Ridgid R5011 - Manual

6 SYMBOLS SERVICE Servicing requires extreme care and knowledge and should be performed only by a qualified service technician. For service we suggest you return the product to your nearest AUTHORIZED SERVICE CENTER for repair. When servic- ing, use only identical replacement parts. WARNING: To avoi...

7 DOUBLE INSULATION Double insulation is a concept in safety in electric power tools, which eliminates the need for the usual three-wire grounded power cord. All exposed metal parts are isolated from the internal metal motor components with protect-ing insulation. Double insulated tools do not need ...

8 Fig. 1 FEATURES PRODUCT SPECIFICATIONS Chuck Capacity ......................................................... 1/2 in. Input .................................120 V, 60 Hz, AC only, 8.5 AmpsSwitch ...............................VSR (Variable Speed Reversible) Hammer Speed ............................

10 DEPTH STOP ROD ASSEMBLY INSTALLING AUXILIARY HANDLE ASSEMBLY See Figure 2. An auxiliary handle is packed with the drill for ease of op-eration and to help prevent loss of control.  Open the clamping ring by turning the handle counter-clockwise.  Slide the ring of the auxiliary handle onto the s...

11 OPERATION WARNING: Do not allow familiarity with tools to make you careless. Remember that a careless fraction of a second is sufficient to inflict severe injury. WARNING: Always wear safety goggles or safety glasses with side shields when operating tools. Failure to do so could result in objects...

12 OPERATION Fig. 6 TWO-SPEED GEAR SHIFT KNOB RIGHT Fig. 7 WRONG Fig. 8 DRILL BIT TO TIGHTEN CHUCK JAWS TWO-SPEED GEAR SHIFT KNOB See Figure 6. The drill has a two-speed gear train designed for drilling or driving at LO (1) or HI (2) speeds. A switch is located on the side of the drill to select eit...

13 DEPTH STOP ROD DRILL BIT TO DECREASE DRILLING DEPTH AUXILIARY HANDLE ASSEMBLY TO INCREASE DRILLING DEPTH DRILLING DEPTH DEPRESS HERE TO ADJUST DEPTH STOP ROD OPERATION SELECTING HAMMER MODE OR DRILLING MODE See Figure 10. To adjust for type of drilling, slide the selector on top of the motor hous...

14 OPERATION WARNING: Before connecting the drill to a power supply source, always check to be sure it is not in lock-on position (depress and release the switch trigger). Failure to ensure that it is not locked-on could result in accidental starting of the drill resulting in possible serious injury...

15 WOOD DRILLING� For maximum performance, use high speed steel bits for wood drilling.�  Select normal drilling mode.�  Begin drilling at a very low speed to prevent the bit from slipping off the starting point. Increase the speed as the drill bit bites into the material.�  When drilling through...

16 MAINTENANCE CHUCK REMOVAL See Figures 14 - 16. The chuck may be removed and replaced with a new one.  Unplug the drill.  Open chuck jaws using the provided chuck key.  Insert a 5/16 inch (8 mm) or larger hex key into the chuck of the drill and tighten the chuck jaws securely.  Tap the hex key...

17 WARRANTY Proof of purchase must be presented when requesting warranty service. Limited to RIDGID ® hand held and stationary power tools purchased 2/1/04 and after. This product is manufactured by One World Technologies, Inc. The trademark is licensed from RIDGID, Inc. All warranty communications ...

20 OPERATOR’S MANUAL 1/2 in. HAMMER DRILL DOUBLE INSULATEDR5011 Customer Service Information: For parts or service, contact your nearest RIDGID authorized service center. Be sure to provide all relevant information when you call or visit. For the location of the authorized service center nearest you...