Page 2 - INDEX
Page 2 Welcome 3 Important Safety Information 4 Description 7Operation 8Cleaning and Maintenance 10 Installation 14Condensation Information 28 Troubleshooting 29Technical Specifications 31 Disclaimer 34 INDEX
Page 3 - must be reported within 48 hours; WELCOME
YOUR STATE REGULATORY AUTHORITYDifferent Australian states have varying legislative requirements for the installation of rangehood ducting. Some will insist on ducting being vented externally (i.e. not in to the ceiling cavity); others will not. It is imperative that you check with your state buildi...
Page 4 - IMPORTANT SAFETY INFORMATION
Page 4 IMPORTANT SAFETY INFORMATION Please read the instructions carefully. Only then will you be able to operate your appliance safely and correctly. Retain the instruction manual for future use or for subsequent owners. Check the appliance for damage after unpacking it. Do not connect or install t...
Page 5 - BEFORE INSTALLATION
IMPORTANT SAFETY INFORMATION Page 5 BEFORE INSTALLATION We recommend this appliance be installed or repaired by a qualified Schweigen Home Appliances technician. Please see our website www.schweigen.com.au for a list of our recommended installers.It is dangerous to modify any part of this appliance....
Page 6 - PRODUCT USE
IMPORTANT SAFETY INFORMATION Page 6 PRODUCT USE This product is designed for household use and should not be used for commercial applications.After use, always ensure that all controls are in the “OFF” position.When frying with a gas flame, take particular care not to allow the oil or grease in the ...
Page 7 - DESCRIPTION; Rangehood
Page 7 DESCRIPTION Rangehood 1. Flue Wall Mounting Bracket2. Extension Flue3. Main Flue4. Single Outlet 200mm5. PCB (computer) Board6. Connect to the Isodrive ® motor system 7. Male Plug (Connect to Mains Power 240V 10 Amp) 8. Reducer (For Isodrive ® 650 motor only) 9. Filters10. Screw Pack and brac...
Page 8 - Electronic Controls; OPERATION
Page 8 To obtain the best performance, switch the rangehood on a few minutes prior to cooking and leave it running for at least 10 minutes after you have finished cooking.The buttons have the following functions:A.- Timer: When this function is activated, the blue light will flash on the timer butto...
Page 9 - Electronic Touch Controls
OPERATION Page 9 Electronic Touch Controls Models KLS-ALBW9S and KLS-ALBB9S.The rangehood has a 4-speed electronic keypad. Speed control usage suggestions:• Low speed for simmering.• Medium speed for light cooking.• High speeds for heavy frying or heavy cooking. To obtain the best performance, switc...
Page 10 - CLEANING AND MAINTENANCE; FILTERS; Catch A
Page 10 CLEANING AND MAINTENANCE WARNINGAlways switch off and disconnect power to the rangehood before cleaning. The manufacturer is exonerated from all responsibility in the event of fire due to poor maintenance of the filters and rangehood.Cleaning and user maintenance shall not be made by childre...
Page 11 - SURFACES; alcohol on the exterior of the
CLEANING AND MAINTENANCE Page 11 SURFACES The surface of the rangehood can be cleaned with warm soapy water and a soft sponge / cloth. • Never use abrasive detergents, scouring pads, steel wool or solvents on ANY part of this appliance. • Rinse with clean water and ensure that the appliance is compl...
Page 12 - heat for a short period of time after being switched off.
CLEANING AND MAINTENANCE Page 12 Your rangehood may have multiple light types, please refer to the pictures below for light replacement instructions. TYPE 1 (LED Spot) & 2 (GLED Square):REPLACING THE LED BULB The life span of an LED bulb is at least 10 times that of a halogen bulb. If the globe ...
Page 13 - Halogen Bulb; REPLACING THE HALOGEN OR LED; REPLACING THE FLUORESCENT TUBE
CLEANING AND MAINTENANCE Page 13 Halogen Bulb LED Bulb [Optional] 1 2 3 TYPE 3 (Halogen G4HD, LED G4): REPLACING THE HALOGEN OR LED BULB (MAX 20W, 12V) 1. Press on the indicated zone “push” (1)2. Open the light cover to an angle of 90º, DO NOT force past 90º. 3. Insert a new 12V halogen bulb as indi...
