Sears 200.71234- User Manual

Page 2 - Warranty; Table Of Contents

1 Warranty .................................................................... 1 Important Safety Instructions ................................. 2 Parts .......................................................................... 3 Wiring Diagram .........................................................

Page 3 - Important Safety Instructions; WARNING

2 Help us help you Remember: • Place charger as far away from battery being charged as the charger cables will permit. • Do not expose charger to rain or snow. • Never charge a frozen battery. If battery fluid (electrolyte) becomes frozen, bring battery into awarm area to thaw before you begin charg...

Page 4 - Parts; Wiring Diagram

3 Parts This section shows an illustration of your battery charger. Use it to become familiar with where all the parts arelocated, and what they look like. Wiring Diagram Replacement Parts List DieHard 71234 ITEM DESCRIPTION PART NUMBER 1 Plastic Top 3799004100 2 Rocker Switch SPST 0499000050 3 Rock...

Page 5 - Before Using Your Battery Charger; Assembling your charger

4 Attach Foot: Remove charger from packing materials and placecharger on its side. Attach mounting foot and securewith the two, 1/4-20 thread cutting screws provided. continued on next page Before Using Your Battery Charger It is important to prepare your charger for use. This section will tell you ...

Page 6 - Plugging it in

5 Axle Assembly (continued): Place the charger on its side. Place one end of eachbracket into slot, then place the axle assembly undereach bracket. Fasten the other side of each bracketusing the two, 10-32 thread cutting screws provided. Handle: Turn the charger right side up onto its foot and wheel...

Page 7 - Preparing your battery to be charged

6 MINIMUM RECOMMENDED EXTENSION CORD Length of Cord, in Feet 25 50 100 150 AWG* Size of Cord 14 12 10 8 *AWG=American Wire Gauge Preparing your battery to be charged It is important that you read and follow these guide-lines while you are preparing to charge your battery. • Make sure that you have a...

Page 8 - Using Your Battery Charger; Setting the controls

7 For best results from your battery charger, learn to use it properly. This section tells how to set the controls,charge a battery in or out of the vehicle, use the ENGINE START feature and test the battery. Using Your Battery Charger All the controls for your charger are located on thefront. Follo...

Page 10 - Charging Your Battery

9 Charging Your Battery NOTE: A marine (boat) boat battery must be removed and charged on shore. To charge it on board requiresequipment specially designed for marine use. Charging your battery in the vehicle: 1. Arrange the power cord and charging leadscarefully in order to avoid damage that could ...

Page 12 - Calculating charge times

11 Calculating charge times • Marine, or deep-cycle batteries are usually rated in Reserve Capacity (RC) . • NR means that the charger setting is NOT RECOM- MENDED . Find your battery’s rating on the chart below and notethe charge time given for each charger setting. Thetimes given are for batteries...

Page 14 - Troubleshooting

13 Troubleshooting Performance problems often result from little things that you can fix yourself. Please read through this table for apossible solution if a problem occurs. PROBLEM POSSIBLE CAUSE SOLUTION/REASONS No reading on the Clamps are not making a Check for poor connections at battery and fr...

Sears 200.71234- User Manual

Table of Contents:

Summary

Other Sears Models