Page 2 - Revision history; Revision
Revision history Copyright © 2009 Seagate Technology LLC. All rights reserved. Printed in U.S.A.Publication number: 100560196, Rev. A March 2009Seagate, Seagate Technology and the Wave logo are registered trademarks of Seagate Technology LLC in the United States and/or other countries. Pipeline HD, ...
Page 3 - Pipeline HD Mini Series SATA Product Manual, Rev. A; Contents
Pipeline HD Mini Series SATA Product Manual, Rev. A i Contents 1.0 Introduction. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 1.1 About the Serial ATA interface . . . . . . . . . . . . . . . . . . . . . . . . . ...
Page 5 - List of Figures
Pipeline HD Mini Series SATA Product Manual, Rev. A iii List of Figures Figure 1. Typical +5V only startup and operation current profile . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 Figure 2. Attaching SATA cabling . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...
Page 7 - Introduction; Pipeline HD
Pipeline HD Mini Series SATA Product Manual, Rev. A 1 1.0 Introduction This manual describes the functional, mechanical and interface specifications for the following Seagate Pipeline HD ® Mini Series SATA model drives: • ST9250311CS• ST91603110CS These drives provide the following key features:• 5,...
Page 8 - About the Serial ATA interface; any jumpers or other configuration options.
2 Pipeline HD Mini Series SATA Product Manual, Rev. A 1.1 About the Serial ATA interface The Serial ATA interface provides several advantages over the traditional (parallel) ATA interface. The primary advantages include:• Easy installation and configuration with true plug-and-play connectivity. It i...
Page 9 - the drive; Specification summary table; Drive specifications
Pipeline HD Mini Series SATA Product Manual, Rev. A 3 2.0 Drive specifications Unless otherwise noted, all specifications are measured under ambient conditions, at 25°C, and nominal power. For convenience, the phrases the drive and this drive are used throughout this manual to indicate the Pipeline ...
Page 11 - Formatted capacity; Default logical geometry; LBA mode; Model
Pipeline HD Mini Series SATA Product Manual, Rev. A 5 2.2 Formatted capacity *One Gbyte equals one billion bytes when referring to hard drive capacity. Accessible capacity may vary depending on operating environment and formatting. 2.2.1 LBA mode When addressing these drives in LBA mode, all blocks ...
Page 12 - Physical organization; Drive model
6 Pipeline HD Mini Series SATA Product Manual, Rev. A 2.4 Physical organization 2.5 Recording and interface technology 2.6 Physical characteristics Drive model Read/write heads Number of discs ST9250311CS 2 1 ST91603110CS 2 1 Interface Serial ATA (SATA) Recording method Perpendicular Recording densi...
Page 13 - Seek time; Typical seek times; Read; Average latency; Time to ready
Pipeline HD Mini Series SATA Product Manual, Rev. A 7 2.7 Seek time Seek measurements are taken with nominal power at 25°C ambient temperature. All times are measured using drive diagnostics. The specifications in the table below are defined as follows:• Track-to-track seek time is an average of all...
Page 14 - Power specifications; Power dissipation; Seek
8 Pipeline HD Mini Series SATA Product Manual, Rev. A 2.9 Power specifications The drive receives DC power (+5V) through a native SATA power connector. 2.9.1 Power consumption Power requirements for the drives are listed in the table on page 8. Typical power measurements are based on an average of d...
Page 15 - Typical current profile; Figure 1. Typical +5V only startup and operation current profile; Conducted noise
Pipeline HD Mini Series SATA Product Manual, Rev. A 9 2.9.1.1 Typical current profile Figure 1. Typical +5V only startup and operation current profile 2.9.2 Conducted noise Input noise ripple is measured at the host system power supply across an equivalent 15-ohm resistive load on the +5 volt line. ...
Page 17 - Environmental specifications; Actual drive base plate temperature should not exceed
Pipeline HD Mini Series SATA Product Manual, Rev. A 11 2.10 Environmental specifications 2.10.1 Base plate temperature Actual drive base plate temperature should not exceed 70°C (158°F). Above 1,000 feet (305 meters), the maximum temperature is derated linearly by 1°C every 1000 feet. 2.10.2 Tempera...
Page 19 - Acoustics; Electromagnetic immunity; CE seek; Radio frequency environments; Test
Pipeline HD Mini Series SATA Product Manual, Rev. A 13 2.11 Acoustics Drive emission of sound is measured consistent with the ECMA-74 and its’ referenced standards. Testing is conducted at room temperature (approximately 25 ° C). Emission levels are reported as the total A-weighted sound power level...
Page 20 - Reliability; Measurement type; Nonrecoverable read errors
14 Pipeline HD Mini Series SATA Product Manual, Rev. A 2.13 Reliability Measurement type Specification Nonrecoverable read errors 1 per 10 14 bits read, max. Annualized Failure Rate (AFR) <0.55% Load/Unload (U/UL) 25°C, 50% relative humidity 32°C, 80% relative humidity 5°C, 80% relative humidity ...
Page 21 - Agency certification; Safety certification
Pipeline HD Mini Series SATA Product Manual, Rev. A 15 2.14 Agency certification 2.14.1 Safety certification These products are certified to meet the requirements of UL60950-1, CSA60950-1 and EN60950 and so marked as to the certify agency. 2.14.2 Electromagnetic compatibility Hard drives that displa...
