Scotsman FME504 - Manual

NME454, 654 & FME504, 804 January 2007 Page 5 FOR THE INSTALLER: Location TWO UNITS ON ONE BIN ALLOW ROOM FOR AIR CIRCULATION AND SERVICE ACCESS ALLOW AIR SPACE ON BOTH SIDES Airflow Notice: Air flow is in the sides and out the back.

FOR THE PLUMBER CONFORM TO ALL APPLICABLE CODES Water Inlet Air Cooled Models: Use 3 8 " O.D. copper tubing to connect cold potable water to the 3 8 " male flare fitting at the back of the cabinet. Install a handvalve near the machine to control the water supply. Water Treatment: In most are...

FOR THE ELECTRICIAN CONFORM TO ALL APPLICABLE CODES Connect the electrical power to the machine to thewires in the junction box at the rear of the machine.Check the nameplate (located on the back panel)for the voltage requirements, and for the minimumcircuit ampacity. The machine requires a solidcha...

NME454, 654 & FME504, 804 January 2007 Page 8 INITIAL START UP Pre-Start Inspection 1. Remove the front and side service panels. 2. Check that any shipping blocks have beenremoved. 3. Inspect the interior of the machine for loosescrews or wires. Check that no refrigerant lines are rubbing each o...

CLEANING & SANITIZING A Scotsman Ice System represents a sizable investment of time and money in any company ’s business.In order to receive the best return for that investment, it MUST receive periodic maintenance.It is the USER’S RESPONSIBILITY to see that the unit is properly maintained. It i...

1. The bin control is a device that senses light,therefore it must be kept clean so it can “see”. Atleast twice a year, remove the bin control sensorsfrom the base of the ice chute, and wipe the insideclean, as illustrated . 2. The ice machine senses water level by a probelocated in the water reserv...

NME454, 654 & FME504, 804 January 2007 Page 11 Clean the air cooled condenser. The air flow on this model is from front to back, sothe inside of the machine will have to be availableto clean the air cooled condenser. Use a vacuumcleaner or coil cleaner if needed. Do NOT use awire brush.A. Discon...

The bearing in the breaker should also be checkedat least two times per year . A. Check the bearing by: · removing the ice chute cover · unscrewing the ice sweep · removing the water shed & unscrewing thebreaker cover (left hand threads). · unscrewing the auger stud Inspect the bearing. There sh...

AUGER MAINTENANCE In some areas, the water supply to the ice makerwill contain a high concentration of minerals, andthat will result in an evaporator and augerbecoming coated with these minerals, requiring amore frequent removal than twice per year. If indoubt about the condition of the evaporator a...

BIN CONTROLS (Ice Level Sensors) 1. Disconnect electrical power.2. Remove front panel.3. Remove control box cover.4. Locate ice chute, at the base of the chute, infront of and behind it are two plastic bin controlmounts.5. Slide each bin control to the left, and in thecontrol box, disconnect the ele...