Page 2 - WELCOME; must be reported within 48 hours
Page 2 WELCOME Thank you for purchasing this Schweigen IN appliance.To achieve the optimal performance from your appliance, and to avoid the risk of accident or damage, it is essential to read this manual before installation and first time use.This guide contains important information on the use and...
Page 3 - TABLE OF CONTENTS
Page 3 TABLE OF CONTENTS Important safety information ................................................................................................................ 4 Description ..........................................................................................................................
Page 4 - IMPORTANT SAFETY INFORMATION
Page 4 IMPORTANT SAFETY INFORMATION Please read the instructions carefully. Only then will you be able to operate your appliance safely and correctly. Retain the instruction manual for future use or for subsequent owners. Check the appliance for damage after unpacking it. Do not connect or install t...
Page 6 - MATCH THE RANGEHOOD SIZE TO YOUR COOKTOP
IMPORTANT SAFETY INFORMATION Page 6 Rangehood smaller than cooking zone INADEQUATE Rangehood same size as cooking zone ADEQUATE Rangehood larger than cooking zone OPTIMAL MATCH THE RANGEHOOD SIZE TO YOUR COOKTOP PRODUCT USEThe Rangehood has one mode of operation:Air extraction: The air is drawn in b...
Page 7 - Rangehood; DESCRIPTION
Page 7 Rangehood 1. Flue Wall Mounting Bracket2. Extension Flue3. Main Flue4. Single Outlet 200mm5. PCB (computer) Board6. Connect to the Isodrive motor system7. Male Plug (Connect to Mains Power 240V 10 Amp) 8. Reducer (For Isodrive 650 motor only)9. Filters10. Screw Pack and bracket11. LED light g...
Page 8 - INSTALLATION; DANGER
Page 8 INSTALLATION DANGER All electrical wiring from the motor to the rangehood should be kept inside the roof space. SYSTEM OVERVIEW 1. Isodrive Motor2. Roof Seal Kit (Dektite)*3. Support Straps*4. Attach Flexi Duct to Bell-Mouth Adaptor using cable tie or ring clamp. Please DO NOT rip the ducting...
Page 9 - MOUNTING LAWS AND REGULATIONS; Type of Cooktop
Page 9 MOUNTING LAWS AND REGULATIONS • The location of the installation must have permanent openings for ventilation.• Regulations concerning the expelling of air must be fulfilled.• It is STRONGLY RECOMMENDED that the rangehood be installed centrally over the cooktop, this will greatly improve its ...
Page 11 - INSTALLING THE RANGEHOOD
INSTALLATION Page 11 INSTALLING THE RANGEHOOD A — Rangehood levelling screw pointsB — Main support bracket, wall screw pointsC — Second rangehood screw pointsD — Main support bracket NOTE: Some models might need the computer board and wiring bracket to be attached, see page 10 . B A D C Step 1 Measu...
Page 13 - protection on the rangehood and
INSTALLATION Page 13 Figure 1 Figure 2 Figure 3 Step 6 Install the wall flue bracket.1. Fold both ends to 90° as shown figure 1.2. Install the bracket to the wall at the correct height, see figure 2. 3. Attach flue cover to the bracket, see figure 3. Fold along these lines Fold in 90º Wall Mount Bra...
Page 14 - ISODRIVE MOTOR SETUP
INSTALLATION Page 14 ISODRIVE MOTOR SETUP NOTEPlease refer to the Isodrive motor installation guide for more details on flexi ducting and Isodrive motor installation. FLEXIBLE DUCTING INSTALLATION Please do not crush or kink flexi ducting, as it will reduce air flow and may cause noise to occur thro...
Page 15 - OPERATION; Electronic Controls
Page 15 OPERATION To obtain the best performance, switch the rangehood on a few minutes prior to cooking and leave it running for at least 10 minutes after you have finished cooking.The buttons have the following functions:A.- Timer: When this function is activated, the blue light will flash on the ...
Page 16 - Electronic Touch Controls
OPERATION Page 16 Electronic Touch Controls Models KLS-ALBW9S and KLS-ALBB9S.The rangehood has a 4-speed electronic keypad. Speed control usage suggestions:• Low speed for simmering.• Medium speed for light cooking.• High speeds for heavy frying or heavy cooking. To obtain the best performance, swit...
Page 17 - FILTERS; CLEANING AND MAINTENANCE; Catch A
Page 17 FILTERS • For this appliance to function effectively, regular maintenance is a must. • The function of the filter is to absorb the grease particles emitted during cooking. • Blocked filters and heavy oil deposits restrict airflow and may cause the motor to overheat and become a fire hazard. ...
Page 18 - SURFACES; a short period of time after being switched off.; REPLACING THE LIGHTS
CLEANING AND MAINTENANCE Page 18 SURFACES The surface of the rangehood can be cleaned with warm soapy water and a soft sponge / cloth. • Never use abrasive detergents, scouring pads, steel wool or solvents on ANY part of this appliance. • Rinse with clean water and ensure that the appliance is compl...
Page 19 - Halogen Bulb
CLEANING AND MAINTENANCE Page 19 Halogen Bulb LED Bulb [Optional] 1 2 3 TYPE 3 (Halogen G4HD, LED G4): REPLACING THE HALOGEN OR LED BULB (MAX 20W, 12V) 1. Press on the indicated zone “push” (1)2. Open the light cover to an angle of 90º, DO NOT force past 90º. 3. Insert a new 12V halogen bulb as indi...
Page 20 - TROUBLESHOOTING
Page 20 TROUBLESHOOTING COOKING WITH INDUCTION COOKTOPS Cooking with an induction or similar cooktop, may produce condensation on the rangehood.Unlike basic electric or gas cooking, induction cooktops heat food and liquid instantly, which in turn, produces vapours rapidly. Because of the accelerated...
Page 21 - appliance by yourself. Always
TROUBLESHOOTING Page 21 Before you contact the technical service department, make sure that the product is plugged in and power is supplied.• Do not take any action that will damage the product. IMPORTANTNever attempt to repair this appliance by yourself. Always refer to a qualified Service Technici...
Page 22 - FAULTY INSTALLATION
TROUBLESHOOTING Page 22 Calling the Technical Assistance Service HotlineIn the event that the failure is not due to the faults mentioned in Trouble Shooting, contact the Customer Service.In Australia, Customer Service 1300 829 066In New Zealand, Customer Service 0800 200 510 Lodging an online Servic...
Page 23 - TECHNICAL SPECIFICATIONS
Page 23 TECHNICAL SPECIFICATIONS Model: KLS-ALBW9S, KLS-ALBB9S Feeding Voltage: 220-240V 50HzMax Lamp Power: 2 x GLED Square 55 x 55mm 2.1 Watts 12V 4000k 1 x Fluorescent Tube Double 860mm Capped 21W 12V Model: WM-LIN9S Feeding Voltage: 220-240V 50HzMax Lamp Power: 2 x GLED Square 55 x 55mm 2.1W 12V...
Page 24 - DISCLAIMER
Page 24 Under our policy of continuous product development, product specifications may change without notice. Prospective purchasers should therefore check with the retailer to ensure this publication correctly describes the products being offered for sale. All information supplied is to be used for...
Page 25 - NOTES
