Page 2 - Contents; Before You Start
Contents 1. Before You Start 1 2. Overview and Operation 2 3. Looking after your Dishwasher 11 4. Troubleshooting 13 5. Installation 15 6. General Information 19 7. Circuit Diagram 20 8. Technical Data 21
Page 3 - Disposing of your packaging
1 1. Before You Start At Time of Delivery Check packaging and dishwasher immediately for signs of transport damage. If the appliance is damaged DO NOT USE. Contact your supplier or customer services. Please dispose of packaging materials properly. During Installation • Site the dishwasher and connec...
Page 4 - Getting to Know Your Dishwasher; Dishwasher Interior; Overview and Operation
2 Getting to Know Your Dishwasher Dishwasher Interior (Fig.2-1) Control Panel (Fig.2-2) � � � � � � � � � � � � � A Upper rack B Upper spray arm C Cutlery basket D Lower rack E Control panel F Top sprayer G Lower spray arm H Salt container cap I Washing filter J Detergent and rinse aid dispenser K Wa...
Page 5 - Salt; Loading the salt into the container; To prevent the formation of rust, load the salt; Adjusting salt consumption
3 Salt The hardness of water varies from place to place. If hard water is used in the dishwasher, deposits will form on the dishes and utensils. The appliance is equipped with a special softener that uses a salt specifically designed to eliminate lime and minerals from the water. Loading the salt int...
Page 6 - Rinse Aid; Loading the rinse aid; Proper dosage of rinse aid improves drying.; Detergent; oading the detergent
4 Rinse Aid T his product makes dishes sparkle and helps them to dry without spotting. The dispenser is located on the inside panel of the door. W hen the low rinse aid indicator (Fig.2-5) lights you must add rinse aid. Loading the rinse aid To load the rinse aid: 1. To open the dispenser, turn the ...
Page 7 - Detergent tablets explained; What you should not put into the; Dishes or cutlery that have been soiled by; Damage to glassware and other dishes; Possible causes; Suggested remedy
5 Detergent tablets explained Classic Tabs The tab contains Stain Soakers, which dissolve instantly to soften really dried on food residues such as baked on egg and cheese sauces. The blue layer then works to break down and lift off food remains while the white layer cleans all traces of dirt away fo...
Page 8 - Dishwasher; Using the lower rack
6 Arranging Crockery, Glasses, etc. in the Dishwasher Before placing the dishes in the dishwasher, remove larger food particles to prevent the filter from becoming clogged, resulting in reduced performance. If the pots and pans have baked-on food that is extremely hard to remove, we recommend that th...
Page 10 - Washing Dishes
8 Washing Dishes Programme selection The most appropriate programme can be identified by comparing the type of crockery, cutlery, etc., as well as the amount and condition of food remains, with the details contained in Table 2-2 , the wash cycle table. The corresponding programme sequence, duration a...
Page 11 - Interrupting the programme; Delayed start programming
9 Interrupting the programme Note: Interrupt or cancel a programme in progress ONLY when absolutely necessary. Interrupting a programme in progress Caution! There is a risk of water coming out from inside the appliance. DO NOT open the door fully until the spray arm has stopped rotating. Open the ...
Page 12 - ⁄2 Load Button; Memory Function Module
10 ½ Load Button This function allows the dishwasher to wash dishes using only the upper rack if there are not enough dishes for a full load. This will allow you to save on water and energy consumption. To select ½ load: 1. Select the programme and then press the ½ load button (Fig.2-19) – the ½ loa...
Page 13 - Looking after your Dishwasher; Care; Overall condition of appliance; Dishwasher salt
11 3. Looking after your Dishwasher Care After Every Wash After every wash, set the ON-OFF button to OFF and leave the door slightly ajar so that moisture and odours are not trapped inside. Before cleaning or performing maintenance isolate from mains. Overall condition of appliance Check that no g...
Page 14 - pray arms; Solvents or Abrasive Cleaning Products
12 S pray arms Limescale and remnants of food in the washing water can block the nozzles in the spray arms and the arm mountings. Inspect the nozzles in the spray arms for blocked holes due to remnants of food. If necessary, pull the lower arm (Fig.3-5) upwards and lift it off. Unscrew the upper spra...
Page 15 - Appliance does not start up; Problems with the appliance; Error display on the time-remaining indicator
13 4. Troubleshooting R esolving minor problems yourself E xperience has shown that you can resolve most problems that occur during normal daily usage yourself, without having to call out a service engineer. Not only does this save costs but it also means that the appliance is available to use. The ...
Page 16 - Problems
14 L ower spray arm rotates with difficulty • The s pray arm is blocked by small items or food remains. L id in detergent compartment cannot be closed • D etergent compartment has been overfilled. • Mechanism is clogged with remnants of detergent. I ndicator lamps do not extinguish after washing has fin...
Page 17 - Positioning the Dishwasher; Cold Water Connection; If the water pipes are new or have not been; Drain Hose Connection
15 5. Installation Positioning the Dishwasher The dishwasher should be aligned to the front of the adjacent cabinets, with allowance made for the door thickness. The dishwasher has water supply and drain hoses that can be positioned on either to the left or the right. Before installing the dishwashe...
Page 18 - Electrical Connection; WARNING: THIS APPLIANCE MUST BE EARTHED; The wires in the mains lead are coloured in; Care for the external cable; Damaged electrical cable; Levelling the Dishwasher
16 Electrical Connection The dishwasher must be installed by a qualified electrician, in accordance with all relevant British Standards/Codes of Practice (in particular BS 7671), or with the relevant national and local regulations. WARNING: THIS APPLIANCE MUST BE EARTHED All external wiring must co...
Page 19 - Fitting the Decor Door; Fixing the door panel fittings
17 ArtNo.800-0106 - Fitting the door � � The adjustable feet allow the dishwasher to be raised up to 870 mm. If the space between the floor and the underside of the work surface is more than 870 mm, the unit should be positioned on suitable wooded spacers that should be fixed to the floor (Fig.5-5) . A...
Page 20 - Fitting the Plinth
18 Securing the Dishwasher Using the two screws supplied, secure the dishwasher to the underside of the worktop (Fig.5-12) . For non-wooden worktops (e.g. marble) two brackets are provided to allow the appliance to be secured to the sides of the adjacent cabinets. Secure the appliance using the two ...
Page 21 - General Information; Information on comparability tests
19 6. General Information Measures must be taken to ensure that the units that are subsequently re-sited as freestanding appliances cannot topple over. This can be achieved by bolting the dishwasher to the wall or fitting it under a continuous work surface, that is screwed to the adjacent cupboards. ...
Page 23 - Dimensions
21 8. Technical Data INSTALLER: Please leave these instructions with the user. DATA BADGE LOCATION: Inside face on the side of the door. COUNTRY OF DESTINATION: GB/IE Dimensions ArtNo.800-0127 - 60 dishwasher dimensions ��� ��� ��� ��� ��������� ������� ��� �������������������� Connections Electric ...
