Sanyo VCC-4324 - Manual

PARTS NAMES Flange-back adjustment If the pick-up surface is not correctly positioned with relation to the lens focal point, the picture will be out offocus (in particular when using auto-iris power zoom lenses, sold separately). If that is the case, adjust theflange-back position as described below...

MOUNTING THE LENS Check the lens mount Do not use a lens if the length “ L ” is more than 5 mm. That may damage the camera and prevent proper installation. Installation of a DC type auto-iris lens (sold separately) A 1/3 inch CS mount type lens without EE amplifier circuit that only uses a DC power ...

CONNECTIONS Basic connection for monitoring or recording The peripheral devices (VCR, monitor, lens, etc.) and cables are sold separately. 1 Make the video signal connection between the camera and the monitor or time lapse VCR. 2 Insert the plug of this power cord into a wall outlet.The POWER indica...

SETTINGS Line phase adjustment When using a camera switcher to connect 2 cameras or more to onemonitor, there may be a vertical roll of the images when switched. Insuch a case, set as described below. 1 Set the SYNC switch to the L-L position. 2 Switch the display on the monitor from camera 1 to cam...

SETTINGS Lens iris adjustment If using a DC type auto-iris lens, you will need to set the LEVEL (VR301) volume when shooting in the conditions described below. L (counterclockwise): To decrease the contrast H (clockwise): To increase the contrast • If shooting simultaneously in a dark room and throu...

SETTINGS Electronic iris function setting Use a manual or fixed iris lens and set the lens aperture to theshortest F stop. Set the EI/BLC switch to the EI-ON position. Note: Please refer to the specifications for dynamic range of the electroniciris. CAUTION: • The electronic iris is suitable for nor...

SETTINGS C • B/W (color/black and white) switch setting This switch lets you select the timing of the automatic switching ofthe optical filter to color image or black and white image, accordingto the subject brightness. The default setting is “ L ”. Set the switch according to the brightness. (Fig. ...

SPECIFICATIONS Camera: Scanning system : NTSC standard TV system (525 TVlines, 30 frames/sec.) Interlace : PLL 2:1 interlace Image device : 1/3 inch solid state image deviceCCD Picture elements : 537 (H) x 505 (V) Effective picture elements : 510 (H) x 492 (V) Synchronizing system : Internal sync, L...