Sanyo VSE-2400 - Manuals

6.3 Housing Mounting 1. Use the two 1/4-20 x 0.50-inch screws and 1/4-inch spring washers provided in the hardware kit to mount thehousing to a mount or a pan/tilt. The spring washers mustbe used for the screws to thread properly. 2. The outermost set of 1/4-20 threaded holes are for mounting to fee...

6.5 Camera/Lens Installation 1. Loosen the two screws holding the camera bracket to the base. It is not necessary to remove them completely. SeeFigure 3. Figure 3: Removing the Camera Bracket 2. Remove the camera bracket from the base. If you are using the feed-through feature, refer to Section 6.8....

3. The terminal block provided on /x0 units accepts wire ranging from 20 to 14 AWG or 1.5 mm 2 . The terminal block provided on /x1 units accepts wire ranging from 18to 12 AWG or 2.5 mm 2 . When using larger wire sizes, splice to a smaller size wire at the terminal block end.The splice may need to b...

10 See Detail Cover Rib Top of Base Seal Figure 10: Reinstalling the Cover 3. As the cover nears the rear cap, make sure the captive screws in the back are not blocking the cover fromengaging into the rear cap. 4. Screw the two rear captive screws into the housing. 6.11 Fuse Replacement1. To replace...

11 THIS WARRANTY IS VALID ONLY ON SANYO PRODUCTS PURCHASED OR RENTED IN THE UNITED STATES OF AMERICA,EXCLUDING ALL U. S. TERRITORIES AND PROTECTORATES. THIS WARRANTY APPLIES ONLY TO THE ORIGINAL RETAILPURCHASER OR END USER. THE ORIGINAL DATED BILL OF SALE, SALES SLIP OR RENTAL AGREEMENT MUST BE SUBM...