SEAGATE 1080SL - Manual
SEAGATE 1080SL – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – © 1995 Seagate Technology, Inc. All rights reserved; Contents
- Page 3 – Introduction
- Page 4 – Drive features
- Page 5 – Note. Throughout this manual the Medalist 1080sl SCSI is; referred to by its model number, ST51080N.; Application. Your Seagate; drive is designed for IBM and IBM-; Static discharge. Observe the following precautions:; Use antistatic padding on all work surfaces.; Warranty. See your authorized Seagate distributor or dealer.
- Page 7 – Configuring the drive
- Page 8 – Figure 1. Connector and jumper block locations
- Page 9 – Figure 2. Options jumper settings
- Page 12 – Attaching cables; Figure 1 on page 6 shows connector and jumper block locations.; Turn off the system power and put on a grounded wrist; to pins 9 and 10 of jumper block J8. Pin 9 is ground.; Attach an available power cable to the drive.
- Page 13 – Mounting the drive; Caution. To prevent drive mounting-hole damage, use only the; type of screws specified.; Figure 3. Mounting hole locations
- Page 14 – Configuring the drive and computer; System setup configuration; A bootable diskette with the Format and FDISK command; Enter the System Setup routine. (Refer to your computer’s
- Page 15 – Partitioning; To partition the drive:; Insert a bootable diskette into Drive A. Turn the computer on.; Note. If you have two or more drives in your system, the menu; create DOS partition or logical DOS drive. Press; create primary DOS partition. Use the maximum avail-; for each subsequent selection.
- Page 16 – High-level formatting; Type the following command at the DOS prompt:
- Page 18 – Basic troubleshooting; Warning. Always turn off the system before changing jumpers or; unplugging cables and cards.; Caution. Improperly aligning or reverse-plugging pin 1 of one
- Page 20 – Advanced troubleshooting; Check all cards for proper seating.
- Page 21 – Check the power supply specifications.; The screen stays blank when you power up the system.; Make sure the monitor is plugged in and turned on.
- Page 23 – Technical support services; SeaBOARD
- Page 24 – Thailand; SeaFAX; United States
- Page 26 – Storing and shipping your drive; Seagate Approved Package; Figure 4. A drive in an approved package
. . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . .
Medalist 1080sl
. . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . .
SCSI Interface Drive
. . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . .
Installation Guide
. . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . .
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
© 1995 Seagate Technology, Inc. All rights reserved Publication Number: 36325-001, Rev. A, August 1995 Seagate, Seagate Technology and the Seagate logo are regis-tered trademarks of Seagate Technology, Inc. Medalist SL, Sea-FAX, SeaFONE, SeaBOARD and SeaTDD are trademarks ofSeagate Technology, Inc. ...
Introduction Thank you for choosing a Seagate drive. The purpose of thisguide is to assist you with installing your new hard drive. Itsorganization outlines the complete installation process from han-dling the drive and drive application in Before you begin... tooffering troubleshooting suggestions ...
Drive features Formatted Capacity (Mbytes) 1080.23 Total sectors 2,109,840 Cylinders 4,826 Physical heads 4 Sectors per track (average) 109 Bytes per sector 512 Spindle speed 5,376 RPM Average seek time (msec) 12.5 msec Cache (segmented) 128 Kbytes Internal transfer rate (Mbits per second max) 33 MH...