Page 14 - INSTALLATION; RANGEHOOD SIZE VS COOKTOP SIZE
Page 14 INSTALLATION INADEQUATE Rangehood smaller than cooking zone ADEQUATE Rangehood same size as cooking zone OPTIMAL Rangehood larger than cooking zone RANGEHOOD SIZE VS COOKTOP SIZE In addition to the size, the height of the rangehood above the cooktop is important to obtain the best performanc...
Page 15 - MOUNTING INSTRUCTIONS; with local laws and regulations.
Page 15 INSTALLATION MOUNTING INSTRUCTIONS It is STRONGLY RECOMMENDED that the rangehood be installed centrally over the cooktop. This will greatly improve its performance.Minimum height from the hob top surface to the underside face of the rangehood:• 650mm electric cooktop• 650mm gas cooktopAny in...
Page 16 - ATTACHING THE COMPUTER BOARD
INSTALLATION Page 16 ATTACHING THE COMPUTER BOARD AND WIRING BRACKET (CERTAIN MODELS ONLY) Before you install the rangehood, you may need to connect the computer board and wiring bracket to the main body of the rangehood.1. Attach the computer board to the outlet box using the screws provided. 2. Po...
Page 17 - INSTALLING THE RANGEHOOD
INSTALLATION Page 17 INSTALLING THE RANGEHOOD A — Rangehood levelling screw pointsB — Main support bracket, wall screw pointsC — Second rangehood screw pointsD — Main support bracket NOTE: Some models might need the computer board and wiring bracket to be attached, see page 10 . B A D C Step 1 Measu...
Page 19 - protection on the rangehood and
INSTALLATION Page 19 Figure 1 Figure 2 Figure 3 Step 6 Install the wall flue bracket.1. Fold both ends to 90° as shown figure 1.2. Install the bracket to the wall at the correct height, see figure 2. 3. Attach flue cover to the bracket, see figure 3. Fold along these lines Fold in 90º Wall Mount Bra...
Page 20 - Please DO NOT crush or kink the ducting.
INSTALLATION Page 20 For technical support, please contact 1300 881 693. Please DO NOT crush or kink the ducting. 1. Crushed or kinked ducting creates sharp corners that creates turbulence. This reduces the size and efficiency of the ducting, lowers extraction and may cause excessive noise. BACK DRA...
Page 21 - SYSTEM OVERVIEW; Danger
Page 21 INSTALLATION SYSTEM OVERVIEW 1. Isodrive ® Motor 2. Roof Seal Kit (Dektite) (Not Supplied)*3. Support Straps (Not Supplied)*4. Attach Flexi Duct to Bell-Mouth Adaptor using ring clamp. Please DO NOT rip the ducting. 5. Isodrive ® Motor Power Lead (Male Plug) 6. Rangehood to Isodrive ® Motor ...
Page 22 - TROUBLESHOOTING; COOKING WITH INDUCTION
Page 22 TROUBLESHOOTING COOKING WITH INDUCTION COOKTOPS Cooking with an induction (or similar) cooktop, may produce condensation on the rangehood.Unlike basic electric or gas cooking, induction cooktops heat food and liquid instantly, which in turn, produces vapours rapidly. Because of the accelerat...
Page 23 - appliance by yourself. Always
TROUBLESHOOTING Page 23 Before you contact the technical service department, make sure that the product is plugged in and power is supplied.• Do not take any action that will damage the product. Check electric c onnection. V oltage o f the electric ne tw ork should be be tw een 220 - 240V , r angeho...
Page 24 - SERVICE; FAULTY INSTALLATION
TROUBLESHOOTING Page 24 SERVICE Lodging an Online Service RequestIn the event that the failure is not due to the faults mentioned in the Troubleshooting section, you can lodge an online Service Request. To lodge an online Service Request, visit our website www.schweigen.com.au/service-and-warranty a...
Page 25 - TECHNICAL SPECIFICATIONS
Page 25 TECHNICAL SPECIFICATIONS Model: KLS-ALBW9S, KLS-ALBB9S Feeding Voltage: 220-240V 50HzMax Lamp Power: 2 x GLED Square 55 x 55mm 2.1 Watts 12V 4000k 1 x Fluorescent Tube Double 860mm Capped 21W 12V KLS-ALBW9S, KLS-ALBB9S 300 525 900 80 300 440 Min 620 - Max 1050
Page 27 - DISCLAIMER; DISPOSAL OF OLD APPLIANCES
Page 27 DISCLAIMER Under our policy of continuous product development, product specifications may change without notice. Prospective purchasers should therefore check with the retailer to ensure this publication correctly describes the products being offered for sale. All information supplied is to ...
