Sanyo VSE-2400 - Manual - manualsarea.com

Page 2 - IMPORTANT SAFEGUARDS

2 IMPORTANT SAFEGUARDS 1. Read Instructions - All the safety and operating instructions should be read before the unit is operated. 2. Retain Instructions - The safety and operating instructions should be retained for future reference. 3. Heed Warnings - All warnings on the unit and in the operating...

Page 4 - Cylindrical Environmental Camera Housings; UNPACKING; Check for the following:

CONTENTS 1 UNPACKING . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4 2 SERVICE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4 3 CARE AND MAINTENANCE . . . . . . . . . . . . . . . .4 4 DESCRIPTION . . . . . . . . . . . . . . . . . . . . . . . . . . . .5 5 ACCESSORIES ...

Page 5 - MECHANICAL SPECIFICATIONS; ACCESSORIES

5 Model Number Preinstalled Heater orHeater/Blower 1 Voltage/Power (V/W) VSE-2300 --- VSE-2300H Heater 24/23 VSE-2300HB Heater/Blower 24/25 VSE-2400 --- VSE-2400H Heater 24/23 VSE-2400HB Heater/Blower 24/25 Model Number Maximum Camera and Lens Weight VSE-2300 2.68 W x 2.1 H x 10.5 L in(68 x 54 x 267...

Page 6 - INSTALLATION; TOOLS REQUIRED

6.3 Housing Mounting 1. Use the two 1/4-20 x 0.50-inch screws and 1/4-inch spring washers provided in the hardware kit to mount thehousing to a mount or a pan/tilt. The spring washers mustbe used for the screws to thread properly. 2. The outermost set of 1/4-20 threaded holes are for mounting to fee...

Page 7 - Camera/Lens Installation; Fittings

6.5 Camera/Lens Installation 1. Loosen the two screws holding the camera bracket to the base. It is not necessary to remove them completely. SeeFigure 3. Figure 3: Removing the Camera Bracket 2. Remove the camera bracket from the base. If you are using the feed-through feature, refer to Section 6.8....

Page 8 - Power Connections

3. The terminal block provided on /x0 units accepts wire ranging from 20 to 14 AWG or 1.5 mm 2 . The terminal block provided on /x1 units accepts wire ranging from 18to 12 AWG or 2.5 mm 2 . When using larger wire sizes, splice to a smaller size wire at the terminal block end.The splice may need to b...

Page 10 - Figure 10: Reinstalling the Cover

10 See Detail Cover Rib Top of Base Seal Figure 10: Reinstalling the Cover 3. As the cover nears the rear cap, make sure the captive screws in the back are not blocking the cover fromengaging into the rear cap. 4. Screw the two rear captive screws into the housing. 6.11 Fuse Replacement1. To replace...

Page 11 - EXCLUSIONS; ATTENTION; LABOR; SANYO INDUSTRIAL VIDEO; OBLIGATIONS

11 THIS WARRANTY IS VALID ONLY ON SANYO PRODUCTS PURCHASED OR RENTED IN THE UNITED STATES OF AMERICA,EXCLUDING ALL U. S. TERRITORIES AND PROTECTORATES. THIS WARRANTY APPLIES ONLY TO THE ORIGINAL RETAILPURCHASER OR END USER. THE ORIGINAL DATED BILL OF SALE, SALES SLIP OR RENTAL AGREEMENT MUST BE SUBM...

Sanyo VSE-2400 - Manual

Table of Contents:

Summary

Other Sanyo Models