Page 2 - © 2013 Seagate Technology LLC. All rights reserved.; Document Revision History; Revision
© 2013 Seagate Technology LLC. All rights reserved. Publication number: 100716628, Rev. D June 2013 Seagate, Seagate Technology and the Wave logo are registered trademarks of Seagate Technology LLC in the United States and/or other countries. Momentus and SeaTools are either trademarks or registered...
Page 3 - SSHD SATA P; ONTENTS; ATA I
S EAGATE L APTOP T HIN SSHD SATA P RODUCT M ANUAL , R EV . D III C ONTENTS S EAGATE T ECHNOLOGY S UPPORT S ERVICES . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 1.0 I NTRODUCTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ....
Page 4 - IGURES; SATA C
S EAGATE L APTOP T HIN SSHD SATA P RODUCT M ANUAL , R EV . D IV F IGURES F IGURE 1 T YPICAL 5V S TARTUP AND O PERATION C URRENT P ROFILE . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 F IGURE 2 A TTACHING SATA C ABLING . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...
Page 5 - Seagate Technology Support Services
Seagate Laptop Thin SSHD SATA Product Manual, Rev. D 1 For information regarding online support and services, visit http://www.seagate.com/about/contact-us/technical-support/ Available services include: • Presales & Technical support • Global Support Services telephone numbers & business hou...
Page 6 - NTRODUCTION; About FIPS; Standard models
S EAGATE L APTOP T HIN SSHD SATA P RODUCT M ANUAL , R EV . D 2 1.0 I NTRODUCTION This manual describes the functional, mechanical and interface specifications for the following Seagate Seagate ® Laptop Thin SSHD model drives: For more information on FIPS 140-2 Level 2 certification About FIPS on pag...
Page 7 - NTERFACE
S EAGATE L APTOP T HIN SSHD SATA P RODUCT M ANUAL , R EV . D 3 1.1 A BOUT THE S ERIAL ATA I NTERFACE The Serial ATA interface provides several advantages over the traditional (parallel) ATA interface. The primary advantages include: Easy installation and configuration with true plug-and-play conne...
Page 8 - the drive; Table 1
S EAGATE L APTOP T HIN SSHD SATA P RODUCT M ANUAL , R EV . D 4 D RIVE S PECIFICATIONS 2.0 D RIVE S PECIFICATIONS Unless otherwise noted, all specifications are measured under ambient conditions, at 25°C, and nominal power. For convenience, the phrases the drive and this drive are used throughout thi...
Page 9 - LBA mode; Configuring and Mounting the Drive; HYSICAL ORGANIZATION; Drive model
S EAGATE L APTOP T HIN SSHD SATA P RODUCT M ANUAL , R EV . D 5 D RIVE S PECIFICATIONS 2.1 F ORMATTED C APACITY F ORMATTED C APACITY (1) 1. One GB equals one billion bytes when referring to hard drive capacity. Accessible capacity may vary depending on operating environment and formatting. G UARANTEE...
Page 10 - All models; Table 2; Read
S EAGATE L APTOP T HIN SSHD SATA P RODUCT M ANUAL , R EV . D 6 D RIVE S PECIFICATIONS 2.3 R ECORDING AND I NTERFACE T ECHNOLOGY Recording method Perpendicular Recording density 1894 Kb/in Track density 375 ktracks/in avg Areal density 705 Gb/in 2 avg Spindle speed 5400 RPM +/- 0.2% Sustained data tr...
Page 11 - Table 3; Typical; TBD; Figure 2; Power requirements for the drives are listed in the table in; Table 4; . Typical power measurements are based on an average
S EAGATE L APTOP T HIN SSHD SATA P RODUCT M ANUAL , R EV . D 7 D RIVE S PECIFICATIONS 2.6 S TART / STOP TIMES Table 3 Start/stop times Typical seek times (ms) Typical Max @ 25 ° C Power-on to ready (sec) <1.0 <1.0 Power-on to ready (sec) (SED models) TBD TBD Standby to ready (sec) <1.0 <...
