Ridgid R7130 - Manual

6 SYMBOLS The following signal words and meanings are intended to explain the levels of risk associated with this product. Indicates an imminently hazardous situation, which, if not avoided, will result in death or serious injury. Indicates a potentially hazardous situation, which, if not avoided, c...

7 DOUBLE INSULATION Double insulation is a concept in safety in electric power tools, which eliminates the need for the usual three-wire grounded power cord. All exposed metal parts are isolated from the internal metal motor components with protect-ing insulation. Double insulated tools do not need ...

8 FEATURES Fig. 1 THREE POSITION BAIL HANDLE CHUCK SWITCH TRIGGER FORWARD/REVERSE SWITCH PRODUCT SPECIFICATIONS Drill ........................................................................... 1/2 in.Switch..........................................Single Speed/ReversibleNo Load Speed .................

9 FEATURES KNOW YOUR RIGHT ANGLE DRILL See Figure 1. Before attempting to use this product, familiarize yourself with all operating features and safety rules. CHUCK KEY A chuck key has been provided for use when installing or removing bits and removing the chuck. When not in use, the chuck key can b...

10 INSTALLING THE PIPE HANDLE See Figure 2. n Unplug the drill. n Insert the pipe handle into the 3/4 NPT threaded hole on the side of the drill. n Turn the handle clockwise to securely hand-tighten the handle. n The pipe handle may be installed either on the left or right side of the drill. INSTALL...

11 OPERATION WARNING: Do not allow familiarity with tools to make you careless. Remember that a careless fraction of a second is sufficient to inflict severe injury. WARNING: Always wear safety goggles or safety glasses with side shields when operating tools. Failure to do so could result in objects...

12 SWITCH TRIGGER See Figure 6. To turn the drill ON , depress the switch trigger. Release switch trigger to turn the drill OFF . FORWARD/REVERSE SWITCH See Figure 6. The direction of chuck rotation is reversible and is controlled by a forward/reverse switch located on the handle of the drill. NOTE:...

13 BIT SELECTION WARNING: Do not use bits larger than the ones listed for HIGH (3) speed in the chart below when drilling at HIGH speed. Using a bit that is too large for high speed applications can result in serious personal injury and can cause damage to the tool. OPERATION BIT BINDING See Figure ...

14 DRILLING See Figures 9 - 11. n Attach the pipe handle. n Select the appropriate position for the bail handle. n �Set the speed selector at the desired speed for the type of bit you are using. n Check the direction of rotation lever for correct setting (forward or reverse). n Be sure the material ...

15 MAINTENANCE WARNING: This tool should never be con nect ed to a power supply when you are performing main te nance. Disconnecting the tool will pre vent ac ci den tal starting that could cause serious in ju ry. BRUSH REPLACEMENT See Figure 12. The drill has externally accessible brush assemblies ...

16 MAINTENANCE Fig. 13 CHUCK REMOVAL See Figures 13 - 15. To remove the chuck: n Unplug the drill. n Select LOW (1) speed. n Open chuck jaws using the provided chuck key. n Insert a 3/8 in. or larger hex key wrench into the chuck of the drill and tighten the chuck jaws se cure ly. n Tap the hex key ...

17 WARRANTY Proof of purchase must be presented when requesting war-ranty service. Limited to RIDGID ® hand held and stationary power tools purchased 2/1/04 and after. This product is manufactured by One World Technologies, Inc. The trademark is licensed from RIDGID, Inc. All warranty communications...

18 983000-649 2-05 Customer Service Information: For parts or service, con tact your near est RIDGID authorized service center. Be sure to pro vide all rel e vant information when you call or vis it. For the lo ca tion of the au tho rized ser vice cen ter nearest you, please call 1-866-539-1710 or v...