Page 2 - Index
Page 2 Index 1. Welcome 3 Your State Regulatory Authority 3 2. Important Safety Information 4 Before Installation 5 Product Use 6 Ducted or Recirculating? 6 Electrical Cord 6 3. Description 7 Rangehood 7Cutout Size 7 4. Operation 8 Push Button Control Panel 8 Speed Control 8 Cleaning periods of meta...
Page 3 - Welcome; Your State Regulatory Authority
Page 3 1. Welcome Thank you for purchasing your new Schweigen rangehood. To get the maximum output from this unit, please read through this guide before use. The guide contains important information on the use and maintenance of the unit, as well as important safety notes. This will ensure your pers...
Page 4 - Important Safety Information; WARNING
Page 4 2. Important Safety Information WARNING Please read this section thoroughly before attempting to operate the appliance. Inspect your product upon receipt. Any damage or defects MUST be reported within 48 hours, or no claim will be recognised. DO NOT INSTALL THIS APPLIANCE IF YOU FIND IT DAMAG...
Page 5 - Before Installation
Page 5 2. Important Safety Information Before Installation 1. We recommend this appliance be installed or repaired by a qualified Schweigen Home Appliances technician. 2. Please see our website www.schweigen.com.au for recommended installers. 3. It is dangerous to modify any part of this appliance. ...
Page 6 - Product Use; Ducted or Recirculating?
Page 6 2. Important Safety Information Product Use This product is designed for household use and should not be used for commercial applications. After use, always ensure that all controls are in the “OFF” position. When frying with a gas flame, take particular care not to allow the oil or grease in...
Page 7 - Description; Rangehood; Cutout Size
Page 7 3. Description Rangehood 1. For use with Isodrive ® motor system 2. Male plug (main power 240V) 3. Single 200mm outlet 4. Reducer (for Isodrive ® 650 only) 5. Filter 6. Lights NOTE: Filter and light quantity may vary from model to model. Important Electronics MUST be accessible for service an...
Page 8 - Operation; Push Button Control Panel; Cleaning periods of metal filters — “C” Signal
Page 8 4. Operation Schweigen silent rangehoods are recognised for their silent operation. Although this holds true for all of our rangehoods with external motors, one must note that the rangehoods are silent when they are used for regular cooking on the lower fan setting. Therefore, you will only h...
Page 9 - Cleaning & Maintenance; Cleaning the Interior; OK; Warning
Page 9 5. Cleaning & Maintenance Cleaning the Interior Clean the interior of the rangehood with a damp cloth and a neutral detergent or denatured alcohol. NOTE: Do not use denatured alcohol on the exterior of the rangehood. Do not clean the electric parts or the motor with liquids or solvents Cl...
Page 10 - Filters
Page 10 5. Cleaning & Maintenance Filters For this appliance to function effectively, regular maintenance is a must. • The function of the filter is to absorb the grease particles given off during cooking.• Clogged filters and heavy oil deposits restrict airflow and may cause the motor to overhe...
Page 11 - Replacing the Lights
Page 11 5. Cleaning & Maintenance Replacing the Lights Step 2 Gently turn light bulb anti-clockwise, pull the light bulb down and remove it from the light holder. Step 3 Insert a new light bulb by lining up the pins of the light bulb with the larger holes inside the light holder. Once the pins a...
Page 12 - Installation; Rangehood Size vs Cooktop Size; Overhead cabinet Rangehood Installation position
Page 12 6. Installation Rangehood Size vs Cooktop Size In addition to the size, the height of the rangehood above the cooktop is important to obtain the best performance. INADEQUATE Rangehood smaller than cooking zone ADEQUATE Rangehood same size as cooking zone OPTIMAL Rangehood larger than cooking...
Page 13 - Mounting Instructions; In addition to the information in this manual,
Page 13 6. Installation Mounting Instructions It is STRONGLY RECOMMENDED that the rangehood be installed centrally over the cooktop. This will greatly improve its performance. Minimum height from the hob top surface to the underside face of the rangehood:• 650mm electric cooktop• 650mm gas cooktop A...
Page 14 - Mounting and Fixing Points; FRONT VIEW; DANGER
Page 14 6. Installation Mounting and Fixing Points The diagrams below are a guide for all mounting points. FRONT VIEW TOP VIEW BOTTOM VIEW SIDE VIEW SIDE VIEW FRONT VIEW TOP VIEW BOTTOM VIEW SIDE VIEW SIDE VIEW Bottom View Front View Side View Mounting point A and B need to be tighten with slightly ...
Page 15 - Installation Example; NOTE
Page 15 6. Installation Installation Example FRONT VIEW TOP VIEW BOTTOM VIEW SIDE VIEW SIDE VIEW FRONT VIEW TOP VIEW BOTTOM VIEW SIDE VIEW SIDE VIEW FRONT VIE W TOP VIE W BOTT OM VIEW SIDE VIEW SIDE VIEW FRONT VIE W TOP VIE W BOTT OM VIEW SIDE VIEW SIDE VIEW Support Frame Step 2 Secure support frame...
Page 16 - Ducting
Page 16 6. Installation Ducting Please DO NOT crush or kink the ducting. 1. Crushed or kinked ducting creates sharp corners that creates turbulence. This reduces the size and efficiency of the ducting, lowers extraction and may cause excessive noise. 2. Sweeping curves and taut ducting reduces resis...
Page 17 - System Overview
Page 17 6. Installation System Overview 1. Isodrive ® Motor 2. Roof Seal Kit (Dektite) (Not supplied)* 3. Support Straps (Not supplied)* 4. Attach Flexi Duct to Bell-Mouth Adaptor using ring clamp. Please DO NOT rip the ducting. 5. Isodrive ® Motor Power Lead (Male Plug) 6. Rangehood to Isodrive ® M...
Page 18 - Condensation Information; Cooking with Induction Cooktops
Page 18 7. Condensation Information Cooking with Induction Cooktops Cooking with an induction or similar cooktop, may produce condensation on the rangehood. Unlike basic electric or gas cooking, induction cooktops heat food and liquid instantly, which in turn, produces vapours rapidly. Because of th...
Page 19 - Troubleshooting; IMPORTANT
Page 19 8. Troubleshooting Troubleshooting Before you contact the technical service department, make sure that the product is plugged in and power is supplied. • Do not take any action that will damage the product. Check electric c onnection. V oltage o f the electric ne tw ork should be be tw een 2...
Page 20 - Faulty Installation
Page 20 8. Troubleshooting Faulty Installation It is not the responsibility of Schweigen to rectify any incorrect installations. A service call out fee will be charged for any Schweigen technician that attends a call, whereby it is established that the fault is due to an incorrect installation or no...
Page 21 - Specifications; Technical Specifications; Dimensions
Page 21 9. Specifications Technical Specifications Model UM1390-12S Feeding Voltage 220-240V 50Hz Lamp Power – Halogen (W) 2 x 20W (Optional) Lamp Power – LED (W) 2 x 3W (Supplied) Weight 9.8kg Dimensions 1181 391 370 391 12.5 350.5 20 39 170 part of filter 3 12.5 246 Ø197 260 90 32 1181 1140 1130 2...
Page 23 - Disclaimer
_n_. _RH Section_ Page 23 10. Disclaimer Disclaimer Under our policy of continuous product development, product specifications may change without notice. Prospective purchasers should therefore check with the retailer to ensure this publication correctly describes the products being offered for sale...
