Rinnai INF26TL50M - User Manual

Table of Contents:

• Page 2 – This page is intentionally blank
• Page 3 – OPERATION TABLE OF CONTENTS; Warnings & Important Information; Notice to Victorian Consumers ������������������������������������������������������������������������������������������������������������������������������������������ 4; Water Temperature Control; Water Controller Combinations & Configurations; Wired Only Configurations; Trouble Shooting; No power display Wireless Water Controller (when fitted); Installation Table of Contents
• Page 4 – REGULATORY INFORMATION; WARNINGS & IMPORTANT INFORMATION
• Page 5 – Operational Safety Information; To clean your water controller(s) use a soft damp cloth; temperatures displayed at the water controller(s) and; DO NOT; having a shower or filling a bath.
• Page 6 – similarly qualified persons in order to avoid a hazard.
• Page 7 – Up to four water controllers can be fitted. See page 9 for details.; Infinity 26 Touch
• Page 8 – MAXIMUM DELIVERY TEMPERATURES; as a licensed plumber�; OPERATION WITHOUT WATER CONTROLLERS; controllers that can be fitted to your water heater model.; Location; outside of the shower recess�; WATER TEMPERATURE CONTROL
• Page 9 – Temperature Control; WATER CONTROLLER COMBINATIONS & CONFIGURATIONS
• Page 10 – required temperature is displayed on the digital monitor.; MUST NOT; MUST; of priority will; NOT; to supply hot water once a hot water tap is opened�
• Page 11 – until the required temperature is; installation configuration.; Indicates that Smartstart; Used to start and stop; PREHEAT
• Page 12 – ERROR CODES; TROUBLE SHOOTING
• Page 13 – installation errors or operation errors are; located on the left hand side of the appliance�
• Page 14 – Installation Configurations; Water Controller Installation; Additional Programming & Activation Requirements; Commissioning 24; INSTALLATION TABLE OF CONTENTS
• Page 15 – Location of the appliance flue terminal; Mounting Of Appliance; GENERAL INSTALLATION INFORMATION
• Page 16 – fitted to the cold water and gas inlets.; be fitted directly to the appliance.; Pipe Sizing; regulator; MUST BE; specified for this gas rate.; Water Supply; in Table 2 must be supplied�
• Page 17 – HOT WATER DELIVERY TEMPERATURE; Local regulations and or the requirements of AS/NZS 3500; Diagram 1 : 50°C Appliance; a 50°C Appliance
• Page 18 – APPLIANCE FLUE TERMINAL; FLUEING
• Page 19 – Horizontal Obstructions; Sideways Flue Diverter; When a Sideways Flue Diverter is to be fitted the installer; When a Sideways Flue Diverter is fitted; from AS/NZS 5601) dimension ‘h’ on page 18 does; Factory Default
• Page 20 – GENERAL INFORMATION; ONLY; A maximum of 4 water controllers can be fitted.; WATER CONTROLLER INSTALLATION
• Page 21 – be installed where chemicals such as benzene, alcohol,; Rinnai supplied
• Page 22 – shown allowing sufficient cable length so that
• Page 23 – Are there four water controllers connected?; You will need to activate the fourth water controller as follows:; temperatures higher than 50°C�; water controller fitted in a bathroom), repeat
• Page 24 – TESTING; for details�; If water controllers are not fitted, simply open; ALL; Ensure building occupants; circumstances it; to deliver a maximum temperature not exceeding 50°C. For fine; For All Other Models; COMMISSIONING
• Page 25 – DOES NOT; require; hand side of the water heater�
• Page 26 – TABLE 1. APPLIANCE DIMENSIONS; Touch; DIAGRAM 1. DIMENSIONS; Infinity Series; SPECIFICATIONS
• Page 27 – TABLE 3. MAXIMUM DELIVERY TEMPERATURES; Delivery; TABLE 4. OTHER ACCESSORIES; CAGE
• Page 28 – Rinnai Australia Pty Ltd