RadioShack 15-124 - Manual

Your receiver works with the transmitter of your

2.4 GHz USB Connection Digital Audio Link.

Refer to the user’s guide of your 2.4 GHz USB

Connection Digital Audio Link before using your

receiver.

• To avoid injury, do not connect the provided

power adapter to a ceiling outlet.

• Use only an adapter that supplies 9V DC and

delivers at least 200mA. Its center tip must be

set to positive.

• Unplug the AC adapter from the AC outlet

before unplugging from the receiver.

• For better performance and greater reception

range, keep the receiver and transmitter away

from wireless LAN access points, microwave

ovens, and wireless networks or phones that

run on 2.4 GHz frequency.

15-124

2.4 GHz Digital Audio Receiver

Thank you for purchasing your 2.4 GHz Digital

Audio Receiver from

RadioShack

. This add-on

receiver is designed for use with your 2.4 GHz USB

Connection Digital Audio Link.

Power indicator

Lights when your

transmitter (not supplied)

and receiver link.

Receiver

AC Adapter

3.5mm Stereo Y-Type Patch Cable

3.5mm Stereo Audio Cable

User ’s Guide

Frequency Range ................................................... 2.4 ~ 2.4835 GHz

Channel Frequency ..................................... 2410, 2419 ~ 2473 MHz

Channel Spacing ...................................................................... 9 MHz

Frequency Stability ............................................................... ±1 MHz

Transmission Range ........................45 ft (15 m, in the home) (Max.)

.................................................... 100 ft (30.5 m, line of sight) (Max.)

Operating Temperature ........................... 32°F to 104°F (0°C to 40°C)

Power Supply ...................................... 120VAC/60Hz, 9V DC/200mA

Response ................................................................ 20 ~ 20kHz±3dB

S/N Ratio ...........................................................................40dB (Min.)

Sensitivity ................................................................. −85 dBm (Min.)

Output Impedance ........................................... >10K Ohm (3.5 mm)

Output Level ...................................................................2 Vms±10%

Dimensions (H x W x D) .......................................3.4 x 3.4 x 1.3 Inch

............................................................................... (86 x 86 x 32 mm)

Weight ............................................................................2.29 oz (65 g)

Specifications are subject to change and improvement without

notice. Actual product may vary from the images found in this

document.

Notes

This equipment has been tested and found to comply with

the limits for a Class B digital device, pursuant to part 15

of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a

residential installation. This equipment generates, uses and

can radiate radio frequency energy and, if not installed and

used in accordance with the instructions, may cause harmful

interference to radio communications.
However, there is no guarantee that interference will not

occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which

can be determined by turning the equipment off and on, the

user is encouraged to try to correct the interference by one or

more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and

receiver.

• Connect the equipment into an outlet on a circuit different

from that to which the receiver is connected.

Consult your local

RadioShack

store or an experienced

radio/TV technician for help. If you cannot eliminate the

interference, the FCC requires that you stop using your

receiver. Changes or modifications not expressly approved

by

RadioShack

may cause interference and void the user’s

authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation

is subject to the following two conditions: (1) this device

may not cause harmful interference, and (2) this device must

accept any interference received, including interference that

may cause undesired operation.

Product

2.4 GHz

Digital Audio Receiver

Model

15-124

Responsible

Party

RadioShack

300 RadioShack Circle

Fort Worth,TX 76102

Phone

817-415-3200

This product is warranted by

RadioShack

against manufacturing defects

in material and workmanship under normal use for ninety (90) days from the

date of purchase from

RadioShack

company-owned stores and authorized

RadioShack

franchisees and dealers. For complete warranty details and

exclusions, check with your local

RadioShack

store.

RadioShack

Customer Relations

300 RadioShack Circle, Fort Worth, TX 76102

04/04

Please read this user’s guide before

installing, setting up, and using your new receiver.

www.radioshack.com

©2007.

RadioShack

Corporation.

All rights reserved.

RadioShack

and

RadioShack.com are trademarks

used by

RadioShack

Corporation.

15-124

02A07

Printed in China

what’s included

specifications

rf emissions information

limited 90-day warranty

using your receiver

Connect the 3.5mm stereo

Y-type cable or 3.5mm stereo

audio cable, then connect the

other end to your stereo’s

audio input jacks.

Connect the 9V AC

adapter, then plug

the other end into a

standard AC outlet.