Page 2 - Thank-you for purchasing a; REGENCY FIREPLACE PRODUCT.; for local considerations.; REGENCY FIRES
Regency Z2510 WarmHearth 2 Thank-you for purchasing a REGENCY FIREPLACE PRODUCT. The pride of workmanship that goes into each of our products will give you years of trouble-free enjoyment. This product has been certifi ed by the Environmental Protection Agency of the United States. This means that it...
Page 3 - TABLE OF CONTENTS; SAFETY LABEL
Regency Z2510 WarmHearth 3 TABLE OF CONTENTS SAFETY LABEL Safety Label for Z2510L ................................................ 4 INSTALLATION The Regency Warmhearth ............................................ 5Product Details .............................................................. 5Optio...
Page 5 - INSTALLATION; OPTIONS
Regency Z2510 WarmHearth 5 THE REGENCY WARMHEARTH 1) Optional 24 Karat Gold-plated Louvers 2) Clean Glass Air Wash System 3) High Safety Ceramic Glass 4) Optional 24 Karat Gold-plated Door 5) Andirons 6) Convection Air Inlet 7) Optional 150 CFM 2-speed Blower 8) Convection Chamber 9) Secondary Air S...
Page 6 - READ BEFORE YOU INSTALL; DIMENSIONS AND
Regency Z2510 WarmHearth 6 Unit Dimensions INSTALLATION 8) NEVER leave children unattended when there is a fi re burning in the fi replace. 9) Allow the fi replace to cool before servicing. Always shut off any electricity to the fi replace while working on it. This will prevent any possible electrical s...
Page 7 - No Combustibles on Face of Unit; CLEARANCES AND
Regency Z2510 WarmHearth 7 Framing Specifi cations No Combustibles on Face of Unit Combustibles May Not Extend to Unit Face Do not notch wallboard around standoffs Clearances to Combustibles INSTALLATION requires a minimum 2 in. (50 mm) clearance. A combustible mantle (to a depth of 10 in.) may be in...
Page 8 - HEARTH EXTENSION; FRAMING DETAILS
Regency Z2510 WarmHearth 8 HEARTH EXTENSION Note: When the unit is raised 4 inches above the fl oor the Regency Hearth Extension (Part# 000-910) is not required. If you plan to raise the fi replace and hearth extension, build the platform assembly then position fi replace and hearth extension on top. I...
Page 9 - Chimney Height
Regency Z2510 WarmHearth 9 Ventilated Chase Pan In Canada: Any factory built chimney listed and certifi ed to ULC-S629. Also any of the following chimney covered by ULC-S610 or ULC S604. 1) GSW Heating Products Model JFC 2) Oliver McLeod Ltd. Model PRO-JET3103 3) Security Chimney Ltd. Model ASHT 4) S...
Page 10 - ASSEMBLY STEPS; INSTALLING THE; Installation Components
Regency Z2510 WarmHearth 10 INSTALLATION ASSEMBLY STEPS Note: The following steps represent the nor- mal sequence of installation. Each installation is unique, however, and might require different steps. Each step is dealt with in detail in the fol-lowing pages. 1) Install stand-offs and insulation ...
Page 11 - SET THE
Regency Z2510 WarmHearth 11 or platform for support and to prevent cold air from entering the room from under the fi replace, if against an outside wall. The fi replace may be positioned and then the framing built around it, or the framing may be constructed and the fi replace positioned into the openi...
Page 12 - MINIMUM RECOMMENDED FLUE HEIGHTS IN FEET; Offset Chimney Installation
Regency Z2510 WarmHearth 12 be closed during regular operation because the unit uses outside air for combustion, not room air. 2) Multiple Terminations. When you install more than one chimney in the same chase or within the same general area, we suggest that their terminations be separated by at lea...
Page 13 - WIRING THE WARMHEARTH; OPTION 1; INSTALLING THE BLOWER SYSTEMS
Regency Z2510 WarmHearth 13 INSTALLING THE OUTSIDE AIR KIT Combustion air is fed to the fi rebox through a connection on the rear lower left side of the unit. A free fl owing supply of air must be available to this opening at all times. Combustion air may be taken from inside the building if the local...
Page 14 - GRAVITY AIR FEED KIT OPTION
Regency Z2510 WarmHearth 14 INSTALLATION GRAVITY AIR FEED KIT OPTION The Gravity Air Feed Kit is designed to extend the heat output vent above the WarmHearth or to the front or the side. The upper louver opening is blocked off and fl ex duct is connected to the vent holes in the top of the unit and r...
Page 15 - INSTALLING YOUR; Installation
Regency Z2510 WarmHearth 15 Central Heat Option Use high temperature silicone to seal the block-off plate to the unit. If necessary drill extra holes in the plate and the unit and secure with extra screws. Note: Make sure the block-off plate is fl ush and fastened tightly to the WarmHearth. Important...
Page 17 - Completing the Facing; Facades Installation; Masonry Retainer Kit Option
Regency Z2510 WarmHearth 17 2" (51mm) x 4" (102mm) aaaaaaaa aaaaaaaa aaaaaaaa aaaaaaaa aaaaaaaa aaaaaaaa aaaaaaaa aaaaaaaa aaaaaaaa aaaaaaaa aaaaaaaa aaaaaaaa aaaaaaaa aaaaaaaa aaaaaaaa aaaaaaaa aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa aaaaaaaaaaaaaaaaaaaaaaaaaaa...
Page 18 - Finishing Details; Completing the Mantle
Regency Z2510 WarmHearth 18 Top View Top View INSTALLATION Top View 4) Place side metal fi ller strips in between stove and framing to cover the stand-off space. Fit the strips behind "A" so that they cover the stand-offs, and will prevent mortar from falling through the mesh. 5) Center door ...
Page 19 - Draft Control
Regency Z2510 WarmHearth 19 INSTALLATION MASONRY LINER/ BRICKS Insulated refractory panels are included to extend the life of the fi replace and help radiate heat more evenly. Make sure Insulating Paper is in place along the bottom, side and rear before bricks are put into place. Insulation batt, 1 i...
Page 20 - MAINTENANCE; Gold Plated Doors and Louvers; SAFETY GUIDELINES
Regency Z2510 WarmHearth 20 MAINTENANCE MAINTENANCE Gold Plated Doors and Louvers The optional gold electroplated fi nish on the doors and louvers requires little maintenance and needs only to be cleaned with a damp cloth. DO NOT use abrasive materials or chemical cleaners, as they may harm the fi nis...
Page 21 - PARTS LIST
Regency Z2510 WarmHearth 21 PARTS LIST PARTS LIST- FIREBOX & BODY Part # Description Part # Description 20) 948-102 Spring Handle - Small 21) 000-198 Hearth Extension Connector 22) * Shell Inner Sides & Back 23) * Insulation - Right 24) * Insulation - Rear 25) * Insulation - Rear - 6" wi...
Page 23 - WARRANTY
Regency Z2510 WarmHearth 23 WARRANTY Regency Fireplace Products are designed with reliability and simplicity in mind. In addition, our internal Quality Assurance Team carefully inspects each unit thoroughly before it leaves our door. FPI Fireplace Products International Ltd. is pleased to extend thi...
Page 24 - Installer: Please complete the following information; Printed in Canada
Installer: Please complete the following information Dealer Name & Address: ______________________________________________ ___________________________________________________________________ Installer: ___________________________________________________________ Phone #: _________________________...
