Schweigen PKCL7275SE - User Manual

Page 6 2. Your Safety Product Use This product is designed for household use and should not be used for commercial applications. After use, always ensure that all controls are in the “OFF” position. When frying with a gas flame, take particular care not to allow the oil or grease in the pan to catch...

Page 7 3. Tips & Suggestions OPTIMAL Rangehood bigger than the cooking area. ADEQUATE Rangehood equal to the cooking area. INADEQUATE Rangehood smaller than the cooking area. The Rangehood has one mode of operation: Air extraction: The air is drawn in and cleaned by the grease filters and direct...

Page 9 5. Operation Push Button Control Panel Turn on/off the rangehood High speed settingMedium speed settingLow speed setting Turn on/off the lamp 1 2 3 Schweigen silent rangehoods are recognised for their silent operation. Although this holds true for all of our rangehoods with external motors, o...

Page 10 6. Cleaning & Maintenance WARNING Always switch off and disconnect power before cleaning. Surfaces Wash with warm soapy water and a soft sponge. Never use abrasive detergent, scouring pads, steel wool or solvents on any part of this appliance, Always make sure to dry the appliance after ...

Page 11 6. Cleaning & Maintenance WARNING • If the grease filters are very dirty, the motor will extract only a small quantity of air, which reduces its efficiency; • The grease deposits that build up on the filter are highly flammable and COULD EASILY CATCH FIRE. • The manufacturer is exonerate...

Page 13 6. Cleaning & Maintenance Replacing the Light Bulb Step 2 Gently turn light bulb anti-clockwise, pull the light bulb down and remove it from the light holder. Step 3 Insert a new light bulb by lining up the pins of the light bulb with the larger holes inside the light holder. Once the pi...

Page 14 7. Installation DANGER Always switch off and disconnect power before installing the rangehood. Failure to do so may cause serious injury. *IMPORTANT: Please check all State and Federal Laws in relation to the minimum - maximum heights, regulations concerning the expelling of air and install ...

Page 15 7. Installation Wall Mount Installation Every wall mounted rangehood has two primary mounting points and several secondary mounting points to firmly fix the rangehood in its place. NOTE: The position of the secondary mounting holes may vary. Please ensure that the holes for the two primary m...

Page 18 7. Installation Isodrive Motor Setup Clip Please remove the clip when attaching Isodrive 1600 / 3200 motor (Single or Twin) system. To remove the clip, hold down 1, 2 and 3 gently pull out to direction 4. NOTE: DO NOT REMOVE the clip at the end of the white cord when installing an Isodrive 6...

Page 19 7. Installation Overview WARNING All electrical wiring (for connection from motor to rangehood) should be kept inside the roof space. Isodrive Motor 1 Roof Seal Kit (Dektite)* Support Straps* Motor Power Lead (Male Plug) Main Power Lead (Male Plug) Rangehood to Motor Lead (Female Plug) Flexi...

Page 20 8. Maintenance Condensation Information The induction cooktop is designed to provide rapid heating, improved thermal efficiency and greater heat consistency. For some customers with an induction cooktop, condensation can form on their rangehood filters while using their cooktop. The inductio...

Page 21 8. Maintenance User advice to avoid condensation in the rangehood: • The rangehood should be switched on approx. 10 minutes prior to cooking and the delay shut down timer set after cooking has stopped in order to clear the fumes held in the flue. These steps will help clear the flue out full...

Page 22 8. Maintenance Troubleshooting If the product does not work: Before you contact the technical service department, make sure that the product is plugged in, the electric fuse (on selected models) is in correctly and electric wiring is connected. (Fuses can be purchased from your local electri...

Page 23 8. Maintenance Calling the Technical Assistance Service Hotline In the event that the failure is not due to the faults mentioned in Trouble Shooting, contact the Technical Service 1300 829 066. A service request will require the following information:• The purchase date• The rangehood model ...

HOME APPLIANCES Distributed by: Unit 102/45 Gilby Road, Mt Waverley 3149 Victoria. 1300 881 693 (EST) www. schweigen .com.au