orange. You then have to charge the device. Charging compartme...
Page 13 - ON
11 Note: The distance between transmitter and earphones should notexceed 1 m during association. Associating the earphones to Kleer compatible devices MX W1 is fully compatible to Kleer wireless standard. For pairingthe MX W1 with other Kleer compatible devices, please refer tothe preceding chapter ...
Page 14 - Setting up your MX W1 for usage; Fixing the transmitter to your audio device
12 Setting up your MX W1 for usage Fixing the transmitter to your audio device Fix the transmitter with the help of:• the fabric strap• or one of the rubber bands (see illustration). Connecting the transmitter to your audio device You can connect the transmitter to anMP3 player or any audio device w...
Page 15 - M L
13 Adjusting the earphones to your ears Sennheiser’s twist-to-fit system and comfortable earpads allowfor the best custom fit enabling you to enjoy seamless highfidelity stereo sound. The perceived sound quality of theearphones depends to a large extent on a correct fit. For bestsound enjoyment, ple...
Page 16 - Using the MX W1; Switching the earphones on/off; earphones
14 Using the MX W1 To switch the system on, proceed as follows:1. Switch your audio device on.2. Switch the earphones on (see following chapter).3. Switch the transmitter on (see page 15).4. Put the earphones on (see page 16). You will hear the sound from your sound source. Switching the earphones o...
Page 17 - Switching the transmitter on/off; transmitter
15 Note: – When you insert the earphones into the docking station, the earphones automatically switch off. – If there is no transmitter in enrollment mode for at least 5 minutes, the earphones automatically switch off. Switching the transmitter on/off To switch the transmitter off : 왘 Press and hold...
Page 18 - Putting on the earphones; Check the
16 Putting on the earphones 왘 Check the R (right) an L (left) marks on the earphones to identify them and put on the earphones as shown in theillustration above. Danger of hearing damage! Listening at high volume levels for long periodscan lead to permanent hearing defects.Sennheiser earphones also ...
Page 19 - Care and maintenance; Cleaning the devices
17 Care and maintenance Cleaning the devices For reasons of hygiene, clean your Sennheiser productsregularly. 왘 Before cleaning, disconnect the devices from the mains. 왘 Only use a slightly damp cloth to clean the devices. Changing the twist-to-fit pads/earpads/rubber rings For reasons of hygiene, t...
Page 22 - Troubleshooting; Problem
20 Troubleshooting Problem Possible cause Possible solution No operationindication Battery is flat Recharge the battery (see page 6, page 17) No sound Jack plug connection is incorrect Check the connection to your audio device (see page 12) Transmitter or earphones are switched off Switch the device...
Page 24 - Accessories and spare parts
22 Accessories and spare parts The following accessories are available from your authorized Sennheiser dealer: Cat. No. Accessory/Spare part 525766 Carrying case 525767 MX W1-C docking station 525768 MX W1-T transmitter 525769 Transmitter straps: 1 elastic fabric strap, 4 rubber bands (2 x S/2 x L) ...
Page 25 - Specifications; System
23 Specifications System Transmitter Earphones Modulation MSK Digital Carrier frequencies 2.4 – 2.48 GHz Range approx. 10 m in open area Power supply unit withcountry adaptors Input: 100 – 240 V AC, 50/60 Hz, Output: 5 V DC/0.5 A (x 2) Operating temperature 0 – 40 °C Audio connection 3.5 mm stereo j...
Page 26 - Manufacturer declarations; Warranty; Declaration of Conformity
24 Docking station “kleer” wireless technology Manufacturer declarations Warranty 2 years Declaration of Conformity This equipment is in compliance with the essential requirements andother relevant provisions of Directives:• R&TTE directive (1999/5/EC) • EMC Directive (2004/108/EC) • Low Voltage...
Page 27 - Statements regarding FCC and industry Canada
25 Statements regarding FCC and industry Canada This device complies with Part 15 of the FCC Rules and with RSS-210 ofIndustry Canada. Operation is subject to the following two conditions:(1) this device may not cause harmful interference, and (2) this devicemust accept any interference received, in...
Page 28 - Meet the requirements for:
26 Meet the requirements for: USA: FCC ID: DMOMXW1TDMOMXW1R Canada: IC: 2099A-MXW1T2099A-MXW1R Europe: Australia & New Zealand: Singapore: Russia: Complies with IDA Standards DB100582
Page 29 - Printed in China
Sennheiser Consumer Electronics GmbH (Singapore Branch)96 Robinson Road, #16-01/04, Singapore 068899Phone: +65 64116911Fax: +65 64380476 Sennheiser electronic GmbH & Co. KG (EU Representative)Am Labor 1, 30900 Wedemark, GermanyPhone: +49 (5130) 600 0 Printed in China Fax: +49 (5130) 600 300 Publ...
