Raypak D2 - Manual
Raypak D2 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Venting
- Page 3 – Pay Attention to These Terms; CONTENTS
- Page 5 – Mounting the Assembly; Table A: Draft Assembly Application and Kit Numbers
- Page 6 – Mount the Power Vent on the outer top.; TABS
- Page 7 – Table B: Vent/Air Inlet Termination Clearances
- Page 8 – For all; Table C: Reduced Maximum Equivalent Vent Run; LEFT SIDE; DIAMETER
- Page 9 – PRESSURE
- Page 12 – Dimensional Data; Model; Table D: Dimensional Data
- Page 13 – Set operating control to call for heat.; Draft Proving Switch; NEGATIVE PRESSURE
- Page 14 – Illustrated Par ts List
INSTALLATION & OPERATING
INSTRUCTIONS
CATALOG NO. 6000.57F
Effective: 12-02-08
Replaces: 5-20-08
P/N 241086 Rev. 7
WARNING:
If these instructions are not followed exactly, a fire or explosion may
result causing property damage, personal injury or death
.
FOR YOUR SAFETY:
Do not store or use gasoline or other flammable vapors and
liquids or other combustible materials in the vicinity of this or any other appliance. To
do so may result in an explosion or fire.
WHAT TO DO IF YOU SMELL GAS:
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use any phone in your building.
• Immediately call your gas supplier from a neighbor's phone. Follow the gas
supplier's instructions.
• If you cannot reach your gas supplier, call the fire department.
Installation and service must be performed by a qualified installer, service agency or
the gas supplier.
This manual should be maintained in legible condition and kept adjacent to the heater or in another safe place for
future reference.
For 181/182, 260/261, 330/331 &
400/401 – Boilers & Water Heaters
D-2
Power
Vent
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 Rev. 7 reflects the following: Changes to: The text in paragraph one of the Venting section on page 8.
War nings 4 Pay Attention to These Terms 4 Receiving Equipment 5 General Specifications 5 Installation 5 Mounting the Assembly 5 Wiring a Power Vent Assembly toan Appliance with IID Ignition 8 Venting 8 Wiring Diagrams 10 182-260 H4/WH1 (Atmospheric) 10 181-261 H4/WH1 (Low NOx) 11 Sequence of Operat...
Receiving Equipment On receipt of your equipment it is suggested that youvisually check for external damage to the carton. If thecarton is damaged, it is suggested that a note be madeon the Bill of Lading when signing for equipment.Remove the complete assembly from the carton if it isdamaged report ...
