RadioShack ET-926 - Manual - manualsarea.com

Page 2 - FEATURES; Its features include:; Spread Spectrum Technology —; spreads signals out over several fre-

2 FEATURES © 1997 Tandy Corporation. All Rights Reserved. RadioShack is a registered trademark used by Tandy Corporation. Your RadioShack ET-926 900-MHzDigital Spread Spectrum CordlessPhone uses the most advanced cord-less telephone technology to give yousuperior audio quality and extendedrange. Its...

Page 3 - ringer equivalence; FCC STATEMENT; FCC Rules; • coin-operated systems

3 Important Note: Cordless phonessuch as this one require AC power tooperate. When the AC power is off,you cannot dial out or receive incomingcalls using your ET-926. To be safe,you should also have a phone thatdoes not need AC power to operate(not a cordless phone) so you can stillmake and receive ...

Page 4 - CONTENTS

4 CONTENTS Installation ............................................................................................................ 5 Selecting a Location ........................................................................................ 5 Placing the Base on a Desk Top .........................

Page 5 - INSTALLATION

5 INSTALLATION SELECTING A LOCATION You can place the ET-926’s base on adesk top or table, or mount it on a wall.Select a location that is: • near an AC outlet • near a telephone line jack • out of the way of normal activities • away from electrical machinery, electrical appliances, metal wallsor fi...

Page 12 - — while the phone is not in use.; press Volume s or t.; USING THE BELT CLIP

12 SETTING THE RINGER TONE/VOLUME You can select one of eight differentringer tone/volume settings — fourtones, with high/low volume for each — while the phone is not in use. To hear and change the ringer volumesetting, press Volume s or t. To change the tone, press Flash then enter the ringer tone ...

Page 13 - OPERATION; USING REDIAL; • The redial memory holds up to 32

13 OPERATION MAKING AND RECEIVING CALLS To make a call, lift the handset andpress Talk. To answer a call, simply liftthe handset from the base (or, if thehandset is away from the base, pressany key.) The Talk/Batt Low indicatoron the handset and the In Use/Chargeindicator on the base light. The ET-9...

Page 14 - USING FLASH; is set to; . Any additional numbers; PAGING

14 USING FLASH Flash performs the electronic equiva-lent of a switchhook operation for spe-cial services, such as Call Waiting. For example, if you have Call Waiting,press Flash to answer an incomingcall without disconnecting the currentcall. Press Flash again to return to thefirst call. Note: If yo...

Page 15 - MEMORY DIALING; Storing a Number in Memory

15 Notes: • Make sure you press Talk twice to stop the handset from beeping. Ifyou press Talk only once, you geta dial tone. • If you receive a call while the page is sounding, the handset stopsbeeping and starts ringing. MEMORY DIALING You can store up to 20 numbers inmemory, then dial a stored num...

Page 18 - TROUBLESHOOTING; Low volume or unusual sounds.

18 TROUBLESHOOTING We do not expect you to have any problems with your phone, but if you do, the fol-lowing suggestions might help. Problem Suggestion Low volume or unusual sounds. Someone has picked up another phone on the same line. Hang up the other phone. Severe noise interference. Keep the hand...

Page 20 - CARE AND MAINTENANCE

20 CARE AND MAINTENANCE Your ET-926 900-MHz Digital Spread Spectrum Cordless Phone is an example ofsuperior design and craftsmanship. The following suggestions will help you care foryour cordless telephone so you can enjoy it for years. Keep the ET-926 dry. If it gets wet, wipe it dry immediately. L...

Page 22 - LIGHTNING

22 THE FCC WANTS YOU TO KNOW In the unlikely event that your phonecauses problems on the phone line,the phone company can temporarilydiscontinue your service. If this hap-pens, the phone company attempts tonotify you in advance. If advance no-tice is not practical, the phone compa-ny notifies you as...

Page 23 - NOTES

23 NOTES 43-1096.fm Page 23 Tuesday, August 17, 1999 3:47 PM