Raypak 241275 - Manual
Raypak 241275 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 3 – GENERAL SAFETY; Feel water before bathing or showering.
- Page 4 – Check the Power Source
- Page 5 – OPERATION
- Page 7 – Elodrive actuator is Nema 4 rated.; TROUBLESHOOTING; Check wiring using wiring diagram.
- Page 8 – Cold Water Star t Troubleshooting Guide
- Page 9 – Wiring Diagram
- Page 10 – COLD WATER RUN; Purpose; Low temperature radiant panel.; INSTALLATION; Installation Codes; The heater should not be located in an area
- Page 11 – Injection & Heater Pump Comparison — Hi Delta
- Page 12 – Before Star ting; ) Turn off power to the unit at the circuit breaker.; Remove the pump body then rotate it so that the
- Page 13 – You will now be able to install the pump cover. See
- Page 15 – Sequence of Operation
- Page 17 – Cold Water Run Troubleshooting Guide
- Page 18 – ILLUSTRATED PARTS LISTS; Cold Water Star t
- Page 19 – Sizing is specific to this application.
- Page 20 – Cold Water Run
This manual should be maintained in legible condition and kept adjacent to the heater or in another safe place
for future reference.
Catalog No: 1000.57A
Effective: 02-28-07
Replaces: 02-24-06
P/N 241275 Rev. 2
INSTALLATION AND OPERATING
INSTRUCTIONS
COLD WATER START & COLD WATER RUN
For Hi Delta & MVB
Heaters & Boilers
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
GENERAL SAFETY To meet commercial hot water use needs, the highlimit safety control on this water heater is adjustable upto 210°F. However, water temperatures over 125°Fcan cause instant severe burns or death from scalds.When supplying general purpose hot water, the rec-ommended initial setting for ...
4 COLD WATER START Before arriving at the job site to begin the installation,it's important to first inspect the system and determinewhat materials you will need. Some parts are includ-ed with the controller while others you will need toprovide. 1 Control Box 1 Temperature Sensor 1 Valve assembly wi...
5 Connecting Power to theController Supply power from the 120 VAC power input from theheater to the controller power inputs Terminal Block(TB1). This is accomplished by connecting wiring fromthe control box to the heater TB1 board 120 VACpower input connections. Refer to wiring diagrams. Fig. 3: Com...
