RCA AVC 776 - Manual - manualsarea.com

Page 2 - Safety Warning; operation may cause permanent damage.

2 Thank you for choosing this high quality Digital Multiplex Recorder. The DMR converts analog NTSC or PAL video to digital images and records them to a removable hard disk drive. Digitally recorded video has many advantages compared to analog video recorded on tape. There is no need to adjust track...

Page 3 - Full Screen; Specifications

3 Full Screen Quad 7 CH 9 CH 10 CH 13 CH 16 CH Full screen 704(H) x 468(V) <NTSC> / 704(H) x 564(V) <PAL> 4 channels 352(H) x 234(V) <NTSC> / 352(H) x 282(V) <PAL> 9 channels 224(H) x 156(V) <NTSC> / 224(H) x 188(V) <PAL> 1.2.6 Independent main and call monitor ou...

Page 4 - Package contents

4 Audio input 4 audio inputs, (RCA) Audio output 2 audio outputs, (RCA) Motion Detect Area 15 * 12 targets per camera (NTSC) / 15 * 14 targets per camera (PAL) Motion Detect Sensitivity 256 Levels Video Loss Detection Yes Refresh Rate 72 images/sec. for NTSC / 60 images/sec. for PAL Recording Rate 2...

Page 6 - You can use the PC keyboard to simulate DMR keypad.; ENTER

6 2.4 RS232 Remote Protocol You can use the PC keyboard to simulate DMR keypad. DATA: REMOTE PROTOCOL using 8 bit data 、 1 start bit 、 1stop bit ACT C0H ID FUNCTION STOP (FFH) (7FH) FUNCTION FUNCTION FUNCTION FUNCTION CODE CODE CODE CODE AS AS AS ASC C C CII II II II FUNCTION FUNCTION FUNCTION FUNCT...

Page 7 - will not operate properly.; Front panel keypad

7 3.1.3 Key lock Status Segment Power status Security status A ON Locked (Irremovable) B OFF Unlocked (Removable) You must turn key lock to “ A ” position before powering on the unit. Otherwise HDD will not operate properly. 3.1.4 The Record Time is different based on Record Speed and Record Quality...

Page 9 - Back panel connection

9 12. POWER : To power on, press power button. To power off, press power button again. 13. FF / Right : FF : Under DMR play mode, it can play video forward at high speed, and press FF again to adjust speed from 1, 2, 4, 8, 16, 32 times. Right : Under setup mode , it can work as Right button. 14. PAU...

Page 13 - ► SEARCH

13 PIN 21. PIN OFF PIN 22. ALARM INPUT 9 To connect wire from ALARM INPUT 9 ( PIN 22 ) to GND ( PIN 1 ) connector, DMR will start recording and buzzer will be on. When Menu/ Camera/ Alarm is set up to “Low” : When alarm input signal is “ Low ”, the unit starts to record and buzzer. When Menu/ Camera...

Page 14 - INT AUDIBLE ALARM : ON

14 Press ”MENU” to enter main menu. You will need to enter password to access main menu. Press “ Right ” “ Left ” to move digit, and Press ” Up ” “ Down ” to select number. Press ”ENTER” button to confirm password. Ex.: PASSWORD : 0000 (Default : 0000) PASSWORD : 0000 After keying in correct passwor...

Page 19 - SEARCH setup

19 3.5.15.3 Press ” Up ” or “ Down ” to choose BAUD RATE setup 115200 、 57600 、 19200 、 9600 、 4800 、 3600 、 2400 、 1200 3.5.15.4 Press ” MENU ” to exit and confirm current operation. 3.5.15.5 Press ” MENU ” again to exit and close SYSTEM setup mode. 3.5.16 Remote protocol ID setup: This device allo...

Page 22 - SEARCH

22 Press “ ENTER ” to confirm Full List, and the screen will be as right displayed. Press ” Up ” or “ Down ” to choose the wanted date & hour for recorded event , and press “ Left ” or “ Right ” to change the location. Press “ ENTER” to play select time recorded video. If there is no record in t...

Page 24 - RECORD QUALITY : NORMAL

24 Press ”MENU” to enter main menu. You will need to enter password to access main menu. To press “ Left ” or “ Right ” to move digit, and to press ” Up ” or “ Down ” to select number. To press ” ENTER ” button to confirm password. Ex.: PASSWORD: 0000 (Default: 0000) PASSWORD: 0000 After keying in c...

Page 26 - CAMERA setup; TITLE

26 3.9 CAMERA setup Press ”MENU” to enter main menu. You will need to enter password to access main menu.Press “ Left ” or “ Right ” to move digit, and to press ” Up ” or “ Down ” to select number. To press ” ENTER ” button to confirm password. Ex.: Password : 0000 (Default : 0000) PASSWORD : 0000 A...

Page 28 - MOTION DETECTION setup

28 EVENT : when alarm input is triggered, VCR will record alarming channel more frequently. For example : VCR normal record method is 1-2-3-4-5-……-9. In Event mode, when CH01 is triggered, the record method will become 1-2-1-3-1-4-1-5-…-9. NORMAL : when external alarm is on, VCR will record normally...

Page 29 - function same as Live video in the above mentioned.; Figure 1; LINE

29 cameras, but if the motion is detected on Camera #1, the sequence to scan #1 camera will be more frequently. It will be scanning as 1st, 2nd, 1st, 3rd, 1st, 4th...1st, 9th. The motion-detected camera will be scanned more frequently, which will be one after another camera been detected. If 2nd cam...

Page 30 - MOTION DETECTION SETUP –; ALL

30 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 032 -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- Figure 1-3 MOTION DETECTION SETUP – ALL 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 032 -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- 3.11 Event 3.11.1 Enter “ Event “ list Press ”MENU” to enter main menu. You will need t...

Page 36 - Compatible HDD brands; and proven compatible with this appliance.

36 Compatible HDD brands Note 1: The models and manufactures of HDD listed above have been tested and proven compatible with this appliance. Note 2: Please remove hard disk drive ONLY after power was shut off for more than 60 seconds. This would protect and extend the operating life of the hard disk...

RCA AVC 776 - Manual

Table of Contents:

Summary

Other RCA Models