Rinnai EHPA315VM - User Manual

Table of Contents:

• Page 2 – including local OH&S requirements
• Page 3 – Warnings and Important Information; System Specifications; Installation; TABLE OF CONTENTS
• Page 4 – SAFETY AND REGULATORY INFORMATION; source, there is a possibility of ignition.; MANDATORY INSPECTION PRIOR TO INSTALLATION; installation or operation of damaged or incorrect appliances.; NOTICE TO VICTORIAN CONSUMERS; WARNINGS AND IMPORTANT INFORMATION
• Page 5 – TRANSPORT AND STORAGE OF APPLIANCE; The refrigerant used in the heat pump is a flammable gas.; IMPORTANT; IMPORTANT; mounts and associated piping
• Page 6 – SCALD HAZARDS
• Page 7 – OPERATION PRINCIPLE; Plate Heat Exchanger
• Page 8 – SAFETY DEVICES; DO NOT tamper with or remove safety devices.; leakage of water from the valve and its drain line may indicate a; dislodge any foreign matter and alleviate the problem.
• Page 9 – HYDROGEN GAS; TURNING ON THE WATER HEATING SYSTEM
• Page 10 – marked “Hot water” or “Water heater” is turned on. (note that the; SAVE A SERVICE CALL
• Page 11 – consumption; See entry under the heading ‘Insufficient or no hot water’; HighElectricityTariffs; electricity supplier to confirm what these tariffs are.; Higher Element Usage; More than one or two hot taps in use at the same time may cause a; the premises; a pressure limiting valve and water hammer arrestor as required.
• Page 12 – SYSTEM SPECIFICATIONS; SPECIFICATIONS
• Page 13 – DIMENSIONS; Height; Cold Inlet
• Page 14 – CLEARANCES; flow through the fan.
• Page 15 – AS/NZS 3500 National Plumbing and Drainage; LOCATION; which minimize the waiting time for hot water delivery.; INSTALLATION
• Page 16 – WATER SUPPLY; to comply with local regulations.; STORAGE TEMPERATURE; the water in the tank to 60°C once a week. This cannot be altered.; HOT WATER DELIVERY TEMPERATURE; all solar hot water systems as detailed below.; VALVES AND FITTINGS; that it is fitted by the installer in all installations.
• Page 17 – TRANSPORT AND HANDLING; When moving the unit, it must be close to vertical at all times.; POSITIONING THE HEAT PUMP
• Page 18 – CONNECT THE PTR VALVE; ‘Dimensions’ on page 13.; PLUMBING CONNECTIONS
• Page 19 – CONNECT COLD / HOT WATER SUPPLY; A stop cock, non return valve and line strainer MUST BE fitted.; Drain
• Page 20 – CONNECT CONDENSATE DRAIN LINE; Condensate; ELECTRICAL CONNECTIONS; specification table for load details.; a mandatory requirements in some states or jurisdictions).
• Page 22 – FILLING THE SYSTEM; Bleed any remaining air from the PTR valve.; Automatic; FINISHING THE INSTALLATION
• Page 23 – OPERATION SEQUENCE OF CONTROLLER; DIP Switch Test & Configuration
• Page 24 – CONTROLLER LED FLASHING CODES; Compressor Discharge Sensor ≥ 110° C
• Page 25 – NOTES
• Page 28 – CONTACT; Rinnai Australia Pty Ltd; National Help Line