Page 2 - Index
Page 2 Index 1. Welcome 3 Your State Regulatory Authority 3 2. Your Safety 4 Before Installation 5 Product Use 6 Ducted or Recirculating? 6 Electrical Cord 6 3. Description 7 Main Rangehood 7 Cutout Size 7 4. Operation 8 Push Button Control Panel 8 Speed Control 8 5. Cleaning & Maintenance 9 Cle...
Page 3 - Welcome; Your State Regulatory Authority
Page 3 1. Welcome Thank you for purchasing your new Schweigen rangehood. To get the maximum output from this unit, please read through this guide before use. The guide contains important information on the use and maintenance of the unit, as well as important safety notes. This will ensure your pers...
Page 4 - Your Safety; WARNING
Page 4 2. Your Safety WARNING Please read this section thoroughly before attempting to operate the appliance. Inspect your product upon receipt. Any damage or defects MUST be reported within 48 hours, or no claim will be recognised. DO NOT INSTALL THIS APPLIANCE IF YOU FIND IT DAMAGED. If this produ...
Page 5 - Before Installation
Page 5 2. Your Safety Before Installation 1. We recommend this appliance be installed or repaired by an experienced Home Appliances technician. 2. Please see our website www.schweigen.com.au for experienced installers. 3. It is dangerous to modify any part of this appliance. Modification of any kind...
Page 6 - Product Use; Ducted or Recirculating?
Page 6 2. Your Safety Product Use This product is designed for household use and should not be used for commercial applications. After use, always ensure that all controls are in the “OFF” position. When frying with a gas flame, take particular care not to allow the oil or grease in the pan to catch...
Page 7 - Description; Main Rangehood; Cutout Size
_n_. _RH Section_ Page 7 3. Description Main Rangehood 1. Power Plug 2. Single Outlet 150mm 3. Filter 4. Lights 5. Oil Drip Tray Note: Filter and light quantity may vary from model to model. 491mm approx. 271mm appr ox. Note: Please make sure that all plastic protection on the rangehood and filters ...
Page 8 - Operation; Push Button Control Panel
_n_. _LH Section_ Page 8 4. Operation Push Button Control Panel Turn off the rangehood Low speed setting Medium speed setting High speed setting Turn on/off the light Speed Control This undermount is equipped with a 3 speed mechanical control. Speed control usage suggestions: • Low speed for simmeri...
Page 9 - Cleaning & Maintenance; Cleaning the Interior; OK; Warning
_n_. _RH Section_ Page 9 5. Cleaning & Maintenance Cleaning the Interior Clean the interior of the rangehood with a damp cloth and a neutral detergent or denatured alcohol. NOTE: Do not use denatured alcohol on the exterior of the rangehood. Do not clean the electric parts or the motor with liqu...
Page 10 - Filters; Replacing the Lights
_n_. _LH Section_ Page 10 5. Cleaning & Maintenance To remove the filter press handle and remove it through the front guide; bend it slightly and remove filter. To replace, perform the same operation but in reverse. Filters For this appliance to function effectively, regular maintenance is a mus...
Page 11 - Danger; Replacing the LED Strip Light
_n_. _RH Section_ Page 11 Danger Always switch off and disconnect the power cord before replacing any light bulbs. Failure to do so may cause serious injury. Please be aware that the light bulb will retain heat for a short period of time after being switched off. 5. Cleaning & Maintenance Replac...
Page 12 - Installation; Rangehood Size vs Cooktop Size; Overhead cabinet Rangehood Installation position
_n_. _LH Section_ Page 12 6. Installation Rangehood Size vs Cooktop Size In addition to the size, the height of the rangehood above the cooktop is important to obtain the best performance. INADEQUATE Rangehood smaller than cooking zone ADEQUATE Rangehood same size as cooking zone OPTIMAL Rangehood l...
Page 13 - Mounting Instructions; In addition to the information in this manual,
_n_. _RH Section_ Page 13 6. Installation Mounting Instructions It is STRONGLY RECOMMENDED that the rangehood be installed centrally over the cooktop. This will greatly improve its performance. Minimum height from the hob top surface to the underside face of the rangehood:• 600mm electric cooktop• 6...
Page 14 - Mounting Points for Body; DANGER; FRONT VIEW
_n_. _LH Section_ Page 14 6. Installation Mounting Points for Body The diagrams below are a guide for all mounting points. Note: Please make sure all plastic protection on the rangehood and filters are removed before use. DANGER Always switch off and disconnect the power supply before installing the...
Page 15 - Installation Example; NOTE
_n_. _RH Section_ Page 15 6. Installation Installation Example Step 2 Secure the undermount into cavity using screws. All screws are installed from the bottom of the rangehood into the cabinet. Step 3 Connect the 6 pin connector (on the face plate) to the rangehood before securing the face plate to ...
Page 16 - The ducting diameter MUST be 150mm. The overall length; Ducting
_n_. _LH Section_ Page 16 6. Installation The ducting diameter MUST be 150mm. The overall length of the ducting should not be greater than 4 metres. Ducting Please DO NOT crush or kink the ducting. 1. Crushed or kinked ducting creates sharp corners that creates turbulence. This reduces the size and ...
Page 18 - Ducting Advice
Page 18 6. Installation Ducting Advice Never reduce flue diameter right next to the rangehood outlet fitting. Avoid excessive reduction of the flue size, as this drastically reduces extraction capacity. Keep the curves or bends to a minimum. If they do exist, try to keep the angles as open as possib...
Page 20 - Condensation Information; Cooking with Induction Cooktops
_n_. _LH Section_ Page 20 7. Condensation Information Cooking with Induction Cooktops Cooking with an induction or similar cooktop, may produce condensation on the rangehood. Unlike basic electric or gas cooking, induction cooktops heat food and liquid instantly, which in turn, produces vapours rapi...
Page 21 - Troubleshooting
_n_. _RH Section_ Page 21 8. Troubleshooting Troubleshooting If the product does not work: Before you contact the technical service department, make sure that the product is plugged in, and electric wiring is connected. Weak air suction may be caused by back draft fins remaining closed. Do not take ...
Page 22 - Faulty Installation
_n_. _LH Section_ Page 22 8. Troubleshooting Faulty Installation It is not the responsibility of Schweigen to rectify any incorrect installations. A service call out fee will be charged for any Schweigen technician that attends a call, whereby it is established that the fault is due to an incorrect ...
Page 23 - Specifications; Dimensions
_n_. _RH Section_ Page 23 9. Specifications Dimensions Technical Specifications Model NAUM-6 / NAUM-6B Feeding Voltage 240V 50Hz Lamp Power — LED Strip (W) 2 x 1.5W Front 295 525 485 80 265 150 210 340 265
Page 24 - Disclaimer
_n_. _LH Section_ Page 24 10. Disclaimer Disclaimer Under our policy of continuous product development, product specifications may change without notice. Prospective purchasers should therefore check with the retailer to ensure this publication correctly describes the products being offered for sale...
Page 26 - Notes