Ridgid R5010 - Manual

6 SPECIFICATIONS Chuck Capacity ......................................................................................................................................... 1/2 in. (13 mm) Input ...............................................................................................................

7 UNPACKING Instructions Your drill has been shipped completely assembled. Carefully remove the tool from the box. Make sure that all items listed in the packing list areincluded. Inspect the tool carefully to make sure no breakageor damage occurred during shipping. Do not discard the packing materi...

8 Before using this product, familiarize yourself with alloperating features and safety requirements. However, donot let familiarity with the tool make you careless. WARNING: Exercise caution when using this tool. Carelessactions, for even a fraction of a second, can resultin serious personal injury...

9 OPERATION WARNING: Always wear safety goggles or safety glasses withside shields when operating this tool. Failure to doso could result in dust, shavings, or loose par-ticles being thrown into your eyes, resulting inpossible serious injury. SWITCH See Figure 2. To turn your drill ON , depress the ...

10 OPERATION Fig. 5 TO INCREASE SPEED, PULL SWITCH TRIGGER VARIABLE SPEED See Figures 5 & 8. Your drill has a variable speed dial designed to allowoperator control of speed and torque limits. The speedand torque of your drill can be increased by turning thedial on top of the drill.Avoid running ...

11 OPERATION ADJUSTING THE AUXILIARY HANDLEASSEMBLY See Figure 7. Follow these steps to adjust the auxiliary handle assembly. Loosen the auxiliary handle assembly by turning theknob counterclockwise. Rotate the auxiliary handle assembly to the desiredlocation. Tighten the auxiliary handle assembly s...

12 OPERATION TO INSTALL BITS See Figures 10 and 11. Unplug your drill. WARNING: Failure to unplug your drill could result in acciden-tal starting causing serious injury. Open or close the chuck jaws to a point where theopening is slightly larger than the drill bit you intendto use. Also, raise the f...

13 OPERATION DRILLING See Figure 12. Depress and release switch trigger to be sure yourdrill is in OFF position before connecting it to power supply. Check the direction of rotation lever for correctsetting (forward or reverse). See Figure 4. Secure the material to be drilled in a vise or withclamps...

14 CHUCK REMOVAL See Figure 13. The chuck must be removed in order to use someaccessories. To remove: Unplug your drill. WARNING: Failure to unplug your drill could result in acciden-tal starting causing serious injury. Using two open-end wrenches, loosen the chuck. See Figure 13. This will loosen t...

15 MAINTENANCE GENERAL Avoid using solvents when cleaning plastic parts. Mostplastics are susceptible to damage from various types ofcommercial solvents and may be damaged by their use.Use clean cloths to remove dirt, carbon dust, etc. WARNING : Do not at any time let brake fluids, gasoline,petroleu...

WARRANTY 16 This product is manufactured under license from Ridgid,Inc. by One World Technologies, Inc. All warrantycommunications should be directed to One WorldTechnologies, Inc. at (toll-free) 1-866-539-1710. 9 0 - D A Y S A T I S F A C T I O N G U A R A N T E EPOLICY During the first 90 days aft...

Customer Service Information For parts or service, contact your nearest Ridgid authorized service center. Be sure to provide all relevant informationwhen you call or visit. For the location of the authorized service center nearest you, please call 1-866-539-1710 or visitus online at www.ridgidwoodwo...