Page 2 - NOTICE
NOTICE FEDERAL EMISSION COMPONENT DEFECT WARRANTY and CALIFORNIAEMISSION CONTROL WARRANTY are applicable to only those enginescomplied with EPA (Environmental Protection Agency) and CARB (CaliforniaAir Resources Board) emission regulations in the U.S.A. AIR INDEX To show compliance with California e...
Page 3 - FEDERAL EMISSION COMPONENT DEFECT WARRANTY
FEDERAL EMISSION COMPONENT DEFECT WARRANTY EMISSION COMPONENT DEFECT WARRANTY COVERAGE This emission warranty is applicable in all States, except the State of California. Fuji Heavy Industries Ltd. and Robin America Inc., Wood Dale Illinois, (herein "ROBIN AMERICA")warrant to the initial ret...
Page 9 - FOREWORD; Thank you very much for purchasing a ROBIN ENGINE.; E H
FOREWORD Thank you very much for purchasing a ROBIN ENGINE. Your ROBIN ENGINE can supply the power to operate varioussorts of machines and equipment.Please take a moment to familiarize yourself with the properoperation and maintenance procedures in order to maximizethe safe and efficient use of this...
Page 10 - CONTENTS; SAFETY PRECAUTIONS
CONTENTS 1. SAFETY PRECAUTIONS ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ 1 2. COMPONENTS ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ 4 3. PRE-OPERATION CHECKS ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ 6 4. OPERATING YOUR ENGINE ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ...
Page 11 - SYMBOLS; Stay clear of the hot surface.
SYMBOLS Read the owner's manual. Stay clear of the hot surface. Exhaust gas is poisonous.Do not operate in an unventilated area. Stop the engine before refueling. Fire, open flame and smoking prohibited. On (Run) Plus ;positive polarity Off (Stop) Battery Engine oil Engine start (Electric start) Add...
Page 12 - EXHAUST PRECAUTIONS; FIRE PREVENTION; Please make sure you review each precaution carefully.
- 1 - EXHAUST PRECAUTIONS NNever inhale exhaust gasses. They contain carbon monoxide, acolorless, odorless and extremelydangerous gas which can causeunconsciousness or death. Never operate the engine indoors orin a poorly ventilated area, such astunnel, cave, etc. Exercise extreme care when operat-i...
Page 13 - NOTE
- 2 - SURROUNDINGS Operate the engine on a stable, levelsurface free of small rocks, loosegravel, etc. PROTECTIVE COVER Place the protective covers overthe rotating parts.If rotating parts such as the driveshaft, pulley, belt, etc. are leftexposed, they are potentiallyhazardous.To prevent injury, eq...
Page 17 - CHECK ENGINE OIL; OIL CAPACITY; CHECK FUEL
3. PRE-OPERATION CHECKS - 6 - CHECK ENGINE OIL Before checking or refilling engine oil, besure the engine is located on a stable, levelsurface and stopped. Do not thread the gauge into oil filler tocheck oil level. If the oil level is below the lower levelline on the dipstick, refill with the proper...
Page 18 - OPERATING YOUR ENGINE; RECOIL STARTER; STARTING; STOP SWITCH
4. OPERATING YOUR ENGINE - 7 - ON ON OFF Pull the starter handle slowly, untilresistance is felt.This is the "compression" point.Return the handle to its originalposition and pull swiftly. Do not pull out the rope all the way. After starting the engine, allow thestarter handle to return to i...
Page 19 - STOPPING; RUNNING
- 8 - STOPPING OFF ON OFF 1 Set the throttle lever at the lowspeed position and allow the engineto run at low speed for 2 or 3minutes before stopping. If the stop switch is installed on theengine.Set the stop switch to theposition "OFF or O ". If the stop switch is installed on amachine side...
Page 20 - EASY TROUBLESHOOTING; Is the engine switch set ON?
5. EASY TROUBLESHOOTING - 9 - WHEN ENGINE DOES NOTSTART: Perform the following checks beforeyou take the engine to your Robindealer. If you still have trouble after complet-ing the checks, take the engine toyour nearest Robin dealer. Is there enough compres-sion? 1. Pull the starter handle slowly an...
Page 21 - WARNING
- 10 - WARNING Wipe out spilled fuel carefullybefore checking.Place spark plug as far away fromspark plug hole as possible.Do not hold spark plug by handwhile checking. 1. Remove the spark plug and connect it to the plug cap.Pull the starter handle while ground-ing spark plug against engine bodyusin...
Page 22 - MAINTENANCE SCHEDULE; DAILY INSPECTION; PERIODIC MAINTENANCE
6. MAINTENANCE SCHEDULE - 11 - DAILY INSPECTION Before running the engine, check the following service items. PERIODIC MAINTENANCE Periodic maintenance is vital to safe and efficient operation of your engine.Check the table below for periodic maintenance intervals. IT IS ALSO NECESSARY FOR THE USER ...
Page 23 - Periodic Maintenance Schedule table
- 12 - NOTE : Replace rubber hoses for passage every one year. If and when fuel leakage isfound, replace hose at once. Periodic Maintenance Schedule table * Note 1 : Initial oil change should be performed after first twenty (20) hours of operation. Thereafter change oil every fifty (50) hours.Before...
Page 24 - NGK CMR6A; ENGINE OIL CHANGE
7. "HOW-TO" MAINTENANCE - 13 - INSPECTING THE SPARKPLUG Clean off carbon deposits on thespark plug electrode using a plugcleaner or wire brush. Check electrode gap.Adjust gap 0.7 mm to 0.8 mm (0.03 inches) Use a proper spark plug : NGK CMR6A 0.7 to 0.8 mm(0.03 in.) ENGINE OIL CHANGE Initial ...
Page 25 - ADJUSTING CARBURETOR; Adjusting idling rpm
- 14 - 3) Remove the oil gauge, then tilt the engine and drain the oil into a pan orother receptacle. 4) Put the engine on a level surface, then fill with the oil up to the point ofoverflowing the filler neck. Pour theoil in from a squeeze bottle or otherappropriate. 5) After filling the engine with...
Page 27 - FUEL PIPE REPLACEMENT
- 16 - FUEL PIPE REPLACEMENT Replace the fuel pipe every 1 year. If the fuel leakage is found on the fuelpipe, replace it immediately. CHECKING BOLTS, NUTSAND SCREWS Retighten loose bolts and nuts. Check for fuel and oil leaks.Replace damaged parts with new ones.Keep safety in your mind. EH025/035取説...
Page 28 - PREPARATIONS FOR STORAGE; ENGINE OIL; CLEAN AND STORE
8. PREPARATIONS FOR STORAGE - 17 - ENGINE OIL Change the engine oil with fresh oil. Remove the spark plug, pour about 2cc engine oil into the cylinder, slowlypull the starter handle of the recoilstarter 2 or 3 times, and tighten thespark plug. CLEAN AND STORE Slowly pull the recoil starter handleunt...