Page 12 - Typical current profiles; The typical 5V startup and operation current profile is shown in; Figure 1; Figure 1 Typical 5V Startup and Operation Current Profile; Seek average
S EAGATE L APTOP T HIN SSHD SATA P RODUCT M ANUAL , R EV . D 8 D RIVE S PECIFICATIONS 2.7.1.1 Typical current profiles The typical 5V startup and operation current profile is shown in Figure 1 . Figure 1 Typical 5V Startup and Operation Current Profile Table 4 DC Power Requirements P OWER D ISSIPATI...
Page 13 - drive buffer is enabled, the
S EAGATE L APTOP T HIN SSHD SATA P RODUCT M ANUAL , R EV . D 9 D RIVE S PECIFICATIONS 2.7.2 Conducted noise Input noise ripple is measured at the host system power supply across an equivalent 15-ohm resistive load on the +5 volt line. Using 5-volt power, the drive is expected to operate with a max...
Page 14 - Shock; Table 5: Environmental specifications
S EAGATE L APTOP T HIN SSHD SATA P RODUCT M ANUAL , R EV . D 10 D RIVE S PECIFICATIONS 2.8 E NVIRONMENTAL S PECIFICATIONS This section provides the temperature, humidity, shock, and vibration specifications for Seagate Laptop Thin SSHD drives. Ambient temperature is defined as the temperature of the...
Page 15 - Nonoperating vibration; COUSTICS; Table 7; Table 6
S EAGATE L APTOP T HIN SSHD SATA P RODUCT M ANUAL , R EV . D 11 D RIVE S PECIFICATIONS 2.8.2.2 Nonoperating vibration The maximum nonoperating vibration levels that the drive may experience without incurring physical damage or degradation in performance when subsequently put into operation are speci...
Page 16 - Korean RRL; Trade name or applicant:
S EAGATE L APTOP T HIN SSHD SATA P RODUCT M ANUAL , R EV . D 12 D RIVE S PECIFICATIONS 2.11 R ELIABILITY Nonrecoverable read errors 1 per 10 15 bits read, max Load/Unload (U/UL) 25°C, 50% relative humidity 600,000 software-controlled power on/off cycles 20,000 hard power on/off cycles Warranty To de...
Page 17 - Radio and television interference; How to Identify and Resolve
S EAGATE L APTOP T HIN SSHD SATA P RODUCT M ANUAL , R EV . D 13 D RIVE S PECIFICATIONS 2.12.3 FCC verification These drives are intended to be contained solely within a personal computer or similar enclosure (not attached as an external device). As such, each drive is considered to be a subassembly ...
Page 19 - ONFIGURING AND; Serial ATA Cables and Connectors; Table 8; for connector pin definitions.; Figure 2 Attaching SATA Cabling; CAUTION; drive’s exposure to ESD.
S EAGATE L APTOP T HIN SSHD SATA P RODUCT M ANUAL , R EV . D 15 3.0 C ONFIGURING AND M OUNTING THE D RIVE This section contains the specifications and instructions for configuring and mounting the drive. 3.1 H ANDLING AND S TATIC -D ISCHARGE P RECAUTIONS After unpacking, and before installation, the...
Page 20 - Figure 3; Figure 3 Mounting Dimensions (for standard models); Top cover stiffness/deflection; For reference only. May not represent actual drive.
S EAGATE L APTOP T HIN SSHD SATA P RODUCT M ANUAL , R EV . D 16 C ONFIGURING AND M OUNTING THE D RIVE 3.3 D RIVE M OUNTING You can mount the drive in any orientation using four screws in the side-mounting holes or four screws in the bottom-mounting holes. Refer to Figure 3 for drive mounting dimensi...
Page 22 - BOUT; FIPS; Figure 5 Example of FIPS tamper evidence labels.
S EAGATE L APTOP T HIN SSHD SATA P RODUCT M ANUAL , R EV . D 18 A BOUT FIPS 4.0 A BOUT FIPS The Federal Information Processing Standard (FIPS) Publication 140-2, FIPS PUB 140-2, is a U.S. government computer security standard used to accredit cryptographic modules. It is titled “Security Requirement...
