Schlage BE479AA V CAM 716 + FE285 CAM 716 GEO - User Manual

5 ENGLISH 5 Check door/frame dimensions. • Measure the dimensions shown. If your door dimensions do not match, you will need to change your door preparation. Go to answers. schlage.com for drilling instructions. » If your door is thicker than 1 C\v ”, you will need a thick door kit. Please call Cust...

6 ENGLISH 7 Install bolt and strike. 7a Adjust bolt length, if necessary. • If the backset (see step 5 on page 5) of your door was 2 C\, ” (60 mm), you do not need to do anything. Proceed to step step 7b . • If the backset (see step 5 on page 5) of your door was 2 C\v ” (70 mm), you need to adjust y...

7 ENGLISH 7c Install the bolt into the door. Choose the picture below that matches your door. FIgure A: Mortise Figure B: No Mortise Use a block of wood and a hammer (not included) to tap the bolt into place. You don’t need to use the screws. Actual Size (2) OR Make sure the word TOP faces up when i...

8 ENGLISH 7e Test bolt alignment. 1. Close the door. 2. Insert a flathead screwdriver into the slot in the bolt, as shown. 3. Rotate the screwdriver toward the door edge to extend the bolt into the hole in the frame. This operation should be smooth. You should be able to rotate the screwdriver 90˚, ...

9 ENGLISH 8b Install the Support Plate on the inside of the door. » Make sure the Touchscreen and Support Plate are straight on the door before tightening the screws. Tighten screws fully to prevent the lock from moving over time. TOP Make sure the indented circle is facing the door. Hold the Touchs...

10 ENGLISH 9b Connect the cable to the Alarm Assembly. » Locate the screws in step 9d before beginning this step so they will be handy when you need them. The connector fits only one way. Match the dot on the connector with the dot on the circuit board. 9c Install the Alarm Assembly. 1. Align the ta...

11 ENGLISH 9d Secure the Alarm Assembly to the Support Plate. Install the lower screw first. Actual Size 8-32 x .187 UP FHMS Actual Size 8-32 x 1 Z\, ” NOTE Please do not rotate the thumbturn at this time. It may not rotate easily. Setup will be performed after installation is complete. 10 Install t...

12 ENGLISH 10b Install the battery cover. Speaker Hole DO NOT install screw! 11 Set up the Lock. 1. Open the door if it is not already open.2. Press the Outside Schlage Button.3. Enter one of the Default Access codes into the lock (see label shown in step 6 on page 5) . 4. The lock will perform a se...

13 ENGLISH 10b Install the battery cover. Speaker Hole DO NOT install screw! 11 Set up the Lock. 1. Open the door if it is not already open.2. Press the Outside Schlage Button.3. Enter one of the Default Access codes into the lock (see label shown in step 6 on page 5) . 4. The lock will perform a se...

15 ENGLISH 15 13 Continue to the User Guide. Your lock is installed and functional. Continue to the User Guide for complete information about how to configure and operate the lock and alarm. Questions about your new Schlage Sense ™ Smart Deadbolt ? Please don’t return it to the store! Let us help yo...

© Allegion 2015 Printed in U.S.A. P516-990 Rev. 07/15-b A NEW KIND OF KEYLESS. *P516-990* P516-990 If you have questions about any part of installation or programming, don’t return your Schlage Sense ™ to the store. Our Schlage Customer Service representatives are ready to help. Toll-free: 888-805-9...