Sears 200.71231- User Manual

Page 2 - Table Of Contents

1 Warranty .................................................................... 1 Important Safety Instructions ................................. 2 Parts .......................................................................... 3 Before Using Your Battery Charger ........................ 4 Assembli...

Page 3 - Important Safety Instructions; WARNING

2 Help us help you Remember: • Place charger as far away from battery being charged as the charger cables will permit. • Do not expose charger to rain or snow. • Never charge a frozen battery. If battery fluid (electrolyte) becomes frozen, bring battery into awarm area to thaw before you begin charg...

Page 4 - Parts; Wiring Diagram

3 Parts This section shows an illustration of your battery charger. Use it to become familiar with where all the parts arelocated, and what they look like. Replacement Parts List DieHard 71230 Wiring Diagram Item Description Part Number 1. Handle 3599000286 2. Negative (BLK) Cable w/Clamps 389900039...

Page 5 - Before Using Your Battery Charger; Assembling your charger

4 To attach the axle assembly: 1. Remove charger from packing materials and placeupside down on a flat surface. Attach mountingfoot and secure with the two 1/4-20 thread cuttingscrews. 2. Hold axle upright on floor or work surface. Then,using a hammer, tap one of the plastic hubs ontothe top end of ...

Page 6 - Plugging it in

5 3. Place the charger on its side. Place one end ofeach bracket into slot, then place the axle assem-bly under each bracket. Fasten the other side ofthe brackets using the two 10-32 screws provided. To attach the handle: Turn the charger right side up onto its foot and wheels.Remove the two top scr...

Page 7 - Preparing your battery to be charged

6 A TEMPORARY adapter may be used to connect the charger to a two-pole outlet if a properly groundedoutlet is not available. Use the adapter ONLY until a properly grounded outlet can be installed by a qualifiedelectrician. MINIMUM RECOMMENDED EXTENSION CORD Length of Cord, in Feet 25 50 100 150 AWG*...

Page 8 - Using Your Battery Charger; Setting the controls

7 To obtain the best results from your battery charger, you must know how to use it properly. This section tells howto set the controls and how to charge a battery in and out of the vehicle. Using Your Battery Charger OFF 40A 12V CHARGE 2A 12V CHARGE 200A 12V ENGINE START All the controls for your c...

Page 9 - Charging Your Battery

8 Charging Your Battery Charging your battery in the vehicle: 1. Arrange the power cord and charging leadscarefully in order to avoid damage that could becaused by the hood, door, or moving engine parts. 2. Keep clear of the fan blades, belts, pulleys, andother parts that can cause injury. 3. Check ...

Page 11 - Calculating charge times

10 2 AMP 2 - 4 4 - 10 11 - 14 14 -18 18 - 35 18 27 30 33 Calculating charge times • Marine, or deep-cycle batteries are usually rated in Reserve Capacity (RC) . • NR means that the charger setting is NOT RECOM- MENDED. Find your battery’s rating on the chart below and notethe charge time given for e...

Page 13 - Troubleshooting

12 Troubleshooting Performance problems often result from little things that you can fix yourself. Please read through this table for apossible solution if a problem occurs. PROBLEM POSSIBLE CAUSE SOLUTION/REASONS No reading on the Clamps are not making a Check for poor connections to battery and fr...

Sears 200.71231- User Manual

Table of Contents:

Summary

Other Sears Models