Page 22 - FCC verification; . This booklet is available from the Super-
16 Pipeline HD Mini Series SATA Product Manual, Rev. A 2.14.3 FCC verification These drives are intended to be contained solely within a personal computer or similar enclosure (not attached as an external device). As such, each drive is considered to be a subassembly even when it is individually mar...
Page 23 - Environmental protection; European Union Restriction of Hazardous Substances (RoHS); Corrosive environment; 表示该部件(于同类物品程度上)所含的危险和有毒物质低于中国
Pipeline HD Mini Series SATA Product Manual, Rev. A 17 2.15 Environmental protection Seagate designs its products to meet environmental protection requirements worldwide, including regulations restricting certain chemical substances. 2.15.1 European Union Restriction of Hazardous Substances (RoHS) T...
Page 25 - Configuring and mounting the drive; Handling and static-discharge precautions
Pipeline HD Mini Series SATA Product Manual, Rev. A 19 3.0 Configuring and mounting the drive This section contains the specifications and instructions for configuring and mounting the drive. 3.1 Handling and static-discharge precautions After unpacking, and before installation, the drive may be exp...
Page 26 - Configuring the drive; Figure 2. Attaching SATA cabling
20 Pipeline HD Mini Series SATA Product Manual, Rev. A 3.2 Configuring the drive Each drive on the Serial ATA interface connects in a point-to-point configuration with the Serial ATA host adapter. There is no master/slave relationship because each drive is considered a master in a point-to-point rel...
Page 27 - Drive mounting; Top cover stiffness/deflection; Operating with no performance degradation, emitted noise,
Pipeline HD Mini Series SATA Product Manual, Rev. A 21 3.4 Drive mounting You can mount the drive using four screws in the side-mounting holes or four screws in the bottom-mounting holes. See Figure 3 for drive mounting dimensions. Follow these important mounting precautions when mount-ing the drive...
Page 29 - Hot-Plug compatibility; Serial ATA connector pin definitions; Segment; Key and spacing separate signal and power segments
Pipeline HD Mini Series SATA Product Manual, Rev. A 23 4.0 Serial ATA (SATA) interface These drives use the industry-standard Serial ATA interface that supports FIS data transfers. It supports ATA programmed input/output (PIO) modes 0–4; multiword DMA modes 0–2, and Ultra DMA modes 0–6. The drive al...
Page 31 - Supported ATA commands; See
Pipeline HD Mini Series SATA Product Manual, Rev. A 25 4.3 Supported ATA commands The following table lists Serial ATA standard commands that the drive supports. For a detailed description of the ATA commands, refer to the Serial ATA: High Speed Serialized AT Attachment specification . See “S.M.A.R....
Page 34 - Identify Device command; The Identify Device command (command code EC; xxxx
28 Pipeline HD Mini Series SATA Product Manual, Rev. A 4.3.1 Identify Device command The Identify Device command (command code EC H ) transfers information about the drive to the host following power up. The data is organized as a single 512-byte block of data, whose contents are shown in the table ...
Page 35 - Word
Pipeline HD Mini Series SATA Product Manual, Rev. A 29 59 Number of sectors transferred during a Read Multiple or Write Multiple command xxxx H 60–61 Total number of user-addressable sectorsThis field contains a value that is one greater than the total number of user-addressable sectors. The maximum...
Page 36 - Bit
30 Pipeline HD Mini Series SATA Product Manual, Rev. A 94 Auto acoustic management setting xxxx H 95–99 ATA-reserved 0000 H 100–103 Total number of user-addressable LBA sectors available(see Section 2.2 for related information)These words are required for drives that support the 48- bit addressing f...
Page 38 - Set Features command
32 Pipeline HD Mini Series SATA Product Manual, Rev. A 4.3.2 Set Features command This command controls the implementation of various features that the drive supports. When the drive receives this command, it sets BSY, checks the contents of the Features register, clears BSY and generates an inter-r...
Page 41 - Seagate Technology support services; Internet; For information regarding Seagate products and services, visit; mySeagate; Global Customer Support; Presales Support
Pipeline HD Mini Series SATA Product Manual, Rev. A 35 5.0 Seagate Technology support services Internet For information regarding Seagate products and services, visit www.seagate.com . Worldwide support is available 24 hours daily by email for your questions. Presales Support: [email protected] T...
Page 42 - Customer Service Operations; Warranty Service; for the service center near you.; USA/Canada/Latin America support services; Direct dial; and Mexico; Europe, the Middle East and Africa Support Services
36 Pipeline HD Mini Series SATA Product Manual, Rev. A Customer Service Operations Warranty Service Seagate offers worldwide customer support for Seagate products. Seagate distributors, OEMs and other direct customers should contact their Seagate Customer Service Operations (CSO) representative for ...
Page 43 - Index
Pipeline HD Mini Series SATA Product Manual, Rev. A 37 Index A ACA 15 acoustics 4 , 13 Active mode 10 Address 26 AFR 14 Agency certification 15 Altitude 11 Altitude, nonoperating 4 Altitude, operating 4 ambient temperature 7 Annualized Failure Rate 14 Annualized Failure Rate (AFR) 4 Areal density 3 ...
Page 48 - Seagate Technology LLC
Seagate Technology LLC 920 Disc Drive, Scotts Valley, California 95066-4544, USA Publication Number: 100560196, Rev. A, Printed in USA
