Ridgid R82007 - Manual

6 SYMBOLS SERVICE Servicing requires extreme care and knowledge and should be performed only by a qualified service technician. For service we suggest you return the product to your nearest AUTHORIZED SERVICE CENTER for repair. When servic-ing, use only identical replacement parts. WARNING: To avoid...

7 FEATURES PRODUCT SPECIFICATIONS Chuck ...........................................................3/8 in. KeylessMotor .................................................................. Volt DCSwitch .......................................................... Variable Speed No Load Speed ..............

8 FEATURES kNOW YOUR DRILL See Figure 1. The safe use of this product requires an understanding of the information on the product and in this operator’s manual as well as a knowledge of the project you are attempting. Before use of this product, familiarize yourself with all operating fe atures and ...

9 OPERATION WARNING: Do not allow familiarity with products to make you careless. Remember that a careless fraction of a second is sufficient to inflict severe injury. WARNING: Always wear safety goggles or safety glasses with side shields when operating products. Failure to do so could result in ob...

0 OPERATION Fig. 3 DIRECTION OF ROTATION SELECTOR (FORWARD/REVERSE/CENTER LOCK) FORWARD VARIABLE SPEED SWITCH TRIGGER WARNING: Battery tools are always in operating condition. Therefore, switch should always be locked when not in use or carrying at your side. SWITCH TRIGGER See Figure 3. To turn the...

OPERATION ADJUSTABLE TORQUE CLUTCH This product is equipped with an adjustable torque clutch for driving different types of screws into different materials. The proper setting depends on the type of material and the size of screw you are using. ADJUSTING TORQUE See Figure 5. There are eighteen torqu...

OPERATION INSTALLING BITS See Figures 7 - 8.  Lock the switch trigger by placing the direction of rotation selector in the center position.  Open or close the chuck jaws to a point where the opening is slightly larger than the bit size you intend to use. Also, raise the front of the drill slightly...

3 OPERATION Fig. 9 Fig. 0 WRONG RIGHT WARNING: Be prepared for binding at bit breakthrough. When these situations occur, drill has a tendency to grab and kick opposite to the direction of rotation and could cause loss of control when breaking through material. If not prepared, this loss of control c...

4 MAINTENANCE BATTERY PACk REMOVAL AND PREPARATION FOR RECYCLING To preserve natural resources, please r e c y c l e o r d i s p o s e o f b a t t e r i e s properly.This product contains lithium-ion batteries. Local, state or federal laws may prohibit disposal of lithium-ion batteries in ordinary t...

5 WARRANTY Proof of purchase must be presented when requesting war-ranty service. Limited to RIDGID ® hand held and stationary power tools purchased //04 and after. This product is manufactured by One World Technologies, Inc. The trademark is licensed from RIDGID, Inc. All warranty communications sh...

6 OPERATOR’S MANUAL 3/8 in. 12 V LITHIUM-ION DRILLREVERSIBLE R82007 Customer Service Information: For parts or service, contact your nearest RIDGID authorized service center. Be sure to provide all relevant information when you call or visit. For the location of the authorized service center nearest...