Page 23 - ERIAL; Serial ATA: High Speed Serialized AT Attachment
S EAGATE L APTOP T HIN SSHD SATA P RODUCT M ANUAL , R EV . D 19 S ERIAL ATA (SATA) I NTERFACE 5.0 S ERIAL ATA (SATA) I NTERFACE These drives use the industry-standard Serial ATA interface that supports FIS data transfers. It supports ATA programmed input/output (PIO) modes 0–4; multiword DMA modes 0...
Page 24 - ATA D; All used voltage pins (V; Power
S EAGATE L APTOP T HIN SSHD SATA P RODUCT M ANUAL , R EV . D 20 S ERIAL ATA (SATA) I NTERFACE 5.2 S ERIAL ATA D EVICE P LUG C ONNECTOR P IN D EFINITIONS Table 8 summarizes the signals on the Serial ATA interface and power connectors. Refer to the Notes below. N OTES 1 All pins are in a single row, w...
Page 25 - ATA C; OMMANDS; the; Table 9; ATA-standard commands names
S EAGATE L APTOP T HIN SSHD SATA P RODUCT M ANUAL , R EV . D 21 S ERIAL ATA (SATA) I NTERFACE 5.3 S UPPORTED ATA C OMMANDS Table 9 lists Serial ATA standard commands that the drive supports. For a detailed description of the ATA commands, refer to the Serial ATA International Organization: Serial AT...
Page 26 - ATA-standard security commands
S EAGATE L APTOP T HIN SSHD SATA P RODUCT M ANUAL , R EV . D 22 S ERIAL ATA (SATA) I NTERFACE S.M.A.R.T. Enable Operations B0h/D8h S.M.A.R.T. Enable/Disable Auto Offline B0h/DBh S.M.A.R.T. Enable One Attribute Modification B0h/E0h S.M.A.R.T. Execute Offline B0h/D4h S.M.A.R.T. Free Fall Protection Ho...
Page 27 - Identify Device command; The Identify Device command (command code EC; Drive; on page 4 for default parameter settings.; Table 10 Identify Device command; Word; xxxx
S EAGATE L APTOP T HIN SSHD SATA P RODUCT M ANUAL , R EV . D 23 S ERIAL ATA (SATA) I NTERFACE 5.3.1 Identify Device command The Identify Device command (command code EC H ) transfers information about the drive to the host following power up. The data is organized as a single 512-byte block of data,...
Page 29 - Each drive will have a unique value.; Table 11 Bit Descriptions
S EAGATE L APTOP T HIN SSHD SATA P RODUCT M ANUAL , R EV . D 25 S ERIAL ATA (SATA) I NTERFACE 108-111 The mandatory value of the world wide name (WWN) for the drive. NOTE: This field is valid if word 84, bit 8 is set to 1 indicating 64-bit WWN support. Each drive will have a unique value. 112-118 AT...
Page 31 - Set Features command; Table 12 Set Features command values
S EAGATE L APTOP T HIN SSHD SATA P RODUCT M ANUAL , R EV . D 27 S ERIAL ATA (SATA) I NTERFACE 5.3.2 Set Features command This command controls the implementation of various features that the drive supports. When the drive receives this command, it sets BSY, checks the contents of the Features regist...
Page 33 - NDEX
S EAGATE L APTOP T HIN SSHD SATA P RODUCT M ANUAL , R EV . D 29 I NDEX A acoustics 11 active mode 9 Address 21 agency certification 12 ambient temperature 6 areal density 6 ATA commands 21 Australia/New Zealand Standard AS/NZS3548 1995 12 Australian Communication Authority (ACA) 12 Australian C-Tick...
Page 36 - Seagate Technology LLC
Seagate Technology LLC AMERICAS Seagate Technology LLC 10200 South De Anza Boulevard, Cupertino, California 95014, United States, 408-658-1000 ASIA/PACIFIC Seagate Singapore International Headquarters Pte. Ltd. 7000 Ang Mo Kio Avenue 5, Singapore 569877, 65-6485-3888EUROPE, MIDDLE EAST AND AFRICA Se...
